CONCRETE CHEMICALS, 3 RONELL CRESCENT, DATE : November 28, 2008 PAGE 1 OF 4
UNIT #1, COLLINGWOOD, ONTARIO, L9Y 4J6 PHONE (705)446-0110 EMERGENCY (613)996-6666
------------------------------------------------------------------------------------------
SECTION 1 IDENTIFICATION OF PRODUCT
------------------------------------------------------------------------------------------
TRADE NAME : CHEMROC 800 "B" MANUFACTURER'S CODE
4044-4071
PRODUCT CLASS INTENDED END USE
PEROXIDE GROUT/MORTAR
------------------------------------------------------------------------------------------
SECTION 2 HAZARDOUS INGREDIENTS
------------------------------------------------------------------------------------------
TLV TLV LD 50 LC50
NAME WT RANGE % CAS # PIN # TWA CLNG SOURCE MG/KG ANIMAL ROUTE PPM ANIMAL HOURS
NEPHELINE SYENITE 30 to 60 68187-64-4 N/A 5 10 ACGIH N/A N/A N/A N/A N/A N/A
DIBUTYL PHTHALATE 30 to 60 84-74-2 N/A 5 N/A ACGIH N/A N/A N/A N/A N/A N/A
BENZOYL PEROXIDE 10 to 30 94-36-0 U.N. 3106 5 N/A ACGIH 950 RAT ORAL N/A N/A N/A
NON HAZARDOUS COMPONENTS 10 to 30 N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A N/A
ORGANOPHILIC CLAY 3 to 7 68953-58-2 N/A 10 N/A ACGIH N/A N/A N/A N/A N/A N/A
PROPYLENE CARBONATE 0.5 to 1.5 108-32-7 N/A N/A N/A N/A 29000 RAT ORAL N/A N/A N/A
FERRIC OXIDE 0.5 to 1.5 1317-61-9 N/A 10 N/A ACGIH N/A N/A N/A N/A N/A N/A
UREA URETHANE 0.1 to 1.0 N/A UN 1993 N/A N/A ACGIH N/A N/A N/A N/A N/A N/A
N - METHYL PYRROLIDONE 0.1 to 1.0 872-50-4 N/A N/A N/A N/A 7000 RAT ORAL N/A N/A
N/A = NOT AVAILABLE
------------------------------------------------------------------------------------------
CONTINUED ON PAGE 2
PRODUCT CODE : 4044-4071 DATE : November 28, 2008 PAGE 2 OF 4
------------------------------------------------------------------------------------------
SECTION 3 PHYSICAL DATA
------------------------------------------------------------------------------------------
PHYSICAL STATE : LIQUID SPECIFIC GRAVITY : 0.15
APPEARANCE : BLACK % VOLATILES BY VOLUME : 0.32
ODOUR : MILD P.H. : N/A
ODOUR THRESHOLD : NOT AVAILABLE VAPOUR DENSITY : N/A
EVAPORATION RATE : N/A FREEZING POINT : N/A
(SECONDS TO 90% EVAPORATION)
VAPOUR PRESSURE : N/A COEFFICIENT/WATER/ : N/A
OIL DISTRIBUTION
BOILING POINT C : N/A SOLUBILITY/WATER : SLIGHT
------------------------------------------------------------------------------------------
SECTION 4 FIRE AND EXPLOSION HAZARD DATA
------------------------------------------------------------------------------------------
FLAMMABILITY : NO FLASH POINT : N/A
(SETAFLASH CLOSED CUP)
EXTINGUISHING MEDIA : WATERFOG, CO2, FOAM, FOAM
EFFECTS OF ACUTE EXPOSURE TO
EYES : WILL RESULT IN EYE IRRITATION
SKIN : WILL RESULT IN SKIN IRRITATION
INGESTION : MAY CAUSE ABDOMNIAL PAIN, VOMITTING, AND DIARRHEA
INHALATION : WILL RESULT IN RESPIRATORY TRACT IRRITATION
LC50 OF PRODUCT PPM : N/A ANIMAL : N/A TIME HRS : N/A
SENSITIZATION : YES SKIN AND RESPIRATORY CARCINOGENICITY : NO
REPRODUCTIVE TOXICITY : NOT APPLICABLE TERATOGENICITY : NOT APPLICABLE
MUTAGENICITY : NOT APPLICABLE SYNERGISTIC PRODUCTS : NONE KNOWN
------------------------------------------------------------------------------------------
CONTINUED ON PAGE 3
PRODUCT CODE : 4044-4071 DATE : November 28, 2008 PAGE 3 OF 4
------------------------------------------------------------------------------------------
SECTION 6 REACTIVITY DATA FOR PRODUCT
------------------------------------------------------------------------------------------
PERSONAL PROTECTIVE EQUIPMENT :
WEAR CLEAN LONG SLEEVED, BODY COVERING CLOTHING, USE IMPERVIOUS GLOVES AND PROTECTIVE
CLOTHING. USE CHEMICAL GOGGLES AND FULL FACE SHIELD. WHEN RESPIRATORY PROTECTION
IS REQUIRED, USE AN APPROVED AIR PURIFYING RESPIRATOR.
HANDLING PROCEDURE :
AVOID INHALATION, SKIN AND EYE CONTACT. PRACTICE GOOD PERSONAL HYGIENE. WASH REPEATEDLY
WITH SOAP AND WATER DURING THE WORK DAY.
STORAGE REQUIREMENTS :
KEEP CONTAINERS CLOSED AND IN A COOL DRY PLACE.
ENGINEERING CONTROLS :
PROVIDE GENERAL DILUTION OR LOCAL EXHAUST IN VOLUME AND PATTERN TO KEEP TLV OF HAZARDOUS
INGREDIENTS IN SECTION 2 BELOW ACCEPTABLE LIMITS.
------------------------------------------------------------------------------------------
SECTION 8 SPILL OR LEAK PROCEDURE
------------------------------------------------------------------------------------------
STEPS TO BE TAKEN UPON RELEASE OR SPILLAGE :
REMOVE ALL SOURCES OF IGNITION (FLAMES, SPARKS ECT.) PROVIDE ADEQUATE VENTILATION.
AVOID PROLONGED BREATHING OF VAPOURS. REMOVE TO A CONTAINER OR ABSORB WITH CLAY,
DIATOMACIOUS EARTH OR OTHER SUITABLE INERT ABSORBANT.
WASTE DISPOSAL METHOD :
DISPOSE OF BY CONTROLLED BURNING OR LANDFILL THE ABSORPTION MATERIAL IN AN APPROVED
SITE IN ACCORDANCE WITH LOCAL, PROVINCIAL, AND FEDERAL REGULATIONS.
**** DO NOT INCINERATE CLOSED CONTAINERS ****
------------------------------------------------------------------------------------------
CONTINUED ON PAGE 4
PRODUCT CODE : 4044-4071 DATE : November 28, 2008 PAGE 4 OF 4
------------------------------------------------------------------------------------------
SECTION 9 FIRST AID MEASURES
------------------------------------------------------------------------------------------
EYES :
FLUSH THOROUGHLY WITH WATER FOR AT LEAST 15 MINUTES AND GET IMMEDIATE MEDICAL ATTENTION.
SKIN :
WASH THE EXPOSED AREAS WITH SOAP AND WATER IMMEDIATELY. CALL A PHYSICIAN IF IRRITATION
PERSISTS.
INHALATION :
REMOVE TO FRESH AIR. IF BREATHING IS DIFFICULT ADMINISTER OXYGEN.
INGESTION :
DO NOT INDUCE VOMITTING ADMINISTER LARGE AMOUNTS OF MILK OR WATER IF AVAILABLE.
TRANSPORT TO A MEDICAL FACILITY
------------------------------------------------------------------------------------------
DISCLAIMER AND LIMITATION OF LIABILITY
------------------------------------------------------------------------------------------
WHILE THE COMPANY BELIEVES THAT THE DATA CONTAINED HEREIN ARE FACTUAL
AND THE OPINIONS EXPRESSED ARE THOSE OF QUALIFIED EXPERTS REGARDING THE RESULTS OF THE
TEST CONDUCTED. THE DATA ARE NOT TO BE TAKEN AS WARRANTY OR REPRESENTATION FOR WHICH
THE COMPANY ASSUMES LEGAL RESPONSIBILITY. THEY ARE OFFERED SOLELY FOR
YOUR CONSIDERATION, INVESTIGATION, AND VERIFICATION. FINAL DETERMINATION OF THE
SUITABILITY OF THE MATERIAL FOR THE USE CONTEMPLATED, THE MANNER OF USE, AND WHETHER THE
SUGGESTED USE INFRINGES ANY PATENT IS THE SOLE RESPONSIBILITY OF THE BUYER.
IT IS AGREED AND UNDERSTOOD THAT THE INFORMATION SUPPLIED HEREIN IS THE PROPERTY OF
THE COMPANY AND IS NOT TO BE DIVULGED IN ANY MANNER WHATSOEVER BY THE
CUSTOMER NOR BY ANYONE ACTING ON BEHALF OF THE CUSTOMER TO ANYONE AND THE CUSTOMER SHALL
BE RESPONSIBLE FOR ANY LOSS SUFFERED BY THE COMPANY IF THE INFORMATION IS DIVULGED
TO ANYONE.
------------------------------------------------------------------------------------------
SECTION 10 PREPARATION OF MSDS
------------------------------------------------------------------------------------------