Pg 1 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
1. PRODUCT AND COMPANY INDENTIFICATION
Company 24 Hour Emergency Response Information
The Greenstreak Group CHEM - TEL: 1- 800-255-3924
3400 Treecourt Industrial
St. Louis, MO 63122
Product Name: LockStop Primer ?Black
Identification Number: 911
Product use/class: Primer Adhesive
2. COMPOSITION/ INFORMATION ON INGREDIENTS
Item CAS Number Content(WT/WT%) Chemical Name
01 8052-42-4 <45.0 ASPHALT
02 8052-41-3 <45.0 MINERAL SPIRITS
03 1330-20-7 <10.0 XYLENES
04 8052-42-4 <10.0 ASPHALT
05 100-41-4 < 5.0 ETHYL BENZENE
EXPOSURE LIMITS
ACGIH OSHA COMPANY
Item TLV-TWA TLV-STEL PEL-TWA PEL-CEILING TLV-TWA SKIN
01 5mg/m3 N.E. 5mg/m3 N.E. N.E. NO
02 100ppm N.E. 500ppm N.E N.E. NO
03 100ppm 150ppm 100ppm N.E N.E. NO
04 5mg/m3 5mg/m3* N.E. N.E N.E NO
05 100ppm 125ppm 100ppm N.E N.E. NO
(See Section 16 for abbreviation legend), * - Ceiling Value
3. HAZARDS IDENTIFICATION
Emergency Overview
No Information
Potential Health Effects
Effects of Overexposure:
Eye Contact: Liquid, aerosols and vapors of this product are irritating and can cause pain, tearing,
reddening and swelling accompanied by a stinging sensation and/or a feeling like that of
fine dust in the eyes.
Pg 2 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
Skin Contact: Prolonged or repeated contact can result in defatting and drying of the skin which may
result in skin irritation and dermatitis (rash).
Inhalation: Prolonged inhalation may be harmful.
Ingestion: Irritating to mouth, throat and stomach.
Chronic Hazards: Overexposure may cause lung damage.
Primary Route(s) of entry:
Skin Contact, Skin Absorption, Inhalation, Ingestion, eye contact
4. FIRST AID MEASURES
General Advice:
No Information
If inhaled:
Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Get immediate medical attention.
If on skin:
Wash with soap and water. Get medical attention if irritation develops or persists.
If in eyes:
Immediately flush eyes with plenty of water. Get medical attention, if irritation persist.
If swallowed:
If swallowed, induce vomiting immediately as directed by medical personnel. Never give anything by
mouth to an unconscious person. Get medical attention immediately.
5. FIRE FIGHTING MEASURES
Flash Point: 83 F LOWER EXPLOSIVE LIMIT: 0.7%
UPPER EXPLOSIVE LIMIT: 7.0%
(SETAFLAS CLOSED CUP)
Autoignition Temperature: No information
Suitable extinguishable media:
Alcohol Foam, CO2, Dry Chemical, Foam, Water Fog
Unusual Fire and Explosion Hazards:
Vapors may form explosive mixture with air. Vapors can travel to a source of ignition and flash back.
Flammable Liquid. Can release vapors that form explosive mixtures at temperatures at or above the
flashpoint. "Empty" containers retain product residue (liquid and/or vapor) and can be dangerous. DO
NOT PRESSURIZE, CUT, WELD, BRAZE, SOLDER, DRILL, GRIND, OR EXPOSE SUCH
CONTAINERS TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES
OF IGNITION; THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. Empty drums should
be completely drained, properly bunged and promptly returned to a drum reconditioner, or properly
disposed of.
Special Firefighting Procedures:
Pg 3 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
Containers can build up pressure if exposed to heat (fire). As in any fire, wear self-contained breathing
apparatus pressure- demand (MSHA/NIOSH approved or equivalent) and full protective gear. Water
runoff can cause environmental damage. Dike and collect water used to fight fire.
6. ACCIDENTAL RELEASE MEASURES
Cleanup:
Absorb spill with inert material (e.g. dry sand or earth), then place in a chemical waste container.
Avoid runoff into storm sewers and ditches which lead to waterways.
7. HANDLING AND STORAGE
Handling
Wash thoroughly after handling.
Storage
General Advice:
Keep away from heat, sparks and flame. Keep container closed when not in use.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Advice on system design
Good general ventilation should be sufficient to control airborne levels. Local exhaust ventilation may
be necessary to control any air contaminants to within their TLVs during the use of this product. Use
explosion- proof ventilation equipment. Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower.
Personal Protective Equipment
Respiratory protection:
A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use.
Skin protection:
Use a chemical splash goggles and face shield (ANSI Z87.1 or approved equivalent).
Eye protection:
Wear safety glasses with side shields (or goggles) and a face shield.
Other protective equipment:
Where splashing is possible, full chemically resistant protective clothing (e.g. acid suit) and boots are
required.
General safety and hygiene measures:
Wash hands before eating. Use only in a well ventilated area. Follow all MSDS/label precautions even
after container is emptied because they may retain product residues. Ground and bond containers when
Pg 4 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
transferring material. Avoid prolonged or repeated contact with skin. Avoid breathing vapors from
heated material. Avoid contact with eyes, skin, and clothing.
9. PHYSICAL AND CHEMICAL PROPERTIES
Form: Liquid Vapor Density: Is heavier than air
Odor: Solvent Odor Threshold:
Color: Black, liquid Evaporation Rate: Is slower than Ether
Boiling Range: 276-383 F Specific Gravity: 0.8825
Solubility in H2O: None pH @ 0.0 %:
Freeze Point: Viscosity:
Vapor Pressure: N.E.
Physical State: Liquid
Coefficient of water/oil distribution: N.A.
(See Section 16 for abbreviation legend)
10. STABILITY AND REACTIVITY
Conditions to avoid:
High Temperatures
Incompatibility:
Oxygen supplying chemicals
Hazardous Decomposition Products:
CO, CO2, isobutene
Hazardous Polymerization:
Will not occur under normal conditions.
Stability:
This product is stable under normal storage conditions.
11. TOXICOLOGICAL INFORMATION
No product or component toxicological information is available.
12. ECOLOGICAL INFORMATION
No information.
13. DISPOSAL CONSIDERATIONS
Hazardous Waste - Flammability
14. TRANSPORT INFORMATION
Pg 5 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
DOT PROPER SHIPPING NAME: Adhesive
DOT TECHNICAL NAME: Adhesive
DOT HAZARD CLASS: 3 HAZARD SUBCLASS:
DOT UN/NA NUMBER: 1133 PACKING GROUP: III RESP. GUIDE PAGE:
15. REGULATORY INFORMATION
Federal Regulations
OSHA: Hazardous by definition of Hazard Communication Standard (29 CFR 1910.1200)
CERCLA- SARA HAZARD CATEGORY:
This product has been reviewed according to the EPA `Hazard Categories'
promulgated under Sections 311 and 312 of the Superfund Amendments and
Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable
definitions, to meet the following categories:
IMMEDIATE HEALTH HAZARD CHRONIC HEALTH HAZARD FIRE HAZARD
SARA SECTION 313:
This product contains the following substances subject to the reporting requirements
of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of
1986 and 40 CFR Part 372:
CHEMICAL NAME CAS NUMBER WT/WT %
XYLENES 1330-20-7 <10.0
ETHYL BENZENE 100-41-4 < 5.0
Toxic Substances Control Act:
This product contains the following chemical substances subject to the reporting requirements of
TSCA 12 (B) if exported from the United States:
CHEMICAL NAME CAS NUMBER
No Information is available.
U.S. State Regulations:
New Jersey Right-to-Know:
The following materials are non- hazardous, but are among the top five components in this
Product.
CHEMICAL NAME CAS NUMBER
No non ?hazardous materials are among the top five ingredients
Pg 6 of 6pPgPg
The Greenstreak Group, Inc.
MATERIAL SAFETY DATA SHEET
Lockstop Primer- Black
June 15, 2006
Pennsylvania Right-to-Know:
The following non- hazardous ingredients are present in the product at greater than 3%:
CHEMICAL NAME CAS NUMBER
No non-hazardous ingredients are present at greater than 3%.
CALIFORNIA PROPOSITION 65:
WARNING: The chemical(s) noted below and contained in this product, are known to the state of
California to cause cancer, birth defects or other reproductive harm:
CHEMICAL NAME CAS NUMBER
No Proposition 65 chemicals exist in this product.
INTERNATIONAL REGULATIONS:
CANADIAN WHMIS: This MSDS has been prepared in compliance with controlled
Product Regulations except for use of the 16 headings.
CANADIAN WHMIS CLASS: No information available.
16. OTHER INFORMATION
HMIS Ratings
Health: 1 Flammability: 3 Reactivity: 0
VOLATILE ORGANIC COMPOUNDS (VOCS): 3.19 lbs/gal, 383 grams/ltr
LEGEND: N.A.- Not Applicable, N.E.- Not Established,
N.D.- Not Determined
The information contained on this MSDS is been checked and should be accurate. However, it is the
responsibility of the user to comply with all Federal, State, and Local laws and regulations.
|