MSDS
Product: Dorf 9855
Rev # 0 Dated 4/6/2004
Page 1 of 4
MATERIAL SAFETY DATA SHEET
1. CHEMICAL PRODUCT AND COMPANY INFORMATION
Product Name: Dorf 9855
Chemical family: Antifoam
2. COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous ingredients - None
3. HAZARDS IDENTIFICATION
Inhalation : Not expected to present a hazard under normal conditions.
Eye Contact : Liquid may cause minor irritation.
Skin Contact : No irritation expected under normal conditions
Ingestion : May cause gastrointestinal upset and nausea
4. FIRST AID MEASURES
Skin: Wash skin with soap and water. Remove contaminated clothing and launder contaminated clothing before reuse. Get medical attention
if redness or irritation develops.
Eyes: Flush eyes immediately with large amounts of water for at least 15 minutes. Lift lower and upper lids occasionally. Get medical
attention.
Inhalation: Remove victim to fresh air. Give artificial respiration if not breathing. If breathing is difficult, administer oxygen. Keep person warm,
quiet and get medical attention.
Ingestion: Call a physician immediately. Give victim a glass of water. DO NOT induce vomiting unless instructed by a physician or poison
control center. Never give anything by mouth to an unconscious person.
This product contains methylpolysiloxanes which can generate formaldehyde at approximately 300 degree farenheit (150 deg C) and above, in
atmospheres which contain oxygen. Formaldehyde is a skin and respiratory sensitizer, eye and throat irritant, acute toxicant and potential
cancer hazard.
5. FIRE FIGHTING MEASURES
Extinguishing Media: This material is non-combustible. If this material is involved in a fire, use an extinguishing agent appropriate to
surrounding materials. Water spray may be used to cool containers of the material exposed to a fire. Fire extinguishing materials should be
collected for determination of proper disposal.
Special Fire Fighting Procedures: Fire fighters should wear self-contained breathing apparatus with full facepiece operated in the pressure-
demand or positive-pressure mode.
Unusual Fire and Explosion Hazards: None.
6. ACCIDENTAL RELEASE MEASURES
Steps to be taken if material is released or spilled : Wipe up with a cloth or paper (small quantity); or absorb unrecoverable product with inert
material such as clay, sand or vermiculite, and put into containers for disposal.
7. HANDLING AND STORAGE
Precautions to be taken in Handling and Storing : Avoid contact with eyes, skin or clothing. Avoid breathing vapors or mist.
Other Precautions : Containers of this material may be hazardous when emptied. Since emptied containers retain product residues (vapor,
liquid, and/or solid), all hazard precautions given in the data sheet must be observed. Do not transfer to improperly marked container. Keep
container closed. Use with adequate ventilation. Wash thoroughly after handling. Containers should not be washed out and used for other
purposes.
FOR INDUSTRIAL USE ONLY
MSDS
Product: Dorf 9855
Rev # 0 Dated 4/6/2004
Page 2 of 4
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Respiratory Protection : Use a dust/mist mask if spray or mist is present.
Ventilation : Good general mechanical ventilation recommended.
Protective Gloves : Neoprene, nitrile, polyvinyl alcohol (PVA), polyvinyl chloride (PVC)
Eye Protection : Chemical splash goggles or face shield in compliance with OSHA regulations is advised; however OSHA regulations also
permits safety glasses under certain conditions. The use of contact lenses is not recommended.
Other Protective Equipment : Eye wash and safety shower.
9. PHYSICAL AND CHEMICAL PROPERTIES
These data do not represent technical or sales specification
Form :Milky white to grey liquid
Sp. Gr. @ 33EC : 0.98 鈥? 1.08
Flash Point (PMCC) : Min 65EC
Kinematic Viscosity @ 40EC : Max 5000 cSt
Abbreviations: N.D. 鈥? Not Determined
N.A. - Not Applicable
10. STABILITY
Stability: Stable under normal conditions of storage and use.
Conditions to avoid - Not Known
Incompatibility: Avoid contact with alkalies and acids
Hazardous Decomposition Products: Thermal decomposition or combustion may produce carbon dioxide and/or carbon monoxide and
oxides of silicon.
Hazardous Pplymerization: will not occur
Conditions to avoid - None
11. TOXICOLOGICAL INFORMATION
Acute Toxicity: No toxicity studies have been conducted on this product.
LD50/oral/rat = ND LD50/dermal/rabbit = ND
LC50/inhalation/rat = ND
Chronic toxicity: EC Carcinogenic: Not listed EC Mutagenic: Not listed
EC Toxic for Reproduction: Not listed
Carcinogenicity (ACGIH): Not listed
IARC classification: Not listed Routes of exposure: NA
Irritation: Signs of nervous system effects were seen by the oral, dermal and inhalation routes of administration.
Skin(rabbit): Corrosive under DOT test method.
Eye (rabbit): severe Irritation
Additional product information: None
Additional component information: None
12. ECOLOGICAL INFORMATION
Mobility: ND Biodegradation: ND
Bioaccumulation: ND Aquatic toxicity: ND Further information: ND
13. DISPOSAL CONSIDERATIONS
Waste Disposal Method : Treatment, storage, transportation and disposal must be in accordance with EPA or state regulations
under authority of the Resource Conservation and Recovery Act (40 CFR 260 - 271)
MSDS
Product: Dorf 9855
Rev # 0 Dated 4/6/2004
Page 3 of 4
14. TRANSPORT INFORMATION
Proper shipping name: Not Regulated UN-No.: Not Regulated
U.S.DOT: Not Regulated IMO: Not Regulated
ICAO-IATA: Not Regulated Further Information: None
15. REGULATORY INFORMATION
Superfund Amendments and Reauthorization Act of 1986 (SARA) Title III
Section 302/304-Extremely Hazardous Substances (40 CFR 355)
SARA requires emergency planning based on Threshold Planning Quantities (TPQs) and release reporting based on Reportable Quantities
(RQs) in 40 CFR 355 (used for SARA 302, 304, 311 and 312). These values are subject to change and the regulations should be consulted to
verify current statutory requirements.
Components present in this product at a level which could require reporting under the statute are:
Component Name RQ TPQ % Range
**NONE**
Section 311/312 Chemical Inventory Reporting Requirements (40 CFR 370)
The Superfund Amendments and Reauthorization Act (SARA) may require submission of reports (Chemical list, MSDS, Tier I & Tier II) to the
state emergency response commission, Local Emergency Response Committee and the local fire department. The SARA physical and health
hazards related to this product are :
X Acute Health Hazard _ Sudden Release of Pressure _ Fire
_ Chronic Health Hazard _ Reactive
Section 313-List of Toxic Chemicals (40 CFR 372)
This product contains the following toxic chemicals subject to the reporting requirements of Section 313 of the emergency planning and
community right-to-know act of 1986 (40 CFR 372). This information should be included in all MSDSs that are copied and distributed for this
material.
Component Name CAS # % Range
**NONE**
CERCLA, 40 CFR 261 & 302
The comprehensive environmental response, compensation, and liability act of 1980 (CERCLA) requires notification of the National Response
Center of any release of a Hazardous Substances equal to or greater than the reportable quantities (RQs) listed in 40 CFR 302.4. Values are
given in pounds for the component and not the mixture, if applicable (These values are subject to change and the regulations should be
consulted to verify current statutory levels.)
Component Name CAS # CERCLA RQ
**NONE**
OSHA Exposure Limits
Component Name
**NONE**
Department of Transportation Shipping Information :
Proper Shipping Name: Nonregulated material.
Toxic Substances Control Act (TSCA), 40 CFR 261: This product, or components if product is a mixture, is/are listed on the Toxic
Substances Control Act (TSCA) inventory.
MSDS
Product: Dorf 9855
Rev # 0 Dated 4/6/2004
Page 4 of 4
16. OTHER INFORMATION
HEALTH: 1 FLAMMABILITY: 0 REACTIVITY: 0
For additional information concerning this product, contact the following:
PRODUCT EMERGENCIES
Dorf Ketal Chemicals (I) Pvt. Ltd. Dorf Ketal LLC
#1 DORF KETAL TOWERS. 3727 Greenbriar
D鈥橫onte Street, Marve Road. Suite 114,
Malad (W). Bombay 64. Stafford, TX 77477
Tel: +91-22-28813654 / +91-22-28828374. Tel : 281 491 3700
Fax: +91-22-28882366 Fax : 281 491 3700
The data and recommendations presented in this data sheet concerning the use of our product and the materials contain there in are believed
to be accurate and are based on information which is considered reliable as of the date hereof. However, the customer should determine the
suitability of such material for his purpose before adopting them on a commercial scale. Since the use our products by others is beyond our
control, no guarantee, express or implied, is made and no responsibility assumed for the use of this material or the results to be obtained there
from. Information on this form is furnished for the purpose of compliance with Government Health and Safety Regulations and shall not be
used for any other purposes. Moreover, the recommendations contained in this data sheet are not to be constructed as a license to operate
under, or a recommendation to infringe, any existing patents, nor should they be confused with state, municipal or insurance requirements, or
with national safety codes.
END OF MSDS
|