Distributed By: K-CHEM, INC.
3908 3rd Ave South
MATERIAL SAFETY DATA SHEET
Birmingham, AL 35222
MSDS L-227 REVISION 6
(205) 592-0844
------------------------------------------------------------------------------------------------------------------------------------------------------------
THE DIAL CORPORATION
CENTER FOR INNOVATION MEDICAL EMERGENCIES: 1-888-689-9082
15101 NORTH SCOTTSDALE ROAD CHEMTREC: 1-800-424-9300 (24 Hours Daily)
SCOTTSDALE, ARIZONA 85254 OTHER INFORMATION: 1-888-468-6673
SUBSTANCE IDENTIFICATION
SUBSTANCE: LIQUID HAND SOAP
TRADE NAMES/SYNONYMS: DIAL COMPLETE庐 ANTIBACTERIAL FOAMING HAND WASH
DIAL COMPLETE庐 ANTIBACTERIAL FOAMING LOTION HAND WASH 鈥? FRESH
PEAR
DIAL COMPLETE庐 ANTIBACTERIAL FOAMING LOTION HAND WASH 鈥? COOL
PLUM
DIAL COMPLETE庐 ANTIBACTERIAL FOAMING LOTION HAND WASH 鈥? KITCHEN
CHEMICAL FAMILY: Mixture
I.D. NUMBERS: 906497; 99101195, 99101825, 99101826, 99102437
NFPA RATINGS (Scale 0-4, where 4=high degree of hazard): HEALTH=1 FLAMMABILITY=0 REACTIVITY=0
HMIS RATINGS (Scale 0-4, where 4=severe hazard): HEALTH=1 FLAMMABILITY=0 REACTIVITY=0
This product is labeled in accordance with guidelines set forth in the Food, Drug, and Cosmetic Act. The use pattern and
exposure in the workplace are generally not consistent with those experienced by consumers. The requirements of the
Occupational Safety and Health Administration applicable to this Material Safety Data Sheet may differ from the
requirements of the FD & C Act and as a result, this MSDS may contain additional health hazard information not pertinent
to consumer use and not found on the product label.
HAZARDOUS INGREDIENTS INFORMATION
COMPONENT: AMMONIUM LAURYL SULFATE CAS #: 68081-96-9 or 2235-54-3
COMPONENT: DIPROPYLENE GLYCOL CAS #: 25265-71-8
COMPONENT: GLYCERIN CAS# 56-81-5
5 mg/m3 OSHA TWA (respirable fraction); 10 mg/m3 OSHA TWA (total mist)
10 mg/m3 ACGIH TWA (total mist)
COMPONENT: SODIUM XYLENESULFONATE CAS #: 1300-72-7
COMPONENT: TRICLOSAN CAS #: 3380-34-5
Carcinogen status of components: Not listed as carcinogenic by NTP, IARC, or OSHA.
PHYSICAL AND CHEMICAL
DESCRIPTION: Clear or colored liquid with a very slight chemical odor.
VISCOSITY: Water-thin. pH: 5.5 鈥? 6.5 @ 25掳C
Page 1 of 4
MSDS L-227 (Rev. 6)
SOLUBILITY IN WATER: Complete. SPECIFIC GRAVITY: 1.05 - 1.09 @ 25掳C
FIRE AND EXPLOSION
FIRE AND EXPLOSION HAZARD - Negligible fire hazard when exposed to heat or flame.
FIRE FIGHTING MEDIA - Dry chemical, carbon dioxide, water spray or regular foam.
FIRE FIGHTING - Move container from fire area if you can do it without risk. Apply cooling water to sides of containers
that are exposed to flames until well after fire is out. Extinguish only if flow can be stopped; use flooding amounts of
water as a fog, solid streams may be ineffective. Avoid breathing vapors, keep upwind.
HEALTH HAZARD DATA
NOTE: The acute health effects described below are those which could potentially occur for the finished product. They
are based on the toxicology information available for the finished product and/or each hazardous ingredient, and are
consistent with the product type and the likelihood of a specific route of exposure. Known chronic health effects related to
exposure to a specific ingredient are indicated.
ACUTE HEALTH EFFECTS:
INHALATION: Unlikely to occur due to the physical properties of the product.
SKIN CONTACT: Repeated or prolonged excessive exposure may cause irritation or dermatitis.
EYE CONTACT: May cause mild transient irritation.
INGESTION: May cause gastrointestinal irritation with nausea, vomiting and diarrhea.
CHRONIC HEALTH EFFECTS: None known.
MEDICAL CONDITIONS GENERALLY RECOGNIZED AS BEING AGGRAVATED BY EXPOSURE: Pre-existing
skin conditions.
EMERGENCY AND FIRST AID PROCEDURES
INHALATION: Immediately remove from exposure area to fresh air . Keep affected person warm and at rest. Treat
symptomatically and supportively. Contact physician or local poison control center. If breathing has stopped, give
artificial respiration, and get medical attention immediately.
SKIN CONTACT: Rinse affected area with plenty of water until no evidence of product remains. Get medical attention if
irritation persists.
EYE CONTACT: Immediately rinse eyes with plenty of water, occasionally lifting upper and lower lids, until no
evidence of product remains. Get medical attention if pain or irritation persist.
INGESTION: Treat symptomatically and supportively. Maintain airway and respiration. If vomiting occurs, keep head
below hips to prevent aspiration. Dilution by rinsing the mouth and giving water or milk to drink is generally
recommended. If unconscious, the victim should not be given anything to drink. Contact physician or local poison
control center.
REACTIVITY
REACTIVITY - Stable under normal temperatures and pressures.
Page 2 of 4
MSDS L-227 (Rev. 6)
INCOMPATIBILITIES: Strong oxidizers, acids.
DECOMPOSITION - Thermal decomposition may release toxic and/or hazardous gases.
POLYMERIZATION - Hazardous polymerization has not been reported to occur under normal temperatures and
pressures.
STORAGE AND DISPOSAL
Store away from incompatible substances. Observe all federal, state and local regulations when storing or disposing of
this substance.
CONDITIONS TO AVOID
Avoid contact with excessive heat and incompatible substances.
SPILL AND LEAK PROCEDURES
OCCUPATIONAL SPILL - Stop leak if you can do it without risk. For small spills, take up with sand or other absorbent
material and place into containers for later disposal. For larger spills, dike far ahead of spill for later disposal. Keep
unnecessary people away; isolate hazard area and restrict entry.
OCCUPATIONAL PROTECTIVE EQUIPMENT
VENTILATION - Provide local exhaust or general dilution ventilation to keep exposure to airborne contaminants as low as
possible.
RESPIRATOR - If respiratory protection is required, it must be based on the contamination levels found in the workplace,
must not exceed the working limits of the respirator and be jointly approved by the National Institute for Occupational
Safety and Health and the Mine Safety and Health Administration (NIOSH-MSHA).
FOR FIRE FIGHTING AND OTHER IMMEDIATELY DANGEROUS TO LIFE OR HEALTH CONDITIONS -
Any self-contained breathing apparatus that has a full facepiece and is operated in a pressure-demand or other
positive-pressure mode. Any supplied-air respirator that has a full facepiece and is operated in a pressure-demand or
other positive-pressure mode in combination with an auxiliary self-contained breathing apparatus operated in pressure-
demand or other positive-pressure mode.
CLOTHING - Protective clothing is required where repeated or prolonged skin contact may occur.
GLOVES - Chemical-resistant gloves are required where repeated or prolonged skin contact may occur.
EYE PROTECTION - Safety glasses are required to prevent eye contact where splashing of product may occur.
REGULATORY INFORMATION
DOT FLAMMABILITY CLASSIFICATION: Not applicable.
EPA - SARA TITLE III SECTION 313: Not applicable 鈥? Consumer Product.
TSCA: All components of this product are listed or are
exempted or excluded from listing on the U.S. Toxic
Substances Control Act (TSCA) chemical substance
inventory.
Page 3 of 4
MSDS L-227 (Rev. 6)
----------------------------------------------------------------------------------------------------------------------------------------------------------------
The information contained herein is provided in good faith and is believed to be correct as of the date hereof. However,
The Dial Corporation makes no representation as to the comprehensiveness or accuracy of the information. It is
expected that individuals receiving the information will exercise their independent judgment in determining its
appropriateness for a particular purpose. Accordingly, The Dial Corporation will not be responsible for damages of any
kind resulting from the use of or reliance upon such information. No representations, or warranties, either expressed or
implied of merchantability, fitness for a particular purpose or of any other nature are made hereunder with respect to the
information set forth herein or to the product to which the information refers.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
MSDS CREATION DATE: 12/12/00
SUPERSEDES: 02/08/06 Rev 5
REVISION DATE: 05/11/06
REVISION: Added Trade Name and I.D. number.
Page 4 of 4
|