MATERIAL SAFETY DATA SHEET FreshSeat Toilet Seat Cleaner
F-MATIC of America
P.O. Box 157
Lehi, UT 84043
Emergency #: Chem-Tel (800) 255-3924 Information #: (801) 768-2000
F-MATIC FRESH SEAT CLEANER
Section I - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
MSDS FIRST PREPARATION DATE: October 6, 2005
REVISION DATE: Jan. 2, 2007
FORMULA: TFMO201 (L35214)
PREPARED AND REVISED BY: Becky Krueger
GENERIC/CHEMICAL NAME: Other
PRODUCT TYPE/CHEMICAL FAMILY: NA
PRODUCTCODE: SUP1ND1
SYNONYMS: None
CONTACT ADDRESS: F-MATIC of America, 299 S. Millpond Drive, Lehi, UT 84043
EMERGENCY PHONE NUMBERS:
F-Matic of America: (801) 768 2000 Monday - Friday, 8:00 am - 5:00 pm MST Chem-tel: (800) 255-6200 - 24-Hours
Section II -COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient CAS No Hazardous
Dimethyl Ether, DME 115-10-6 Yes
Ethanol 64-17-5 Yes
Section III - HAZARDS INDENTIFICATION
POTENTIAL HEALTH EFFECTS
EYE CONTACT: Direct contact of product with eyes may cause irritation, and may result in irreversible damage.
SKIN CONTACT: None Known
INHALATION: None Known
INGESTION: If ingested, may cause nausea and vomiting. If in aerosol form, ingestion is not likely.
Section IV - FIRST AID
EYE CONTACT: If irritation or redness due to vapors develops, move victim away from exposure and into fresh air. If material
gets into the eyes, flush eyes immediately with clean water for at least 15 minutes. If available, use eye-cups or eye wash fountain.
If symptoms persist, get medical attention.
SKIN CONTACT: Clean affected areas with mild soap and water. Remove contaminated clothing, including shoes, and launder
before reuse or discard
INHALATION: If respiratory symptoms develop, move victim away from source of exposure and into fresh air. If symptoms
persist, get medical attention. If victim is not breathing immediately begin artificial respiration. Get medical attention.
INGESTION: Product is not likely to be ingested. If this occurs, treat systematically. Never give fluids or induce vomiting if the victim is uncon-
scious or having convulsions.
Section V - FIRE FIGHTING MEASURES
FLASH POINT: -30掳F TCC (Propellant Only)
AUTOIGNITION TEMPERATURE: NA
FLAMMABILITY LIMITS IN AIR (% V): LEL=1.8%; UEL=9.5%
EXTINGUISHING MEDIA: Carbon Dioxide, Foam, Dry Chemical, Water
SPECIAL FIRE FIGHTING PROCEDURES: Keep containers cool by spraying them with water until the fire has been extinguished.
UNUSUAL FIRE & EXPLOSION HAZARDS: Containers may rupture and release flammable liquids and lor gasses if exposed to the heat of fire.
Section VI - ACCIDENTIAL RELEASE MEASURES
SPILL ON LAND (LARGE SPILL): Eliminate sources of ignition. Prevent additional discharge of material, if possible to do so without risk. Mini-
mize breathing of vapors. Minimize skin contact. Ventilate confined spaces. For small spills implement the following cleanup procedures: Prevent
material from entering sewers, watercourses, or low areas. Contain spilled material with sand or earth. Do not use combustible materials such as
sawdust. Observe precautions for volatile, combustible vapors from absorbed material. For large spills implement the preceding cleanup procedures
and, if in public area, keep public away and advise authorities. Consult an expert on disposal of recovered material and ensure conformity to local
disposal regulations.
SPILL ON WATER (LARGE SPILL): Eliminate sources of ignition. Warn occupants and shipping in surrounding and downwind areas of fire and
explosion hazard and request all to stay clear. Remove from surface by skimming or scooping up floating material. Consult an expert on disposal of
recovered material and ensure conformity to local disposal regulations.
SMALL SPILLS: Leaking containers should be placed in open containers, outdoors, away from any source of ignition, until all pressure has been
released.
Section VII - STORAGE AND HANDLING
STORAGE TEMPERATURE: Ambient STORAGEITRANSPORT PRESSURE: 180 psig @ 131掳F Max LOADING/UNLOADING TEMPERA-
TURE: Ambient
STORAGE AND HANDLING: Keep container closed. Handle and open containers with care. Store in a cool, well ventilated place away from
incompatible materials. DO NOT handle or store near an open flame, heat, or other source of ignition. DO NOT pressurize, cut, heat, or weld empty
containers. DO NOT reuse containers.
Section VIII - EXPOSURE CONTROLSIPERSONAL PROTECTION
RESPIRATORY PROTECTION: None Required
VENTILATION: Normal Ventilation adequate for recommended uses. PROTECTIVE CLOTHING: Not necessary except as a good industrial
practice.
EYE PROTECTION: Not necessary except as a good industrial. practice.
OTHER PRECAUTIONS: Avoid excessive inhalation. Read and follow all label directions and cautions. Use only as directed
Section IX - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: White Liquid
STATE: Aerosol
ODOR: Characteristic
PERCENT VOLATILE: 10 %
SPECIFIC GRAVITY: 0.995-1.010 @ 20掳C
VISCOSITY: Aerosol @ ambient
EVAPORATION RATE, > I
VAPOR PRESSURE mm Hg @ 20掳C: Can pressure not to exceed 180 psig @ 131掳F BOILING POINT: 173掳F (Estimated)
VAPOR DENSITY (Air=l): >1
SOLUBILITY IN WATER: Soluble
Section X - REACTIVITY
STABILITY: Stable under normal conditions of storage and handling
CONDITIONS TO AVOID INSTABILITY: Do not store containers in direct sunlight or where conditions will heat them above
120掳F.
HAZARDOUS POLYMERIZATON: Will not occur
CONDITIONS TO AVOID HAZARDOUS POLYMERIZATION: Not Applicable MATERIALS AND CONDITIONS TO AVOID
INCOMPATffiILITY: None Known
Section XI - TOXICOLOGICAL INFORMATION
No specific toxicological data is available for this product. Please refer to Section m for available information on potential health
effects.
Section XII - ECOLOGICAL INFORMATION
No specific ecological data are available for this product. Please refer to Section VI for information regarding accidental releases
and Section XV for regulatory reporting information
Section XIII - DISPOSAL CONSIDERATIONS
All recovered material should be packaged, labeled, transported, disposed and reclaimed in conformance with local, county, state,
and federal regulations. May be disposed of by controlled incineration. Do not contaminate any lakes, streams, ponds, or underground
water supplies.
Empty containers may be disposed of as normal refuse. Please recycle whenever possible.
Section XIV - TRANSPORT INFORMATION
U. S. DOT PROPER SHIPPING NAME:
U. S. DOT HAZARD CLASS:
U. S. DOT LABELS REQUIRED:
U. S. DOT PLACARDS REQUIRED: EMERGENCY RESPONSE GillDE NUMBER:
Consumer Commodity ORM-D
None
None
NAERG# 171
lATA PROPER SHIPPING NAME:
lATA HAZARD CLASS: lATA LABELS REQUIRED:
BILL OF LADING DESCRIPTION:
UNINA CODE:
PACKING INSTRUCTIONS:
EMERGENCY RESPONSE GUIDE NUMBER: EMERGENCY RESPONSE NUMBERS:
Consumer Commodity ORM-D (Domestic) Aerosols, Flammable, N.O.S., UN1950 (Export) 2.1
Consumer Commodity ORM-D-AIR (Domestic) Flammable Gas (Export)
Consumer Commodity ORM-D-AIR, 9, ID8000 (Domestic)
Aerosols, Flammable, N.O.S., 2.1, UN1950 (Export) NA (Domestic)
UN1950 (Export)
910 (Domestic)
203/Y203 (Export)
Authorization: Limited Quantity
126
CHEM- TEL: 1-813-979-0626
US & Canada Only: 1-800-255-3924 International: 00-1-813979-0626
IMDG PROPER SHIPPING NAME:
IMDG HAZARD CLASS:
IMDG LABELS REQUIRED:
IMDG SECONDARY LABELS REQUIRED: IMDG PLACARDS REQUIRED:
BILL OF LADING DESCRIPTION:
MARINE POLLUTANT:
EMERGENCY RESPONSE GUIDE NUMBER: EMS NUMBER:
MFAG NUMBER:
EMERGENCY RESPONSE NUMBERS:
IMDG PAGE NUMBER: UNINA CODE:
Aerosols
2.1
CARTON MUST BE MARKED "AEROSOLS" Hollow Diamond with UN1950 Marked in Center None
Aerosol, 2, UN1950
No
126
2-13
620
CHEM-TEL: 1-813-979.0626
US & Canada Only: 1-800-255-3924 International: 00-1-813979-0626
2102
UN1950
Section XV - REGULATORY INFORMATION
TSCA: Components of this product are listed on the Toxic Substances Control Act (TSCA) Inventory SARA TITLE ill, Section 311-
312: Acute, Fire. Sudden Release (Dimethyl Ether, Ethanol); Acute and Fire Hazard (Dimethyl Ether, Ethanol)
SARA TITLE ill, Section 313: None noted
CALIFORNIA PROPOSITION 65: Not Regulated
Section XVI - OTHER INFORMATION
HAZARD RATING SYSTEMS: This information is for people trained in: National Paint & Coatings Association's (NPCA) Hazardous
NOTE: The information presented herein for this product or its components has been compiled from different supplier sources con-
sidered to be dependable and is accurate to the best of our knowledge as to the proper use and handling of this product under normal
conditions. However, no representation, warranty, or guarantee is made as to its accuracy, reliability, or completeness. It is the user's
responsibility to satisfY himself as to the suitability and completeness of such information for his own particular use. We do not ac-
cept liability for any loss or damage that may occur from the use of this information. Any use of this product which is not in confor-
mance with this MSDS or which involves using the product in combination with any other product or any process is the responsibil-
ity of the user.
EXPLANATION OF ABBREVIATIONS:
ACGIH - American Conference of Governmental Industrial Hygienists CAS# - Chemical Abstract System No.
DOT -Department Of Transportation
IMDG - International Maritime Dangerous Goods code
NA - Not Applicable
ND - Not Determined
NFPA - National Fire Protection Association
OSHA - Occupational Safety and Health Administration
PEL - Permissible Exposure Limits
ppm - Parts Per Million
PMCC - Pen sky-Martin Closed Cup (flash point)
SARA - Superfund Amendments and Reauthorization Act Title I, II, III TL V - Threshold Limit Value
This MSDS has been formatted to be consistent with ANSI Standard Z400.1-1993
|