MSDS Document for STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
Spartan Chemical Company, Inc.
Material Safety Data Sheet
SECTION I: PRODUCT INFORMATION
Product Name or Number (as it appears on label): Product Division:
Janitorial
STAINLESS STEEL CLEANER AND POLISH
(AEROSOL)
Product Number: 6310
Product/Technical
Spartan Chemical Company, Inc. 1-(800)-537-8990
Information:
1110 Spartan Drive Medical Emergency:1-(888)-314-6171 (24 hours)
Chemical Leak/Spil
Maumee OH 43537 CHEMTREC 1-(800) 424-9300 (24 hours)
Emergency:
Shipping Description: ORM-D, Consumer commodity, cleaning compounds, aerosol, n.o.s.
NFPA Ratings: HMIS Ratings:
Health: 1- Slight Health: 1- Slight
Fire: 0 - Minimal Fire: 0 - Minimal
Reactivity: 1- Slight Reactivity: 1- Slight
Pers. Prot. Equip.: A - Safety Glasses
SECTION II: HAZARDOUS INGREDIENTS
(Listed when present at 1% or greater, carcinogens at 0.1% or greater) All component chemicals are listed or
exempted from listing on the "TSCA Inventory" of chemical substances maintained by the U.S. Environmental
Protection Agency.
NTP,
Table Z- 1 - A
IARC or
CELING mg/
OSHA
CAS
3
3 3
% W Registry No. TWA mg/m STEL mg/m Carcinogen
Chemical Name(s) m
Not 1800
05-10 8052-41-3
Odorless mineral spirits 350 (NIOSH) No
Established (NIOSH)
Not Not
05-10 74-98-6
Propane 1800 No
Established Established
1900 Not Not
01-05 75-28-5
Isobutane No
Established Established
(NIOSH)
SECTION III: PHYSICAL DATA
http://www.spartanchemical.com/sfa/MSDSRep.nsf/18ce1...619f51/0f8802c667ea779d852567df006372f2!OpenDocument (1 of 5)7/13/2005 7:42:25 AM
MSDS Document for STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
Boiling Point: N/A Vapor Pressure: Unknown
Vapor Density (AIR = 1): Unknown Solubility in Water: Forms an emulsion
pH: 8.8 Specific Gravity 0.97
(H O=1):
2
Evaporation Rate (but.ace. >1 Percent Solid by 7-9
=1): Weight:
Physical State: Liquid
Appearance & Odor: Creamy sprayed film, lemon fragrance
http://www.spartanchemical.com/sfa/MSDSRep.nsf/18ce1...619f51/0f8802c667ea779d852567df006372f2!OpenDocument (2 of 5)7/13/2005 7:42:25 AM
MSDS Document for STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
SECTION IV: FIRE & EXPLOSIVE HAZARD DATA
Flash Point: None Method Used: ASTM-D56
Flammable Limits: N/A Flame Extension: NA
Extinguishing Media: Water fog, dry chemical, CO
2
Special Fire Fighting Use equipment or shielding required to protect personnel against bursting,
Procedures: rupturing or venting containers.
Unusual Fire & Explosive At elevated temperatures (over 54掳C/130掳F) container may vent, rupture or burst.
Hazards:
SECTION V: HEALTH HAZARD DATA
Threshold Limit Value: Not Established Primary Routes of Inhalation, Skin Contact
Entry:
Effects of Overexposure- Avoid skin and eye contact, may cause skin or eye irritation.
Conditions to Avoid:
Conditions Aggravated by Unknown
Use:
Emergency & First Aid Procedures:
Eyes: In case of contact; flush eyes with water for at least 15 minutes. Remove contact
lenses.
Skin: Wash off in flowing water or shower. Wash clothing before reuse.
Ingestion: Induce vomiting if large amounts are ingested. Seek medical attention.
SECTION VI: REACTIVITY DATA
Stability: Stable Incompatible Oxidizing material; acids
Materials:
Hazardous Decomposition None known Hazardous Will Not Occur
Products: Polymerization:
SECTION VII: SPILL OR LEAK PROCEDURES
Steps to be Taken in Case Dilute with water and flush into sanitary sewer system..
Material is Released or
Spilled:
Waste Disposal Method: Do not incinerate or puncture aerosol container. Dispose of in accordance with
state or local regulations.
http://www.spartanchemical.com/sfa/MSDSRep.nsf/18ce1...619f51/0f8802c667ea779d852567df006372f2!OpenDocument (3 of 5)7/13/2005 7:42:25 AM
MSDS Document for STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
SECTION VIII: SPECIAL PROTECTION INFORMATION
Respiratory Protection: None required
Ventilation: Good general ventilation should be sufficient for most conditions. Local exhaust
ventilation may be necessary for some operations.
Protective Gloves(Specify None required
Type):
Eye Protection(Specify Safety glasses while spraying
Type):
Other Protective Equipment: None required
http://www.spartanchemical.com/sfa/MSDSRep.nsf/18ce1...619f51/0f8802c667ea779d852567df006372f2!OpenDocument (4 of 5)7/13/2005 7:42:25 AM
MSDS Document for STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
SECTION IX: SPECIAL PRECAUTIONS
Precautions; Handling & Contents under pressure. Do not use near fire, sparks, or flame. Do not store
Storing: where tempertures could exceed 120掳F.
Other Precautions: None
漏 SCC 11/05/1999 Name: Ronald T. Cook Title: Manager, Regulatory Affairs
STAINLESS STEEL CLEANER Effective 11/05/1999 Supercedes: 09/24/1999
AND POLISH (AEROSOL) Date:
Ref: 29 CFR 1910.1200 Changes: Section II correction
(OSHA)
This document has been prepared using data from sources considered technically reliable. It does not constitute a
warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and
handling are beyond sellers control. User is responsible to evaluate all available information when using product
for any particular use and to comply with all Federal, State and Local laws and regulations.
http://www.spartanchemical.com/sfa/MSDSRep.nsf/18ce1...619f51/0f8802c667ea779d852567df006372f2!OpenDocument (5 of 5)7/13/2005 7:42:25 AM
|