MATERIAL SAFETY DATA SHEET PHASE庐
FOR CHEMICAL EMERGENCY, SPILL, LEAK, FIRE, EXPOSURE OR ACCIDENT, CALL CHEMTREC - DAY OR NIGHT 1-800-424-9300
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
FORMULATED FOR:
Loveland Industries, Inc. 24-Hour Emergency Phone: 1-800-424-9300
P.O. Box 1289 鈥? Greeley, CO 80632-1289 Medical Emergencies: 1-800-301-7976
PRODUCT NAME: PHASE庐
CHEMICAL NAME: Mixture
CHEMICAL FAMILY: Surfactant - Adjuvant
CALIF. REG. NO.: 36208-50031
WA REG. NO.: AW36208-00001
MSDS Number: PHS-03 MSDS Revisions: All sections reviewed and/or revised Date Of Issue: 10/15/03 Supersedes: 02/29/96
2. COMPOSITION, INFORMATION ON INGREDIENTS
Chemical Ingredients: Percentage by Weight: CAS No. TLV (Units)
Methylated esters of fatty acids, alkylpolyoxy- 100.00 Mixture none established
Ethylene ether and polyether modified polysiloxane
3. HAZARDS IDENTIFICATION SUMMARY
KEEP OUT OF REACH OF CHILDREN 鈥? CAUTION 鈥? Harmful if absorbed through skin. Causes mild eye irritation. Avoid contact with skin, eyes or clothing.
This product is yellow liquid with a mild fatty odor
.
4. FIRST AID MEASURES
If in Eyes: Flush with water for 15 minutes. Get medical attention if irritation persists.
If on Skin: Remove contaminated clothing. Wash with soap and water.
If Swallowed: Give 2 glasses of water. DO NOT induce vomiting. Call a physician if irritation persists.
If Inhaled: Remove to fresh air.
5. FIRE FIGHTING MEASURES
>212OF / >100OC (PMCC)
FLASH POINT (掳F/Test Method):
FLAMMABLE LIMITS (LEL & UEL): Not established
EXTINGUISHING MEDIA: Foam, Dry chemical, CO2, or water spray.
HAZARDOUS COMBUSTION PRODUCTS: None known.
SPECIAL FIRE FIGHTING PROCEDURES: Wear self-contained breathing apparatus and full protective gear.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Dike area to contain run-off and prevent contamination of water supplies. Burning may produce toxic
fumes, carbon monoxide, carbon dioxide and oxides of silicon.
6. ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
Wear appropriate personal protective equipment (refer to Section 8) when responding to spills. Shut off source of leak if safe to do so. Dike and contain
spill. Soak up residue with absorbent such as clay, sand or other suitable material and dispose of properly. Flush area with water to remove trace
residue. Contain runoff from residue flush and dispose of properly. Place in container for proper disposal. Check local, state and federal regulations for
proper disposal.
CAUTION: Keep spills and cleaning runoff out of municipal sewers and open bodies of water.
7. HANDLING AND STORAGE
HANDLING: Wash with soap and water before eating, drinking, smoking, applying cosmetics, or using toilet facilities. Keep away from
children, feed and foodstuffs, fertilizers and seed.
STORAGE: Store in a cool, dry place. Store in original container. Keep tightly closed. Do not reuse empty container. Keep out of reach of
children.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS: Work in well-ventilated area.
RESPIRATORY PROTECTION: Wear a NIOSH approved respirator for pesticides if necessary.
EYE PROTECTION: Chemical goggles or shielded safety glasses.
SKIN PROTECTION: Wear long sleeved shirt, long pants, and shoes with socks. Wear impervious rubber or chemical-resistant gloves.
Have eyewash and safety shower available.
OSHA PEL 8 hr TWA ACGIH TLV-TWA
For product not established not established
PAGE 1 OF 3
MATERIAL SAFETY DATA SHEET PHASE庐
9. PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE AND ODOR: Yellow liquid with mild fatty odor SOLUBILITY: Dispersible
SPECIFIC GRAVITY (Water= 1): 0.91 g/ml BULK DENSITY: 7.59 lbs/gal. pH: 7.3 (1% solution)
VAPOR PRESSURE: Not established BOILING POINT: Not established
PERCENT VOLATILE (by volume): Not established EVAPORATION RATE: Not established
Note: These physical data are typical values based on material tested but may vary from sample to sample.
Typical values should not be construed as a guaranteed analysis of any specific lot or as specification items.
10. STABILITY AND REACTIVITY
STABILITY: Stable CONDITIONS TO AVOID: None known.
INCOMPATIBILITY: None known.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide, carbon dioxide, toxic fumes and oxides of silicon from burning.
HAZARDOUS POLYMERIZATION: Will not occur.
11. TOXICOLOGICAL INFORMATION
Acute Oral LD50 (rat): >5000 mg/kg [EPA Category IV] Acute Dermal LD50 (rat): >2000 mg/kg [EPA Category IV]
Eye Irritation (rabbit): Mild to moderate irritant [EPA Category III] Skin Irritation (rabbit): Not a skin irritant [EPA Category IV]
Inhalation LC50 (rat): >0.19 mg/L (4 HR) Skin Sensitization: Not a sensitizer
Carcinogenic Potential: None listed by OSHA, NTP, IARC, and ACGIH as a carcinogen
12. ECOLOGICAL INFORMATION
ALTHOUGH ACTUAL AQUATIC TOXICITY TESTS HAVE NOT BEEN PERFORMED ON THIS PRODUCT, THE COMPONENTS USED IN THE FORMULATION OF THIS PRODUCT
DO NOT INDICATE AQUATIC TOXICOLOGICAL CONCERNS.
Do not apply directly to water, or to areas where surface water is present or to intertidal areas below the mean high water mark. Do not contaminate water
when cleaning equipment or disposing of equipment wash waters.
13. DISPOSAL CONSIDERATIONS
Do not reuse product containers. Plastic Jugs: Triple rinse (or equivalent), adding rinse water to spray tank, then offer for recycling at an ACRC site or by
reconditioning, or puncture and dispose of in a sanitary landfill or by other procedures approved by local, state and federal regulations.
14. TRANSPORT INFORMATION
DOT Shipping Description: NOT REGULATED BY USDOT.
Freight Classification: ADHESIVES, ADJUVANTS, SPREADERS OR STICKERS (NMFC 4610; CLASS: 60)
Consult appropriate ICAO/IATA and IMDG regulations for shipment requirements in the Air and Maritime shipping modes.
15. REGULATORY INFORMATION
NFPA & HMIS Hazard Ratings: NFPA HMIS
2 Health 0 Least 2 Health
1 Flammability 1 Slight 1 Flammability
0 Instability 2 Moderate 0 Reactivity
3 High H PPE
4 Severe
SARA Hazard Notification/Reporting
SARA Title III Hazard Category: Immediate __Y__ Fire __N__ Sudden Release of Pressure __N__
Delayed __N__ Reactive __N__
Reportable Quantity (RQ) under U.S. CERCLA: Not listed
SARA, Title III, Section 313: Not listed
RCRA Waste Code: Not listed
CA Proposition 65: Not listed
PAGE 2 OF 3
MATERIAL SAFETY DATA SHEET PHASE庐
16. OTHER
MSDS STATUS: All sections reviewed and/or revised
PREPARED BY: Registrations and Regulatory Affairs REVIEWED BY: Environmental/ Regulatory Services
庐Phase is a registered trademark of Loveland Industries, Inc.
Although the information and recommendations set forth herein (hereinafter 鈥淚nformation鈥?) are presented in good faith and believed to be correct, Loveland
Industries, Inc., the manufacturer or the seller makes no representations as to the completeness or accuracy thereof. Information is supplied upon the
condition that the persons receiving it will make their own determination as to its suitability for their purposes prior to use.
The product covered by this information sheet is furnished 鈥渁s is鈥? by Loveland Industries, Inc., the manufacturer or the seller, and is subject only to the
warranties, if any, that appear on the product鈥檚 label or are otherwise expressly provided herein.
Except as expressly provided on the product鈥檚 label or otherwise provided herein, no warranties, guarantees, or representations of any kind, either express
or implied, or by usage of trade, statutory or otherwise, are made by Loveland Industries, Inc., the manufacturer or the seller with regard to the product or
use of the product, including, but not limited to, merchantability, fitness for a particular purpose, use or eligibility of the product for any particular trade
usage.
Except as expressly stated herein, Loveland Industries, Inc., the manufacturer or the seller makes no warranty of results to be obtained by use of the
product covered by this information. Buyer鈥檚 or user鈥檚 exclusive remedy, and the total liability of Loveland Industries, Inc., the manufacturer or the seller,
shall be limited to damages not exceeding the cost of the product. No agent or employee of Loveland Industries, Inc., the manufacturer or the seller is
authorized to amend the terms of this warranty disclaimer or the product鈥檚 label or to make a representation or recommendation different from or
inconsistent with the label of this product.
IN NO EVENT SHALL LOVELAND INDUSTRIES, INC., THE MANUFACTURER OR THE SELLER BE LIABLE FOR CONSEQUENTIAL, SPECIAL OR
INDIRECT DAMAGES RESULTING FROM THE USE, HANDLING, APPLICATION, STORAGE OR DISPOSAL OF THIS PRODUCT OR FOR
DAMAGES IN THE NATURE OF PENALTIES AND THE BUYER AND USER WAIVE ANY RIGHT THEY MAY HAVE TO SUCH DAMAGES.
PAGE 3 OF 3
|