Material Safety Data Sheet
PremierArt - Print Shield - Aerosol Can
Section I - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name: Print Shield
General Use: Spray varnish sealer for ink jet prints
Product Description:Aerosol spray sealer
Manufactured For: Premier Imaging Products
P.O. Box 1427 Oxnard, CA 93030 USA
TELEPHONE No.: 805 983 1472
Section II - COMPOSITION / INFORMATION ON INGREDIENTS
Hazardous Ingredients % Wt. CAS No. EEC No. R
Symbol EXPOSURE LIMITS
Long Term (8Hr) Short Term
(15 mins)
mg/m3 mg/m3
ppm ppm
Isopropyl Alcohol 40-60 67-63-0 200-661-7 F 11, 36, 67 400 999 500 1250
Dimethyl Ether 40-60 115-10-6 204-065-8 F+ 12 400 766 500 958
966
n-Butyl Acetate 1-3 123-86-4 204-658-1 - 10, 66, 67 150 742 200
Remaining ingredients not considered hazardous under CHIP regulations
Section III - HAZARDS IDENTIFICATION
Extremely Flammable. Vapour harmful. The principal safety and health hazards when using the product are due to
inhalation of isopropanol vapors. There is also a risk of ignition of the spray should it pass through or on an ignition
source. Inhalation may occur while spraying the product or during the drying process. If the product is used with
adequate ventilation, risk of excessive inhalation is eliminated.
Section IV - FIRST AID MEASURES
EYES : Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if irritation
persists.
SKIN : Wash with soap and water. Get medical attention if irritation or rash develops. Remove and launder
contaminated clothing before reuse.
INGESTION: If fully conscious, drink plenty of water. Induce vomiting. Get medical attention.
INHALATION: Remove to fresh air. If not breathing, apply artificial respiration. Get immediate medical
attention
ADVICE TO PHYSICIAN : Treat symptoms.
Section V - FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: Dry chemical, carbon dioxide, foam for alcohols, water fog/ spray.
FIRE/EXPLOSION HAZARDS: Containers are under pressure. Exposure to high heat may result in
explosion.
FIRE FIGHTING MEASURES: Wear a self-contained breathing apparatus and full protective gear. Cool
cans with water.
NFPA HAZARD CODES: Health/Flammability/Reactivity 2 4 1
Section VI - ACCIDENTAL RELEASE MEASURES
Evacuate area. Provide adequate ventilation. Contain spill to a small area. Flush away from ignition sources
with water. Pick up with absorbent material and transfer to suitable container for disposal. Keep out of
sewers, streams and waterways.
Premier Imaging Products, Inc. info@premierimagingproducts.com
PO Box 1472 Oxnard, CA 93030
1
Section VII - HANDLING AND STORAGE
Do not puncture or crush container, even when empty. Keep away from open flames and sparks.
Store above 0oC (32oF) and below 49oC (120oF). Do not store in direct sunlight.
Section VIII - EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS: Good general ventilation should be sufficient to control airborne levels. Use a
fume hood if PEL/TLV may be exceeded.
OPORATOR PROTECTION
RESPIRATORY PROTECTION: For most conditions no respiratory protection should be needed. If
Exposure limit is exceeded, wear an approved organic respirator.
PROTECTIVE GLOVES: Not normally required. Wear chemical resistant gloves, if skin contact may occur.
EYE PROTECTION: Wear safety glasses or goggles.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Clear low viscosity liquid with an alcohol odor.
BOILING POINT: 82.5癈 (181癋) (Isopropanol)
FLASH POINT: 12癈 (53癋) open cup (Product only)
AUTOIGNITION TEMP: not determined
VAPOUR PRESSURE: not determined
SOLUBILITY IN WATER: Miscible
FREEZING POINT: Less than 0癈
SPECIFIC GRAVITY: 0.78 kg/l
pH: Not applicable
VAPOUR DENSITY: >1 (Air = 1)
EVAPORATION RATE: <1 (Ether#1)
% VOLATILE (BY VOLUME): 90
FLAMMABLE LIMITS: Lower: 2.0 Upper: 12.7 (Isopropanol)
Section X - STABILITY AND REACTIVITY
STABLE: Yes
INCOMPATIBILITY: Strong Oxidizers, strong inorganic acids.
HAZARDOUS DECOMPOSITION PRODUCTS: May include oxides of carbon, nitrogen and other toxic
fumes.
HAZARDOUS POLYMERISATION: Will not occur.
Section XI - TOXICOLOGICAL INFORMATION
PRIMARY ROUTE OF EXPOSURE: Inhalation, skin and eye contact
ACUTE EFFECTS:
EYES: Eye contact may cause irritation.
INHALATION: Inhalation in excess of PEL/TLV may result in dizziness and headache and in extreme cases,
loss of consciousness.
SKIN: Repeated or prolonged skin contact may cause skin irritation and defat the skin.
CHRONIC EFFECTS: None expected from available data.
CANCER INFORMATION: This product contains no ingredient that is listed on the IARC, NTP, or OSHA
carcinogen lists.
Section XII - ECOLOGICAL INFORMATION
No data available
Section XIII - DISPOSAL CONSIDERATIONS
Do not incinerate. Bury in licensed facility. Follow Federal, State, and local regulations.
Premier Imaging Products, Inc. info@premierimagingproducts.com
PO Box 1472 Oxnard, CA 93030
2
Section XIV - TRANSPORTATION INFORMATION
TDG: Aerosol, 2.1, UN1950 IMDG: Aerosols, Class 2, UN1950, ERG No.12
IATA/CAO: Aerosols, Flammable, N.O.S., UN 1950
ARD/RID: Aerosol Dispensers, 2, 5癋 ARD.UN1950
U.S. DOT: Consumer Commodity ORM-D for package weights more than 30 Kg. - Aerosols, Flammable,
N.O.S., UN
Section XV - REGULATORY INFORMATION
EUROPEAN CLASSIFICATION: F+, Extremely flammable; R-Phrase - Extremely flammable; S-Phrase -
keep away from ignition sources, no smoking.
CANADIAN CLASSIFICATION: B-2: Flammable aerosol; R-Phrase - Flammable; S-Phrases - keep away
from sources of ignition, no smoking; Do not breathe spray; Use only in well ventilated areas.
Section XVI - OTHER INFORMATION
HMIS Rating : Health : 2 Flammability : 4 Reactivity : 1
CERCLA/SUPERFUND,40 CFR 302.4: Dimethyl Ether is reportable, 100 lbs (45.4 kg.).
TOXIC SUBSTANCES CONTROL ACT (TSCA) : The ingredients of this product are all on the TSCA
inventory list.
SARA TITLE III, 313 CHEMICALS: None
CALIFORNIA PROPOSITION 65: This product contains no chemical known to the State of California to
cause cancer, birth defects, or other reproductive harm.
This information is based solely on the data provided by the suppliers of the materials
used and/or recognized technical sources, not on the mixture itself and is believed to be
correct as of this date.
No warranty is expressed or implied regarding the accuracy of the data.
Premier Imaging Products, Inc. info@premierimagingproducts.com
PO Box 1472 Oxnard, CA 93030
3
|