Material Safety Data Sheet
Page 1 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER
Product Name: ERABOND 6100 PRIMER PART B
Synonym: None
Use: Polyurethane primer curative
Era Polymers Pty Ltd
25-27 Green Street
Banksmeadow NSW 2019
Australia
Ph: +61 2 9666 3788
Fax: +61 2 9666 4805
Emergency Advice All Hours:
Technical Manager +61 2 9666 3788
2. HAZARDS IDENTIFICATION
NOT CLASSIFIED AS HAZARDOUS ACCORDING TO NOHSC CRITERIA
Hazard Category: None allocated
Hazard Classification: NON-HAZARDOUS SUBSTANCE, DANGEROUS GOOD
RISK PHRASES
R10 Flammable.
SAFETY PHRASES
S16 Keep away from sources of ignition - No smoking.
S24/25 Avoid contact with skin and eyes.
S29 Do not empty into drains.
S45 In case of accident or if you feel unwell, contact a doctor immediately and show this container or label.
S51 Use only in well-ventilated areas.
S60 This material and its container must be disposed of as hazardous waste.
Poison Schedule: S5 [Aust]
This material is a Scheduled S5 Poison and must be stored, handled and used according to the appropriate regulations.
Warning Statement:
Avoid skin and eye contact. Flammable liquid - avoid sources of ignition.
3. COMPOSITION / INFORMATION ON INGREDIENTS
SUBSTANCE NAME Proportion CAS Number
N-BUTYL ACETATE 10 to 30% 123-86-4
1-METHOXY-2-PROPANOL ACETATE (Below Cut-off) 1 to 10% 108-65-6
All other ingredients not hazardous according to NOHSC Criteria.
4. FIRST AID MEASURES
Swallowed:
If swallowed, DO NOT induce vomiting. If vomiting occurs, the head should be kept low so that stomach vomit doesn't
enter the lungs. Drink plenty of water. Seek medical attention.
Material Safety Data Sheet
Page 2 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
Eye:
If material is splashed into eyes, flush with plenty of water for at least 15 minutes, ensuring eyelids are held open. Seek
medical attention if irritation persists.
Skin:
If material is splashed onto the skin, remove any contaminated clothing and wash skin thoroughly with water and soap.
Seek medical attention if irritation persists.
Inhaled:
Remove exposed person to fresh air at once. When breathing is difficult, properly trained personnel ay assist affected
person by administering 100% oxygen. Seek medical attention if any discomfort continues.
First Aid Facilities:
Eye wash fountain, safety shower and normal washroom facilities.
Advice to Doctor:
Treat symptomatically.
In case of poisoning, contact Poisons Information Centre
In Australia call Tel: 131126
In New Zealand Tel: 034747000
5. FIRE-FIGHTING MEASURES
Fire/Explosion Hazard
EXTINGUISHING MEDIA: Fire can be extinguished using water spray, fog or mist; foam; carbon dioxide; or dry
powder.
SPECIAL FIRE FIGHTING PROCEDURES: Self-contained breathing apparatus (SCBA) and full protective clothing
required for fire-fighting personnel. If possible to do so safely, shut off fuel to fire. Avoid breathing fire vapours. Cool
containers exposed to flames with water until well after the fire is out. Keep run-off water out of sewers and water
sources. Dike for water control.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Flammable liquid. By heating and fire, irritating vapours or gases
may be formed. Vapours from this product may travel considerable distance to source of ignition and flash back.
HAZCHEM CODE: 3[Y] [Aust]
FLAMMABILITY
Flammable liquid. Avoid all sources of ignition, heat and naked flames.
6. ACCIDENTAL RELEASE MEASURES
PERSONAL PRECAUTIONS:
Warn everybody of potential hazards and evacuate if necessary. Remove sources of ignition. Avoid inhalation of spray
mist and avoid contact with skin and eyes. Wear protective clothing as described in Section 8 of this safety data sheet.
Provide adequate ventilation.
ENVIRONMENTAL PRECAUTIONS:
Do not discharge into drains, watercourses, or onto the ground. Spillages or uncontrolled discharges into watercourses
must be immediately alerted to the local water company or Environmental Agency.
SPILL CLEAN-UP METHODS:
Absorb with non-combustible absorbent material. Transfer to a container for disposal. Containers with collected
spillage must be properly labelled with correct contents and hazard symbol.
Material Safety Data Sheet
Page 3 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
7. HANDLING AND STORAGE
USAGE PRECAUTIONS:
Provide adequate ventilation, including appropriate local extraction, to ensure that the defined occupational exposure
limit is not exceeded. Take precautionary measures against static discharges. Storage tanks and other containers must
be grounded. Do not smoke, use naked flames or other sources of ignition. Do not eat, drink or smoke when using the
product. Observe good industrial hygiene practices.
STORAGE PRECAUTIONS:
Store in tightly closed original containers in a cool, dry, well-ventilated place. Keep away from heat, sparks and open
flame.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Standards
No exposure standards are available for this product, however, the following exposure standards have been assigned by
[NOHSC] to the following components of the product:
? N-BUTYL ACETATE
(Worksafe Australia)
[TWA] 150 ppm 713 mg/m?br>
[STEL] 200 ppm 950 mg/m?br>
References: H
(ACGIH)
[TWA] 150 ppm 713 mg/m?br>
[STEL] 200 ppm 950 mg/m?br>
Carcinogen Category: A4
? 1-METHOXY-2-PROPANOL ACETATE (Below Cut-off)
(Worksafe Australia)
[TWA] 50 ppm 274 mg/m?br>
[STEL] 100 ppm 548 mg/m?br>
Notices: Sk
(ACGIH)
[TWA] 100 ppm
Engineering Controls
Flammable liquid. Maintain adequate general and local exhaust ventilation at all times. Prevent accumulation of
vapours in hollows or sumps. Eliminate any sources of ignition. Elevated temperature or mechanical action may form
vapours, mists or fumes, which may require local exhaust ventilation systems. If ventilation is insufficient, wear
approved respiratory protection.
Personal Protection Equipment
CLOTHING: Wear suitable protective clothing to prevent skin contact.
GLOVES: Wear protective gloves to prevent skin contact - rubber or plastic.
EYES: Wear safety glasses with side shields, chemical goggles or face shield to protect eyes.
RESPIRATORY PROTECTION: Avoid breathing of vapours/gases. Select and use respirators in accordance with
AS/NZS 1715/1716. When gases exceed the exposure standards then the use of a half-face respirator with organic
vapour cartridge is recommended. For high concentrations use an atmosphere-supplied, positive pressure demand self-
contained or airline breathing apparatus, complying with the requirements of AS/NZS 1715 is recommended. Filter
capacity and respirator type depends on exposure levels and type of contaminant. If entering spaces where the airborne
concentration of a contaminant is unknown then the use of a Self-contained breathing apparatus (SCBA) with positive
pressure air supply complying with AS/NZS 1715 / 1716, or any other acceptable International Standard is
recommended.
Material Safety Data Sheet
Page 4 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Grey liquid
Boiling Point Melting Point: BP = 125-150癈, MP = not determined
Vapour Pressure: Not determined
Specific Gravity: 1.55 @ 25癈
Flash Point: 26.6癈
Flammability Limits: Not determined
Solubility in Water: Insoluble
Other Properties
Vapour density > 1 (air = 1)
% Volatiles (by vol.) = 34%
10. STABILITY AND REACTIVITY
STABILITY:
Stable under normal temperature conditions and recommended use.
HAZARDOUS DECOMPOSITION PRODUCTS:
Thermal decomposition or combustion may liberate carbon monoxide, carbon dioxide and other toxic gases or vapours.
HAZARDOUS POLYMERIZATION:
Will not occur under normal conditions of use.
INCOMPATIBILITIES:
Avoid contact with: oxidising agents, strong acids, and isocyanates.
CONDITIONS TO AVOID:
Avoid heat, flames and other sources of ignition. Avoid excessive heat for prolonged periods of time. Store below
25癈.
11. TOXICOLOGICAL INFORMATION
No adverse health effects are expected, if the product is handled in accordance with this Material Safety Data Sheet and
the product label. Symptoms and effects that may arise if the product is mishandled and overexposure occurs are:
ACUTE HEALTH EFFECTS:
Swallowed:
May cause irritation to mouth, throat and stomach with effects including mucous build up, irritation to the tongue and
lips and pains in the stomach, which may lead to nausea, vomiting and diarrhoea.
Eye:
May cause irritation to the eyes, with effects including: tearing, pain, stinging and blurred vision.
Skin:
May cause irritation to the skin, with effects including: redness and itchiness.
Inhaled:
May cause irritation to the nose, throat and respiratory system with effects including: dizziness, headache and loss of
co-ordination.
Chronic:
Prolonged or repeated skin contact may lead to dermatitis.
Toxicological Data:
There is no other toxicological information available for this product.
Material Safety Data Sheet
Page 5 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
12. ECOLOGICAL INFORMATION
Ecotoxity:
Avoid release to the environment.
Mobility:
Do not allow any environmental contamination. Do not discharge into drains, watercourses, or onto the ground.
Persistence / Degradability:
Do not contaminate water sources or sewer.
Chemical Fate Information:
This substance may cause long-term adverse effects in the environment.
13. DISPOSAL CONSIDERATIONS
Dispose of in accordance with all relevant Local, State and Federal regulations. Dispose of material through a licensed
waste contractor. Any processing, use, or contamination of this product may change the requirements for disposal. It is
the responsibility of the generator of the waste to properly classify, transport and dispose of the waste.
14. TRANSPORT INFORMATION
Road Transport
UN Number: 1139
Proper Shipping Name: COATING SOLUTION
Dangerous Goods Class: 3
Packing Group: III
Label: None allocated
Air Transport
UN Number: 1139
Proper Shipping Name: COATING SOLUTION
Dangerous Goods Class: 3
Packing Group: III
Label: None allocated
Sea Transport
UN Number: 1139
Proper Shipping Name: COATING SOLUTION
Dangerous Goods Class: 3
Packing Group: III
Label: None allocated
15. REGULATORY INFORMATION
Poison Schedule: S5 [Aust]
Inventory Status:
Inventory Status
Australia (AICS) Y
Y = all ingredients are on the inventory.
Material Safety Data Sheet
Page 6 of 6 Issue date: September 2008
ERABOND 6100 PRIMER PART B
16. OTHER INFORMATION
Date of Preparation:
Issue date: 10 September 2008
Supersedes: None
Reasons for Update:
First Issue
Key Legend Information:
NOHSC - National Occupational Health & Safety Commission {Formerly Worksafe}[Aust]
SUSDP - Standard for the Uniform Scheduling of Drugs and Poisons [Aust]
TWA - Time Weighted Average [Int]
STEL - Short Term Exposure Limit [Int]
AICS - Australian Inventory of Chemical Substances
EPA - Environmental Protection Agency [Int]
NIOSH - National Institute for Occupational Safety and Health [US]
AS/NZS 1715 - Selection, use and maintenance of respiratory protective devices. [Aust/NZ]
AS/NZS 1716 - Respiratory protective devices. [Aust/NZ]
IATA - International Aviation Transport Authority [Int]
ICAO - International Civil Aviation Organization [Int]
IMO - International Maritime Organisation. [Int]
IMDG - International Maritime Dangerous Goods [Int]
United Nations Recommendations for the Transport of Dangerous Goods and Globally Harmonized System for the
classification and labelling of Chemicals. [Int]
EU - European Union
[Aust/NZ] = Australian New Zealand
[Int] = International
[US] = United States of America
Removal of the heading of Poison Schedule [Aust], in section 3 and 15 of this Material Safety Data Sheet (MSDS)
makes this a valid health and safety document in other international jurisdictions/countries. For full compliance please
contact your Federal, State or Local regulators for further information.
Disclaimer
This MSDS summarises our best knowledge of the health and safety hazard information available on the product and
the measures to be used to handle and use the product safely. Each user should read this MSDS and consider the
information in connection with the way the product is intended to be handled or used.
Principal References:
Information supplied by manufacturer, reference sources including the public domain.
END OF MSDS
|