Material Safety Data Sheet (DS)
IDENTITY (As Used on Label and List)
DELTA-SOL PRESERVATIVE
Section I
Manufacturer's Name Emergency Telephone Number
RANACO CORPORATION 24HR Assistance CHEMTREC: 1-800-424-9300
Address (Number, Street, City, State, and ZIP Code) Telephone Number for Information
4345 E. Irvington Road 1-520-790-7737 (Arizona Time 8am-5pm)
Tucson, AZ 85714 Date Prepared
April 22, 2010
Signature of Preparer (Optional)
Section II ?Hazardous Ingredients/Identity Information
Other Limits
Hazardous Components (Specific Chemical Identity; Common Name(s)) CAS # OSHA PEL ACGIH TLV % Optional
Recommended
Not Not WEEL
Propylene Glycol 57-55-6 9
10mg/m3
Established Established
Not Not None
Ethylene Glycol Phenyl Ether 122-99-6 1
Established Established Recommended
Not Not None
Diethylene Glycol Phenyl Ether 104-68-7 0.01
Established Established Recommended
Section III ?Physical/Chemical Characteristics
Boiling Point Specific Gravity (H2O = 1)
>212? 1
Vapor Pressure (mm Hg.) Melting Point
NA NA
Vapor Density (AIR = 1) Evaporation Rate
>4 <1
Butyl Acetate = 1
Solubility in Water
99%
Appearance and Odor
Clear colorless liquid. Mild pleasant odor.
Section IV ?Fire and Explosion Hazard Data
Flash Point (Method Used) Flammable Limits LEL UEL
Glycol Ether Phenyl Ether = 172
Propylene Glycol 2.6 Propylene Glycol 12.5
Propylene Glycol = 218
Extinguishing Media
Use water spray, dry chemical, CO2 or alcohol foam.
Special Fire Fighting Procedures
Wear fire fighting protective equipment and self-contained breathing apparatus.
Unusual Fire and Explosive Hazards
None specified.
Ranaco MSDS Form, Rev Apr 2010
Page 1 of 2
Section V ?Reactivity Data
Stability Unstable Conditions to Avoid
X Avoid high temperatures above 200?F and removal of water.
Stable
Incompatibility (Materials to Avoid)
Acids, Alkalis, and oxidizing materials.
Hazardous Decomposition or Byproducts
May liberate carbon monoxide or carbon dioxide, and propionaldehyde along with organic compounds in black smoke.
Hazardous Polymerization May Occur Conditions to Avoid
Will Not Occur Heat sparks, and open flames.
X
Section VI ?Health Hazard Data
Route(s) of Entry: Inhalation? Skin? Ingestion?
Yes Yes Yes
Health Hazards (Acute and Chronic)
SKIN: Prolonged contact is essentially non-irritating to the skin. Highly excessive exposure may cause a softening of the skin, and/or absorption of
harmful amounts of Glycol Ether EPH which may cause Hemolysis, thereby impairing the bloods ability to transport oxygen. It is very doubtful that this
will occur with the amounts of Ethylene Glycol Phenyl Ether contained in this mixture. EYES: Liquid and mist may irritate the eyes. Slight risk of corneal
injury due to the Glycol Ether EPH content. INHALATION: No adverse effects expected or known. INGESTION: Swallowing large quantities may cause
diarrhea, nausea and vomiting. CHRONIC: May cause slight anesthesia and tissue injury. Excessive repeated ingestions may cause central nervous
system effects. Animal studies suggest the liver and kidneys may be target organs for overexposure
Carinogenicity: NTP? IARC Monographs? OSHA Regulated?
No No No
Signs and Symptoms of Exposure
SKIN: Moderate irritation; EYES: Severe irritation; INGESTION: Toxic; INHALATION: Low or mild irritation
Medical Conditions Generally Aggravated by Exposure
None specified.
Emergency and First Aid Procedures
SKIN: Wash with soap and water. EYES: Flush with water for 15 minutes lifting the upper and lower eyelids occasionally. INHALATION: Move victim
promptly to fresh air. Give oxygen if breathing is difficult. INGESTION: If conscious, drink no more than 2 glasses of water and induce vomiting. Keep
head below hips while vomiting. Seek medical attention if any of the above symptoms persist.
Section VII ?Precautions for Safe Handling and Use
Steps to Be Taken in Case Material is Released or Spilled
Wear protective equipment. Eliminate sources of ignition. Ventilate area. Remove spill with pump or with non-flammable absorbent. Place in suitable
container for disposal. Prevent liquid from entering sewers, waterways or low areas. Comply with all applicable governmental regulations on spill
reporting, handling and disposal of waste. Generally not a concern with this product.
Waste Disposal Method
Dispose of contaminated product and materials used in cleaning up spills or leaks in a suitable container. Consult appropriated federal, state and local
regulatory agencies to ascertain proper disposal procedures.
Precautions to Be Taken in Handling and Storage
Store in tightly closed containers in flammable liquid storage room/cabinet. Avoid excessive heat. Keep away from incompatible materials.
Other Precautions
Do not pressurize, cut, weld, braze, solder, drill, grind, or expose containers to heat, flame, sparks, static electricity, or other sources of ignition. Do not
store or handle in aluminum equipment at temperatures above 120 癋.
Section VIII ?Control Measures
Respiratory Protection (Specify Type)
If levels may or does exceed the recommended health standards, wear a respirator. For emergency use, wear breathing apparatus.
Ventilation Local Exhaust Special
General room ventilation
Mechanical Other
Protective Gloves Eye Protection
Yes Safety glasses/face shield
Other Protective Clothing or Equipment
Long sleeved shirt, trousers, and safety shoes. Eye wash station and safety showers should be available in the immediate vicinity of
any potential exposure.
Work/Hygienic Practices
Wash hands before eating, drinking, smoking, or using toilet facilities. Wash contaminated clothing before reuse.
FOR ADDITIONAL INFORMATION
Contact Ranaco's Safety Manager during business hours at (520) 790-7737
NOTICE: RANACO expressively disclaims all express or implied warranties of merchantability and fitness for a particular purpose, with respect to the product or information provided herein.
All information appearing herein is based upon data obtained from the manufacturer and/or recognized technical sources. While the information is believed to be accurate, RANACO makes no
representations as to its accuracy or sufficiency. Conditions of use are beyond RANACO's control and therefore users are responsible to verify this data under their own operating conditions to determine
whether the product is suitable for their particular purposes and they assume all risks of their use, handling and disposal of the product, or from the publication or use of, or reliance upon, information
contained herein. This information relates only to the product designated herein, and does not relate to its use in combination with any other material or in any other process.
Page 2 of 2
|