MATERIAL SAFETY DATA SHEET
FINISHES, COATINGS AND RELATED MATERIALS
MANUFACTURER: Poloplaz. EMERGENCY CONTACT (INFOTRAC #): 1-800-535-5053
1 Paradise Park Road
Jacksonville, Arkansas 72076
(501) 985-1172
DATE: August 13, 2008
Supercedes: September, 2006 Prepared by: POLOPLAZ Technical Staff
SECTION I: PRODUCT IDENTIFICATION
PRODUCT NAME: PoloPlaz Zenith (Natural Matte)
PRODUCT CLASS: Water Based Polyurethane/Acrylic Floor Finish
SECTION II: HAZARDOUS INGREDIENTS
Ingredient CAS # Exposure Limits LD50, Route,
Weight SARA Vapor
Percent Title III Pressure Species
(mmHg)
1-Methyl-2- 872-50-4 1-5% 311/31 0.29 TLV/ACGIH: 100 4150 mg/kg (orl-rat)
pyrrolidone 2/313 NIOSH: none listed 7000 mg/kg (skn-
rat)
Dipropylene glycol 34590- 1-5% 311/31 0.40 100 ppm TWA (ACGIH 1991- 5135 mg/kg (orl-rat)
methyl ether 94-8 2/313 92) 9500 mg/kg (drm-
rbt)
Dipropylene glycol 29911- 1-5% N/A 0.1 None listed 3700 mg/kg (orl-rat)
butyl ether 28-2 2160 mg/kg (orl-
mse)
5157 mg/kg (skn-
rbt)
N,N- 121-44-8 1-5% 311/31 400 OSHA PEL: 25 ppm(100 450 mg/kg (orl-rat)
Diethylethanamine 2/313 mg/m3) 570 ul/kg (skin-rbt)
(TWA)-ACGIH (TLV):
1 ppm (TWA)skin
3 ppm (STEL) skin
Amorphous Silica 7631-86- 1-4% none OSHA-PEL: 80mg/m3
9
HMIS?Rating HEALTH: 1 FLAMMABILITY: 1 REACTIVITY: 0
CALIFORNIA PROPOSITION 65: This product contains no known chemicals known to the State of California to
cause cancer or reproductive toxicity.
DOT SHIPPING NAME: Paint, Non Hazardous (NA1263)
DOT DRUM LABEL: None
SECTION III: HAZARDS IDENTIFICATION
THRESHOLD LIMIT VALUE: N/A
ACUTE HAZARDS
EYE & SKIN CONTACT: Primary irritation to skin, defatting, dermatitis. Absorption through skin increases
exposure. Primary irritation to eyes includes; redness, tearing, blurred vision. Liquid can cause eye irritation.
Wash thoroughly after handling.
INHALATION: Anesthetic. Irritates respiratory tract. Acute overexposure can cause serious nervous system
depression. Vapor harmful. Breathing vapor can cause irritation. Acute overexposure can cause damage to
kidneys, blood, nerves, liver &lungs.
SWALLOWING: Swallowing can cause abdominal irritation, nausea, vomiting, & diarrhea.
SUBCHRONIC HAZARDS/CONDITIONS AGGRAVATED: Absorption thro skin may be harmful. Chronic
overexposure can cause damage to kidneys, blood, nerves, liver & lungs. Persons with severe skin, liver, heart,
lung, or kidney problems should avoid use.
CANCER HAZARD: This product has no carcinogens listed by IARC,NTP, NIOSH, OSHA, or ACGIH, as of this
date, greater than or
equal to 0.1%.
SECTION IV: FIRST AID MEASURES
EYE CONTACT: Immediately flush with plenty of water for 15minutes & call a physician.
SKIN CONTACT: In case of contact with skin, wash thoroughly with soap and water. Remove & wash
contaminated clothing before reuse. (Discard contaminated shoes.)
INHALATION: Remove victim to fresh air. If breathing is difficult, give oxygen. If breathing has stopped, give
artificial respiration. Call a physician immediately.
SWALLOWING: Call a Physician immediately. Induce vomiting promptly using Physician's instructions. Never
give anything by mouth to an unconscious person.
SECTION V: FIRE FIGHTING MEASURES & DATA
LOWER FLAMMABLE LIMIT IN AIR (% BY VOLUME): 1.1 (Lowest component)
FLASH POINT (TEST METHOD): None
EXTINGUISHING MEDIA: Use carbon dioxide or foam extinguishers.
SPECIAL FIRE FIGHTING PROCEDURES: Water vapor may be ineffective on fire but can protect fire fighters &
cool closed containers. Use fog nozzles if water is used. Do not enter confined fire-space without full bunker gear
(helmet with face shield, bunker coats, gloves & rubber boots). Use NIOSH approved positive pressure, self-
contained breathing apparatus.
SECTION VI: ACCIDENTAL RELEASE MEASURES
SPILL OR LEAK PROCEDURES: Stop spill at source. Dike area &contain. Clean up remainder with absorbent
materials. Dispose of collected materials according to Federal, State, & Local Regulations. WASTE DISPOSAL
METHOD: Recycle or dispose of observing Federal, State, & Local Regulations. If questions exist, contact the
proper agencies.
SECTION VII: HANDLING & STORAGE
HANDLING: Use only with adequate ventilation. Avoid prolonged or repeated breathing of vapor or spray mist.
Do not get in eyes, on skin or clothing. Wear OSHA standard goggles or face shield. Consult Safety equipment
supplier. Wear gloves, apron & footwear impervious to this material. Wash clothing before reuse.
STORAGE: Keep container tightly closed & upright when not in use to prevent leakage. Ground containers when
transferring. Do not flame cut, braze, or weld. Empty container very hazardous! Continue all label precautions.
Isolate from oxidizers, heat & open flame.
SECTION VIII: EXPOSURE CONTROLS & PERSONAL PROTECTION
EXPOSURE CONTROLS: If engineering controls do not maintain airborne concentrations below recommended
exposure limits, an approved respirator must be worn. Respirator type: organic vapor. If respirators are used, a
program should be instituted to assure compliance with OSHA Standard 29 CFR 1910.134.
VENTILATION: Use local, general & mechanical exhaust necessary to keep vapor levels below TLV.
PERSONAL PROTECTION: Wear OSHA Standard goggles or face shield. Consult Safety Equipment Supplier.
Wear gloves, apron & footwear impervious to this material. Wash clothing before reuse.
SECTION IX: PHYSICAL DATA
APPEARANCE: Liquid, white
ODOR: mild
BOILING RANGE: 212-342*F
SPECIFIC GRAVITY: 1.04
POUNDS/GALLON: 8.74
VOC's : 2.06lbs/gall 247.27gms/ltr
VAPOR PRESSURE: 10.6 mm HG @ 20*C
VAPOR DENSITY: .8
% VOLATILE BY VOLUME: 72.12
SECTION X: REACTIVITY DATA
STABILITY: stable
MATERIALS & CONDITIONS TO AVOID: isolate from oxidizers such as permanganates, chromates, &
peroxides, heat, & open flame. Do not allow product to freeze.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide, carbon dioxide from burning.
HAZARDOUS POLYMERIZATION: will not occur
OTHER COMMENTS
The supplier disclaims all expressed or implied warranties of merchantability or fitness for a specific use, with
respect to the product or the information provided herein, except for conformation to contracted specifications. All
information appearing herein is based on data obtained from manufacturers and/or recognized technical sources.
While the information is believed to be accurate, we make no representations as to its accuracy or sufficiency.
Conditions of use are beyond our control, and therefore users are responsible for verifying the data under their
own operating conditions to determine whether the product is suitable for their particular purposes and they
assume all risks of their use, handling, and disposal of the product. Users also assume all risks in regards to the
publication or use of, or reliance upon, information contained herein. Users must have MSDS available in
workplace. This information relates only to the product designated herein, and does not relate to its use in
combination with any other material or in any other process.
|