M a t e r ii a ll S a f e t y D a t a S h e e t
Mater a Safety Data Sheet
UltraFlush
Single Component
MANUFACTURER Issue Date: February 2002
Elastomer Specialties, Inc. Revised: November 2005
2210 South Highway 69 Revised: January 2006
Wagoner, OK 74467 Revised: July 2009
918-485-2835
1 - Chemical Product Identification
Product Code: 1293
Product Name: UltraFlush Single Component
Chemical Family: Aromatic Sulfonic Ester
Chemical Name: Alkylsulfonic Acid Ester of Phenol
CAS Number: 70775-94-9
2 - Composition / Information on Ingredients - HAZARDOUS INGREDIENTS
INGREDIENT NAME/CAS # EXPOSURE LIMITS CONCENTRATION
This product contains NO hazardous ingredients as defined under the criteria of the Federal OSHA Hazard
Communication Standard 29 CFR 1910.1200.
Other Ingredients:
The following potentially hazardous constituent(s) are contained at levels below OSHA disclosure requirements and are
provided for informational purposes only.
Phenol/108-95-2 OSHA: 5.00 ppm TWA-Skin < 25 ppm
ACGIH: 5.00 ppm TWA-Skin
3 - Hazards Identification:
Emergency Overview: Warning!
Color: Light yellow;
Form: Liquid; Viscous Liquid;
Odor: Odorless; Product poses little or no hazard if spilled and no hazard if spilled and no unusual hazard if involved in a fire.
POTENTIAL HEALTH EFFECTS:
ROUTE(S) OF ENTRY: Inhalation; Skin contact; Eye contact
HUMAN EFFECTS AND SYMPTOMS OF OVER-EXPOSURE:
ACUTE EFFECTS OF EXPOSURE: On the basis of animal toxicity testing, we would expect this product to be
non-irritation to the eyes and skin and essentially non-toxic by ingestion or skin absorption.
CHRONIC EFFECTS OF EXPOSURE: No applicable information was found concerning any adverse chronic health
effects from over-exposure to this product.
CARCINOGENICITY: This product is not listed by NTP, IARC or regulated as a carcinogen by OSHA.
NTP--?- - - - - Not listed
IARC-- - - - - - Not listed
OSHA-- - - - - Not regulated
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None known
EXPOSURE LIMITS: Not established for this product.
4 - First Aid Measures
FIRST AID FOR EYES: Flush with plenty of lukewarm water.
FIRST AID FOR SKIN: Wash affected areas with soap and water.
FIRST AID FOR INHALATION: Remove to fresh air.
FIRST AID FOR INGESTION: Get medical attention.
Elastomer Specialties, Inc. MSDS UltraFlush Page 2
5 - Fire Fighting Measures
FLASH POINT: 410癋 - 464癋 (210癈--240癈) ASTM-D92
FLAMMABLE LIMITS: Upper explosive limit (UEL) (%): Not established
Lower explosive limit (LEL) (%): Not established
AUTO-IGNITION TEMPERATURE: 797癴 (425癈) ASTM-D286
EXTINGUISHING MEDIA: Water; Carbon dioxide; Dry chemical; Foam
SPECIAL FIRE FIGHTING PROCEDURES: Full emergency equipment with self-contained breathing apparatus should
be worn by firefighters. During a fire, irritating and toxic gases and aerosols may be generated by thermal
decomposition and combustion.
6 - Accidental Release Measures
SPILL OR LEAK PROCEDURES: Cover with absorbent material, such as sand, sweeping compound or
diatomaceous earth; collect material and handle as normal waste.
7 - Handling and Storage
STORAGE TEMPERATURE (MIN/MAX): Not established
SHELF LIFE: Approximately 2 years in original, tightly sealed containers.
SPECIAL SENSITIVITY: Excessive heat.
HANDLING/STORAGE PRECAUTIONS: If material is overheated, oxides of sulfur are generated. Store in a cool,
dry place. Keep separated from foods. Keep container closed to prevent contamination. Avoid contact with
eyes, skin and clothing. Avoid breathing vapors. Wash thoroughly after handling.
8 - Personal Protection
EYE PROTECTION REQUIREMENTS: Protective goggles recommended.
SKIN PROTECTION REQIREMENTS: Chemical resistant gloves are recommended.
VENTILATION REQUIREMENTS: Under normal conditions of use, special ventilation is not required.
RESPIRATOR REQUIREMENTS: Under normal conditions of use, respiratory protection is not required.
ADDITIONAL PROTECTIVE MEASURES: Safety showers and eyewash stations should be available.
Educate and train employees in the safe use and handling of this product.
9 - Physical and Chemical Properties
PHYSICAL FORM: Liquid APPEARANCE: Viscous liquid
COLOR: Light yellow ODOR: Odorless
ODOR THRESHOLD: Not applicable pH: Not established
BOILING POINT: Approx. 392癋 (200癈) @ 9.75 mmHg SOLUBILITY IN WATER: Insoluble
MELTING/FREEZING POINT: Less than 5癋 (-15癈)
VISCOSITY: 100 - 130 mPa's @ 68癋 (20癈)
SPECIFIC GRAVITY: Approx. 1.055 @ 68癋 (20癈)
BULK DENSITY: Approx. 8.78 lbs/gal
VAPOR PRESSURE: Less than 0.000075 mmHg @ 68癋 (20癈)
VOC BY WEIGHT: 1.25% (USEPA Method 24)
10 - Stability and Reactivity
STABILITY: This is a stable material
HAZARDOUS POLYMERIZATION: Will not occur.
INCOMPATIBILITIES: None known.
INSTABILITY CONDITIONS: Excessive heat.
DECOMPOSITION TEMPERATURE: 392癋 (200癈)
DECOMPOSITION PRODUCTS: By fire or thermal decomposition: carbon monoxide (CO), carbon dioxide (CO2),
sulfur dioxide and phenol.
11 - Toxicological Information
ACUTE TOXICITY
Oral LD50 Greater than 10 g/kg (Rat).*
Dermal LD50 Greater than 1.0 g/kg (Rat).*
Eye Effects Non-irritating to rabbit eyes.* Revised: November 2005
Skin Effects Non-irritation to rabbit skin.* Revised: January 2006
Revised: July 2009
Testing conducted at the Institute of Toxicology, Bayer AG.
2210 South Highway 69, Wagoner, OK 74467 * 918-485-2835 * Fax 918-485-2856 * www.elastomer.com / www.gatorhyde.com
Elastomer Specialties, Inc. MSDS UltraFlush Page 3
12 - Ecological Information
FISH TOXICITY LC0 = 100 mg/L (96 h, Brachydanio rerio).*
BIOLOGICAL ELIMINATION 31% after 28 days (MITI-test, variation Painter).*
INHIBITION BACTERIA EC50 greater than 10000 mg/L (activated sludge micro-organism).*
PLANT TOXICITY No harmful effect at saturation concentration (96 h, scenedesmus subs).*
* Tests conducted at the Institute for Toxicology, Bayer AG.
13 - Disposal Considerations
WASTE DISPOSAL METHOD: Waste may be incinerated or disposed of in compliance with federal, state or local
environmental control regulations.
14 - Transportation Information
TECHNICAL SHIPPING NAME Aromatic Sulfonic Ester
FREIGHT CLASS BULK Chemicals, NOI
FREIGHT CLASS PACKAGE Chemical, NOI (NMFC 60000)
PRODUCT LABEL Product Label Established
DOT (Domestic Surface): HAZARD CLASS OR DIVISION Non-Regulated
IMO / IMDG code (Ocean): HAZARD CLASS DIVISION NUMBER Non-Regulated
ICAO / IATA (Air): HAZARD CLASS DIVISION NUMBER Non-Regulated
HARMONIZED SYSTEM TARIFF #: HS# 3812.20.1000
15 - Regulatory Information
OSHA STATUS: This product is not hazardous under the criteria of the Federal OSHA
Hazard Communication Standard 29 CFR 1910.1200.
TSCA STATUS: On TSCA Inventory
CERCLA REPORTABLE QUANTITY: None
SARA TITLE III: SECTION 302 EXTREMELY: HAZARDOUS SUBSTANCES: None
SECTION 311/312: HAZARD CATEGORIES: Non-hazardous under Section 311/312
SECTION 313: TOXIC CHEMICALS: None
RCRA STATUS: If discarded in its purchased form, this product would not be a hazardous waste either by listing or
by characteristic. However, under RCRA, it is the responsibility of the product user to determine at the time of disposal,
whether a material containing the product or derived from the product should be classified as a hazardous waste. (40
CFR 261.20-24). FOREIGN CHEMICAL INVENTORY LIST (S): Canada DSL: Listed
The following chemicals are specifically listed by individual states; other product specific health and safety data in other
sections of the MSDS may also be applicable for state requirements. For details on your regulatory requirements you
should contact the appropriate agency in your state.
I
COMPONENT NAME
/CAS NUMBER CONCENTRATION STATE CODE
Alkylsulfonic Acid Ester of Phenol / 70775-94-9 100.000 % PA3, NJ4
Phenol / 108-95-2 < 25 ppm MA, NJ3
MA = Massachusetts Hazardous Substance List
NJ3 = New Jersey Special Health Hazardous Substance List
NJ4 = New Jersey Other--included in 5 predominant ingredients > 1%
PA3 = Pennsylvania Non-hazardous present at 3% or greater.
CALIFORNIA PROPOSITION 65: To the best of our knowledge, this product contains no levels of listed substances, which the
state of California has found to cause cancer, birth defects or other reproductive effects.
17 - Other Information
HMIS RATINGS: Health Flammability Reactivity
0 1 0
0 = Minimal 1 = slight 2 = Moderate 3 = Serious 4 = Severe
Elastomer Specialties' method of hazard communication is comprised of Product Labels and Material Safety Data Sheets. HMIS and
NFPA ratings are provided by Elastomer Specialties, Inc. as a customer service.
This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of
Elastomer Specialties, Inc. The data on this sheet relates only to the specific material designated herein. Elastomer
Revised: November 2005
Specialties, Inc. assumes no legal responsibility for use or reliance upon this data.
Revised: January 2006
Revised: July 2009
2210 South Highway 69, Wagoner, OK 74467 * 918-485-2835 * Fax 918-485-2856 * www.elastomer.com / www.gatorhyde.com
|