MATERIAL SAFETY DATA SHEET
PREMIER INDUSTRIAL SUPPLY, INC.
Product Name: XTRABOND 50 SILICONIZED ACRYLIC LATEX SEALANT
Date Issued: March 3, 2006
Company Identification & Chemical Product
1.
Product Brand Name: XtraBond 50 Siliconized Acrylic Latex Sealant
Product Use: Sealant & Adhesive
Proper DOT Shipping: Caulking & Glaziers, NOI
DOT Hazard Classification: NONE
Company Contact Information Emergency Telephone Number
Premier Industrial Supply, Inc. CHEMTREC: 800-424-9300 (24 hours)
1833 W. Calle De Pompas Telephone: 866-512-4583
Phoenix, AZ 85085
2. Information on Ingredients
CHEMICAL NAME CAS NUMBER WEIGHT %
Calcium Carbonate 471-34-1 <40
Vinyl Acetate/acrylic
CoPolymer Proprietary <10
Phthalate Plasticiizer Proprietary <10
Acrylic Resin Proprietary <6
Stoddard Solvent 8052-41-3 <5
Ethylene Glycol 107-21-1 <1
3. Hazards Identification
HEALTH HAZARDS:
The principle volatile component is water. Minor volatile components from the
emulsion may cause headaches and nausea. Prolonged and repeated skin contact
can cause irritation. Treatment of overexposure should be directed at the control
of symptoms and clinical condition.
CAUTION: Can cause skin & eye irritation
SYMPTOMS OF EXPOSURE
Inhalation: Trace component and residual monomer may cause headache,
nausea, and irritation of the nose, throat, and lungs in poorly
ventilated areas..
Eye Contact: Can cause eye irritation with direct contact. Symptoms
include stinging, tearing, redness and swelling of eyes.
Skin Contact: No significant effects expected from a single short term
exposure..
1
Ingestion: There are no known symptoms of ingestion..
Symptoms of Over exposure: No known applicable information.
The above listed potential effects are based on actual data, results of studies
performed upon similar compositions, component data and/or expert review of
the product. Please refer to Section 11 for detailed toxicology information.
FIRST AID MEASURES
4.
Inhalation: Remove subject to fresh air. Get Medical attention if ill effects
persist
Eye Contact: Immediately flush eyes with copious amounts of water
Skin Contact: Immediately wash affected areas with large amounts of soap
& water. Continue for 15 minutes. Get Medical attention if
irritation develops.
Ingestion: Do not induce vomiting or give anything by mouth. Get
immediate medical attention.
5. FIRE FIGHTING MEASURES
Flash Point & Method......................Not Determined
GENERAL HAZARD:
Not Determined
EXTINGUISHING MEDIA
On large fires use dry chemical, foam or water spray. On small fires
use carbon dioxide, dry chemicals or water spray. Water can be
utilized to cool containers exposed to fires.
FLAMMABLITY: TDGR Class
Sensitivity to impact
Sensitivity to static discharge
SPECIAL FIREFIGHTIN INSTRUCTIONS
Non-flammable (aqueous emulsion). After water evaporates,
remaining material will no burn. Breathing apparatus required when
fighting fires in enclosed area.
UNUSUAL FIRE or EXPLOSION HAZARDS
Product will not burn, but may splatter if temperature exceed boiling
point of water. Dried solids can burn, giving off oxides of carbon.
2
6. ACCIDENTAL RELEASE MEASURES
Containment/Clean Up: Observe all personal protective equipment
recommendations as described in section 8. Scrape all spilled materials for
disposal. This material is not classified as a hazardous waste per 40 CFR 261.
State and local laws may impose regulatory restrictions.
7. HANDLING AND STORAGE
Personal Pre Cautionary Measures: Avoid Breathing vapors in top of
shipping containers. Keep containers closed. Use with adequate ventilation.
Avoid contact with skin and clothing. Wash thoroughly after handling. Observe
all PPE Suggestions in section 8.
Storage: Store in a cool dry place. Protect from freezing and excessive heat.
8. EXPOSURE CONTROLS & PERSONAL PROTECTION
PERSONAL PROTECTIONS
Ventilation: Local and General Ventilation are recommended
Respiratory Protection: Use respiratory protection unless adequate exhaust
ventilation is provided or exposure assessment demonstrates
that exposures are within exposure guidelines. Industrial
Hygiene Personnel can assist in judging the adequacy of
existing engineering controls.
Suitable Respirator: General and local exhaust ventilation is recommended to
maintain vapor exposures below recommended limits. Where
concentrations are above recommended limits as determined
by air sampling or are unknown, appropriate respiratory
protection should be worn. Follow OSHA Respirator
Regulations (29 CFR 1910.134) and use NIOSH/MSHA
approved respirators..
Eye Production: Wear safety glasses with side shields as a minimum
Skin Protection: Impervious gloves are suggested. Wash at mealtimes and end
of shift.
Gloves: Nitrile Gloves
Clothes: Wear clothing that will protect the skin from exposure to this
chemical.
Note: These precautions are for room temperature handling.
ENGINEERING CONTROLS
Use local exhaust or general dilution ventilation system.
3
9. PHYSICAL & CHEMICAL PROPERTIES
VOC Content: 50 grams/liter PH: 7.85
Boiling Point: 100c Water Solubility: Slightly Soluble
Vapor Density: Lighter than Air Freeze Point: 0c
Odor: Slight Odor State: Paste
Color: Various Specific Gravity: 1.66
Melting Point: 0c Reactivity to Water: Incompatible
The above information is not intended for use in preparing product
specifications.
10. STABILITY AND REACTITY
INCOMPATIBILITIES:
Oxidizing can cause a reaction
STABILITY:
Stable
HAZARDOUS DECOMPOSITION PRODUCTS:
Will not occur
11. ECOLOGICAL INFORMATION
FOR PRODUCT
Not Established
12. DISPOSAL CONSIDERATIONS
RCRA WASTE CODE
Not regulated as a hazardous waste per 40 CFR 261. Observed all applicable
federal, state, and local regulations. Material is not classified as a hazardous
waste per 40 CFR 261.
WASTE DISPOSAL METHOD
We make no guarantee or warranty of any kind that the use or disposal of this
product complies with all local, state, or federal laws. It is also the obligation
of each user of the product mentioned herein to determine and comply with the
requirements of all applicable statues
4
13. TRANSPORT INFORMATION
Marine Transport
None
DOT (usa):
Caulking & Glaziers, NOI
DOT Hazard Classification:
None
UN/NA Number:
Not Applicable
Label Required:
None
15. REGULARTORY INFORMATION
The contents of this MSDS comply with OSHA Hazard Communication
Standard 29 CFR 1910.1200
SARA (302)
CHEMICAL NAME TPQ (lbs) RQ (lbs)/ (kg)
N/A N/A N/A
SARA (304)
CHEMICAL NAME CASE # %
N/A N/A N/A
SARA HAZARD CATEGORIES (312)
YES Acute NO Chronic NO Fire NO Pressure NO Reactive
INVENTORY STATUS
The ingredients of this chemical are listed on the US TSCA Chemical Substance
Inventory Substance Inventory.
TOXIC SUBSTANCE CONTROL ACT:
No specific regulation apply
STATE REGULATION
California Proposition 65: None Known
This chemical contains the following listed by the state of California under the
safe Drinking Water and Toxic Enforcement Act of 1986 as being known to
cause cancer, birth defects and reproductive harm.
5
16. OTHER INFORMATION
Disclaimer: The opinions expressed herein are those of qualified experts
within Premier Industrial Supply Inc. We believe the information contained
herein is current as the date of this MSDS. Since the use of the product is not
within the control of Premier Industrial Supply Inc. it is the user's obligation to
determine the conditions of safe use.
PREPARED BY: Premier Industrial Supply Inc.
MSDS #: XTRABOND50
DATE PREPARED: March 3, 2006
DATE ISSUED: March, 2006
6
|