MATERIAL SAFETY DATA SHEET
Fire
1
1 0
Reactivity
Health
--
Special
NFPA 704 DESIGNATION HAZARD RATING
Issue Date: 1/05 Supersedes: 5/04 4 = Extreme 3 = High 2 = Moderate
1 = Slight 0 = Insignificant
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
PRODUCT IDENTITY: WEARCOATTM
PRODUCT USE: Abrasion Resistant Coating
Sealoflex?Inc.
MANUFACTURED BY:
2520 Oscar Johnson Drive CHEMTREC
Charleston, SC 29405 1-800-424-9300
PHONE: 843 554-6466 FAX: 843 554-6458
2. COMPOSITION & INFORMATION ON INGREDIENTS
SARA Title III CARCINOGENICITY State Right-To-Know
Component % weight CAS # Section 313 RCRA (As per 29CFR 1910.1200) PA NJ MA
Acrylic Polymer 20.0 ?25.0 Proprietary Not Listed No No No No No
Pigments, Fillers & 31.0 ?35.0 N.A. Not Listed No No No No
Extenders
Ethylene Glycol 1.0 ?3.0 107-21-1 Listed No No No No No
Glycol Ether 1.5 ?3.5 111-77-3 Listed No No Yes Yes Yes
Water 75.0 ?40.0 7732-18-5 Not Listed No No No No No
Additives <2.0 N.A. Not Listed No No No No No
All components are listed in the TSCA inventory.
3. PHYSICAL AND CHEMICAL PROPERTIES
Physical State Bulk Density
Various Colors Viscous Liquid No Data
Odor Vapor Pressure
Mild Acrylic/Ammonia No Data
Odor Threshold Vapor Density
Not Applicable Heavier than Air
Molecular Formula Evaporation Rate (n-Butyl Acetate=1)
No Data <1
Molecular Weight VOC content
No Data < 6.0%
Boiling Point % Volatiles
~100癈 (~212癋) 40 ?45
Freezing Point Solubility in Water
~0癈 (~32癋) Miscible
Specific Gravity Viscosity (cps)
1.31 4,000 ?6,000
Density (lbs/gal) pH
10.9 9.0 - 9.5
4. STABILITY & REACTIVITY
GENERAL: This product is stable under normal conditions
CONDITIONS TO AVOID: Avoid contamination with acidic materials.
INCOMPATIBLE MATERIAL: Acidic materials, anhydrides and strong oxidizers.
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Oxides of carbon.
PRODUCT IDENTITY: WearcoatTM PAGE 2 OF 3
5. HAZARDS IDENTIFICATION
POTENTIAL HEALTH EFFECTS:
EYE CONTACT: Eye irritant. If irritation persists, seek medical attention.
SKIN CONTACT: Repeated or prolonged exposure may induce skin irritation.
INGESTION: Ingestion will cause moderate to severe irritation or chemical burns to the gastrointestinal tract. Injury may
be severe and cause death. Acute oral toxicity is LD50 3038 mg/Kg.
INHALATION: Exposure to high concentrations of vapor or mists may cause moderate to severe irritation of respiratory
tract.
6. FIRST AID MEASURES
EYE CONTACT: Immediately flush eyes with plenty of clean running water for at least 15 minutes. Seek immediate medical
attention. Continue flushing eyes until medical attention arrives.
SKIN CONTACT: Immediately flush skin with plenty of clean running water while removing contaminated clothing. Continue
for at least 15 minutes. Seek medical attention.
INHALATION: Immediately move to fresh air. Seek immediate medical attention if ill effects occur.
INGESTION: DO NOT induce vomiting. Seek immediate medical attention. Give one or two glasses of water to drink and
refer to medical personnel or take direction from a physician or poison control center. Never give anything
by mouth to an unconscious person.
7. FIRE FIGHTING MEASURES
GENERAL: This material is not flammable. Increased temperature may increase pressure in closed container resulting in
rupture, spreading fire and increasing risk of injury.
FLASHPOINT AND METHOD: >200癋 (PMCC)
FLAMMABLE LIMITS: Lower: No Data Upper: No Data
AUTOIGNITION TEMPERATURE: No Data
HAZARDOUS COMBUSTION PRODUCTS: Oxides of carbon and nitrogen.
EXTINGUISHING MEDIA: Foam, CO2, dry powder, water spray.
FIRE FIGHTING INSTRUCTIONS: Wear self-contained breathing apparatus with full facepiece and protective
clothing.
UNUSUAL FIRE AND EXPLOSION HAZARDS: None known.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
CONTROL MEASURES: No ACGIH TLV or OSHA PEL assigned to this product. Minimize exposure in accordance with good
hygiene practice.
RECOMMENDED PERSONAL PROTECTIVE EQUIPMENT:
RESPIRATOR: If needed, use NIOSH approved respirator for organic vapors mists or fumes.
EYES: Chemical splash goggles and full face shield.
GLOVES: Rubber or Neoprene.
CLOTHING: Rubber or neoprene apron.
FOOTWEAR: Impervious boots.
OTHER: Eye wash station and safety shower should be available in the work area.
PRODUCT IDENTITY: WearcoatTM PAGE 3 OF 3
9. HANDLING AND STORAGE
STORAGE TEMPERATURE: 4 - 32癈 (40 - 90癋) STORAGE PRESSURE: Ambient
STORAGE: Keep container tightly closed. Store in a cool well ventilated area away from heat, sources of ignition, direct
sunlight and acidic materials, anhydrides and oxidizing agents.
HANDLING: Open in a well ventilated area. Avoid breathing vapors. Prevent skin and eye contact. Empty containers should
be thoroughly rinsed with water and disposed of according to local regulations.
10. ACCIDENTAL RELEASE MEASURES
SMALL SPILL: Eliminate all ignition sources (flares, flames, pilot lights, electrical sparks). Wearing recommended protective
clothing, dike spill using soil, sand or compatible commercial absorbent. Pick up bulk of product using pumps
or vacuum truck or absorb product in sand or commercial absorbent. Place in chemical waste containers for
recovery or disposal.
LARGE SPILL: Eliminate all ignition sources. Persons not wearing protective equipment should be excluded from the spill
area until clean up has been completed. Stop spill at source. Prevent from entering drains, sewers, streams
or other bodies of water. Prevent from spreading. If run-off occurs, notify authorities as required. Pump or
vacuum-transfer spilled product to clean containers for recovery. Absorb unrecoverable product. Transfer
contaminated absorbent soil and other material to containers for disposal. Ensure that all local, State and
Federal regulations are complied with for release reporting, recovery and disposal of material and containers.
11. DISPOSAL CONSIDERATIONS
RCRA 40 CFR 261 CLASSIFICATION: Not Classified
U.S. EPA WASTE NUMBER/DESCRIPTION: None
DISPOPSAL METHOD: Incinerate in an approved facility. Do not incinerate closed containers. Dilute with clean, low
viscosity fuel. Untreated material should not be released to the environment.
CONTAINER DISPOSAL: Empty container retains potentially hazardous residue. Observe all hazard precautions. Remove all
product residue from container and puncture or otherwise destroy empty container before disposal.
12. TRANSPORTATION INFORMATION
DOT INFORMATION ?49 CFR 172.101
DESCRIPTION: Not regulated as a hazardous material.
CONTAINER MODE: One-gallon and five-gallon plastic pails
NOS COMPONENT: N.A.
This Material Safety Data Sheet is provided as an information resource only. It should not be taken as a warranty or representation for which
Sealoflex?Inc. assumes legal responsibility. While Sealoflex?Inc. believes the information contained herein is accurate and compiled from
sources believed to be reliable, it is the responsibility of the user to investigate and verify its validity. The buyer assumes all responsibility of
using and handling the product in accordance with applicable federal, state and local regulations.
|