MATERIAL SAFETY DATA SHEET
SECTION 1
Material Identification and Use
LTP 2 ENVIRO-KOTE PART B
Material Name/Identifier:
Manufacturer's Name: LT Coatings
122 Saunders Rd.
Barrie Ontaio
Tel: 705.725.5455
Fax: 705.728.0334
Material Use: Metal
SECTION 2
Hazardous Ingredients/Information
Hazardous Ingredients % CASNA Exposure Limits Vapor Pressure
<1 mm 65 oF-18oC
Methyl Alcohol <2.0 67561 200ppm TLV
HMIS Code NFPA
Health 1 Health 1
Flammability 3 Flammability 3
Reactivity 0 Reactivity 0
Personal Protection H Personal Protection H
SECTION 3
Physical/Chemical Characteristics
Physical State: Liquid, Clear Melting Point: N/A
Boiling Point: Not Determined Specific Gravity: 0.94
Evaporation Rate: Slower than Ether % Solid by Weight: 98
Vapor Density: Not Determined % Solid by Volume: 99
Weight Per Gallon: 7.84 lbs VOC: <0.1 lb/gal
<12 gm/ltr
Combined 3 parts A and 1 part B:
% Solids by Weight: 25
% Solids by Volume: 22
Weight per gallon: 8.22 lbs
VOC: 2.8 lb/gal
336 gm/ltr
SECTION 4
Fire & Explosion Hazard Data
DOT Category: Flammable
47oF CC
Flash Point:
Extinguishing Media: CO2, Dry Chemical, Water Fog
Unusual Fire and Explosion Hazards: None
Special Fire Fighting Procedures: None
SECTION 5
Health Hazard Data
Threshold Limit Value: Refer to Section 2
Primary Routes of Entry: Inhalation, Skin Absorption
Effects of Over-Exposure:
To Vapors: Concentrated vapors may be harmful
Acute: May cause irritation
Chronic: None known
Emergency First Aid Procedures:
Inhalation: Provide fresh air and rest. Consult physician if ill effects persist.
Skin Contact: Wash with mild soap and water
Eye Contact: Wash with gentle stream of water for at least 15 minutes and
seek medical attention
Ingestion: Consult a physician immediately. May cause blindness or death.
If conscious, induce vomiting. Cover eyes to exclude light.
Treat same a s methyl alcohol poisoning.
SECTION 6
Reactivity Data
Stability: Stable
Conditions to Avoid: None known
Hazardous Decomposition of Product: Normal combustion product including CO 2, CO of N2
Hazardous Polymerization: Will not occur
SECTION 7
Spill or Leak Procedures
Steps to be taken if material is released or spilled:
Remove all sources of ignition
Provide adequate ventilation
Treat area with an absorbing compound
Waste disposal method:
Dispose in accordance with local, state and federal regulations
SECTION 8
Special Protection Information
Respiratory Protection: If exposure to spray mist, wear NIOSH approved respirator
Ventilation: Local ventilation to keep air supply above threshold limit values
Protective Gloves: Solvent resistant gloves
Eye Protection: Safety goggles
Other Protection: No special requirements
Hygienic Work Practices: Remove and wash contaminated cloth before reuse
SECTION 9
Special Precautions
Precaution to be take in handling and storing:
Do not store over 120 oF
Keep container tightly closed and store away from heat, sparks, water and moisture
SECTION 10
Preparation Date of MSDS
Sources Used:
Prepared By:
Harry Laur
Phone Number: 705.725.5455
Date: December 19, 2005
|