FPG-YE
* May 23, 2000
Material Safety Data Sheet
1. Identification of the product and of the company/undertaking:
1.1. Identification of the product:
Pigment Ink, FPG-YE
1.2. Company/undertaking identification
Manufacture's name: Roland DG Corporation
Address: 1-6-4 Shinmiyakoda Hamamatsu-shi
Shizuoka 431-2103
JAPAN
Phone: + 81-53-484-1224
Fax: + 81-53-484-1221
2. Composition/information on ingredients
Ingredients: Company Secret
(Mixture: water-soluble ink)
3. Hazards identification
No hazardous classification according to Council Directive 88/379/EEC
4. First-aid measures
Swallowed: First immediately rinse out mouth several times
with water. Then drink 2-3 glasses of water. Give
nothing by mouth to an unconscious person. Rest
quietly in bed. Seek medical advice immediately.
Eye: Immediately flush eyes with plenty of water,
occasionally lifting the upper and lower lids. Contact
lenses must be removed. Seek medical advice.
Skin: If exposures is excessive, immediately remove all
contaminated clothing in contact with the affected
skin areas. Wash affected skin areas with soap
and water. If symptoms such as irritation persist,
seek medical advice.
Inhaled: If the person breaths in a large amount of vapor,
move the exposed the person to an area with
fresh air. Seek medical advice immediately.
1/3
FPG-YE
* May 23, 2000
5. Fire-fighting measures
Flammability: None
Suitable extinguishing media: Dry Chemical, carbon dioxide.
6. Accidental release measures
If spilt, use sponge to wipe up the ink. Place it in closed container for proper disposal.
During working for clean up, put on rubber gloves and goggle to avoid contacting
ink to skin and eyes.
7. Handling and storage
7.1. Handling
Under normal circumastances, ink will not come out of the cartridges.
If ink gets into your eyes or on your skin, see 4.First -aid measures.
Do not shake an ink cartridge; this can cause leakage. Do not dismantle the cartridge.
Keep ink cartridges out of the reach of children. Do not drink ink.
7.2. Storage
Do not leave ink cartridges in high temperature and high humidity.
Do not expose directly to the sun.
8. Exposure controls/person protection
Exposure standards: None
Engineering controls: Not applicable
Personal protection: None required when used as intended in Roland equipment.
9. Physical and chemical properties
Appearance Yellow liquid
Odor: No odor
pH: Approximately 9 at room temperature
Boiling point: No data available
Melting point: No data available
Not detected until 110
Flashing point:
Autoflammability: None
Explosive properties: None
Oxidizing properties: None
Vapor pressure: No data available
Relative density: No data available
Solubility in water:
Solubility in fat: No data available
Partition coefficient: No data available
less than 5 mPa s
Viscosity: at room temperature
2/3
FPG-YE
* May 23, 2000
10. Stability and reactivity
Stability: Stable
Hazardous polymerization: Will not occur
Hazardous decomposition products: No data available
11. Toxicological information *Based on toxicology data of chemically similar material.
Acute toxicity:
2,000mg/kg (Rats)*
Oral LD50:
2,000mg/kg (Rats)*
Dermal LD50:
Irritation:
Skin: Non-irritating (Rabbit skin)*
Eye: Non-irritating (Rabbit eye)*
Skin sensitization: Non-sensitizing (Albino Guinea pig)*
Mutagenicity: None (by Ames assay)*
12. Ecological information
No data available
13. Disposal considerations
Dispose of in accordance with federal, state and local regulations.
14. Transport information
No hazardous classification
15. Regulatory information
-
16. Other information
-
3/3
|