SRW Paver Seal Pro 鈥? High Gloss
MATERIAL SAFETY DATA SHEET
MSDS Name: SRW Paver Seal Pro - High Gloss
MSDS Number: SC108
MSDS Revision Date: 06-22-06
Page Number: 1 of 3
GENERAL INFORMATION
PRODUCT IDENTIFICATION: SRW Paver Seal Pro 鈥? High Gloss
VOC CONTENT: 188 GRAMS/LITER OR 1.57 #/GAL.
CATEGORY: CURE AND SEAL
COMMON NAME: VINYLTOLUENE ACRYLATE EMULSION
DOT SHIPPING NAME: IN CONTAINER LESS THAN 119 GALS AND GREATER THAN 119 GALS.:
SRW Paver Seal Pro 鈥? High Gloss (NON-REGULATED)
HEALTH AND SAFETY: THIS PRODUCT IS AN ORGANIC LIQUID AND WATER EMULSION. PER NFPA 30 THIS
MIXTURE WITH A FLASH POINT GREATER THAN 200 F IS A CLASS III B COMBUSTIBLE LIQUID. ALL
PRECAUTIONS PROVIDED ARE FOR THE ORGANIC LIQUID PORTION OF WHICH THIS PRODUCT MAY CONTAIN AS
LITTLE AS 5%. USE WITH ADEQUATE VENTILATION. DO NOT INDUCE VOMITING IF SWALLOWED. USE OF SOLVENT
RESISTANT GLOVES, GOGGLES AND OTHER PROTECTIVE CLOTHING IS ADVISED WHEN HANDLING THIS PRODUCT.
KEEP FROM FREEZING.
SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name: SRW Paver Seal Pro 鈥? High Gloss
CAS Number: none
HMIS Hazard Rating: Health: 1 Fire: 1 Reactivity: 0
Company Identification: SRW Products 鈥? Princeton, MN
Contact: SRW Products
Telephone/Fax: (800)752-9326 鈥? (763)389-2725
Emergency Phone (24 Hr:): (614) 445-1300
Chemtrec (24 Hour): (800) 424-9300
Chemtrec International: (703) 527-3887
Product Class Solvent based
Product Use: Masonry Cure and Seal
Product Code: 53102
Division: CS108
-----------------------------------------------------------------------------
SECTION II HAZARDOUS INGREDIENTS
-----------------------------------------------------------------------------
MATERIAL OR COMPONENTS CAS. NO. % HAZARD DATA UN#
VINYLTOLUENE ACRYLATE POLYMER 25085-34-1 30% ND
ODORLESS MINERAL SPIRITS 64741-86-7 10% TLV 100 PPM 1255
REMAINDER WATER NA
----------------------------------------------------------------------------
SECTION III PHYSICAL/CHEMICAL CHARACTERISTICS
----------------------------------------------------------------------------
BOILING POINT, 212掳F MELTING POINT: N/A
SPECIFIC GRAVITY (H2O=1): 0.9784
VAPOR PRESSURE: 2.00 mm Hg
VAPOR DENSITY (AIR=1): GREATER THAN AIR
SOLUBILITY IN H20 BY WT: 100%
EVAPORATION RATE (ETHER =1): 9.5 LESS THAN
% VOLATILES BY VOL: 78% PH (AS IS): 7-8 PH (1% SOLN): ND
APPEARANCE AND ODOR: MILKY WHITE EMULSION WITH AROMATIC ODOR (MAY CONTAIN FUGITIVE DYE)
------------------------------------------------------------------------
SRW Paver Seal Pro 鈥? High Gloss
MATERIAL SAFETY DATA SHEET
MSDS Name: SRW Paver Seal Pro - High Gloss
MSDS Number: SC108
MSDS Revision Date: 06-22-06
Page Number: 2 of 3
SECTION IV FIRE AND EXPLOSION HAZARD
-------------------------------------------------------------------------
FLASH POINT: (TEST METHOD) >200掳 F TCC
AUTOIGNITION TEMP: N.D.
FLAMMABLE LIMITS IN AIR, % BY VOL:
LOWER: N.D. UPPER: N.D.
EXTINGUISHING MEDIA: WATER, FOAM
SPECIAL FIRE FIGHTING PROCEDURES: NONE
UNUSUAL FIRE AND EXPLOSION HAZARD: PRODUCT WILL BURN IF TEMPERATURE EXCEEDS BOILING POINT
WATER MIX. NO UNUSUAL HAZARDS.
-----------------------------------------------------------------------
SECTION V REACTIVITY DATA
------------------------------------------------------------------------
CONDITIONS CONTRIBUTING TO INSTABILITY: THIS PRODUCT IS STABLE
INCOMPATIBILITY: THIS PRODUCT IS INCOMPATIBLE WITH STRONG ACIDS.
HAZARDOUS DECOMPOSITION PRODUCTS: THERMAL DECOMPOSITION IN THE PRESENCE OF AIR YIELDS CARBON
MONOXIDE AND/OR CARBON DIOXIDE.
CONDITIONS CONTRIBUTING TO HAZARDOUS POLYMERIZATION: N/A
-------------------------------------------------------------------------
SECTION VI HEALTH HAZARD INFORMATION
-------------------------------------------------------------------------
HEALTH HAZARD DATA HAZARD CLASSIFICATION BASIS FOR CLASSIFICATION SOURCE
ROUTES OF EXPOSURE:
INHALATION: VAPOR INHALATION CAN CAUSE NASAL AND RESPIRATORY IRRITATION, DIZZINESS, WEAKNESS,
FATIGUE, NAUSEA OR HEADACHE.
SKIN CONTACT: PROLONGED OR REPEATED CONTACT CAN RESULT IN MODERATE IRRITATION.
SKIN ABSORPTION: PROLONGED OR REPEATED CONTACT CAN RESULT IN MODERATE IRRITATION.
EYE CONTACT: THIS PRODUCT CAN CAUSE SEVERE IRRITATION.
INGESTION: CAN CAUSE GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING.
EFFECTS OF OVEREXPOSURE: ANESTHESIA, HEADACHE, NAUSEA, DIZZINESS. LIQUIDS MODERATELY IRRITATING
ON SKIN AND EYES.
ACUTE OVEREXPOSURE: PROLONGED CONTACT ON THE SKIN WILL CLAY AND DEFAT THE SKIN POSSIBLY CAUSING
DERMATITIS.
EMERGENCY AND FIRST AID PROCEDURES: EYES: FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES.
CONSULT WITH A PHYSICIAN.
SKIN: IMMEDIATELY WASH SKIN WITH SOAP AND PLENTY OF WATER. IF IRRITATION PERSISTS, CONSULT A
PHYSICIAN.
INHALATION: REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL RESPIRATION, PREFERABLY MOUTH
TO MOUTH. IF BREATHING IS DIFFICULT, GIVE OXYGEN. SEEK PROMPT MEDICAL ATTENTION.
----------------------------------------------------------------------
SRW Paver Seal Pro 鈥? High Gloss
MATERIAL SAFETY DATA SHEET
MSDS Name: SRW Paver Seal Pro - High Gloss
MSDS Number: SC108
MSDS Revision Date: 06-22-06
Page Number: 3 of 3
SECTION VII PRECAUTIONS FOR SAFE
HANDLING AND USE
-----------------------------------------------------------------------
WASTE DISPOSAL METHOD: TREATMENT TRANSPORTATION AND DISPOSAL MUST BE IN COMPLIANCE WITH EPA OR
STATE REGULATIONS UNDER THE RESOURCES CONSERVATION AND RECOVERY ACT. TYPICALLY CONTROLLED
BURNING, INCINERATION OR APPROVED LAND FILL SITES ARE AVAILABLE.
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
ELIMINATE ALL IGNITION SOURCES (FLARES, FLAMES, INCLUDING PILOT LIGHTS, ELECTRICAL SPARKS).
PERSONS NOT WEARING PROTECTIVE EQUIPMENT SHOULD BE EXCLUDED FROM AREA OF SPILL UNTIL CLEAN UP IS
COMPLETE. STOP SPILL AT SOURCE. DIKE SPILL AREA TO PREVENT SPREADING. PUMP LIQUID TO SALVAGE
TANK. REMAINING LIQUID CAN BE TAKEN UP ON SAND, EARTH, FLOOR ABSORBENT, OR OTHER ABSORBENT
MATERIAL AND SHOVELED INTO CONTAINERS.
------------------------------------------------------------------------
SECTION VIII CONTROL MEASURES
--------------------------------------------------------------------------
VENTILATION REQUIREMENTS: LOCAL MECHANICAL VENTILATION MAY BE SUFFICIENT TO KEEP PRODUCT VAPOR
CONCENTRATIONS WITHIN SPECIFIED TIME-WEIGHTED TLV RANGES. IF LOCAL VENTILATION PROVES INADEQUATE
TO MAINTAIN SAFE VAPOR CONCENTRATIONS, SUPPLEMENTAL LOCAL EXHAUST MAY BE REQUIRED. OTHER SPECIAL
PRECAUTIONS SUCH AS RESPIRATORY MASKS OR ENVIRONMENTAL CONTAINMENT DEVICES MAY BE REQUIRED IN
EXTREME CASES.
RESPIRATORY (SPECIFY IN DETAIL): CHEMICAL CARTRIDGE RESPIRATOR: HALF MASK ORGANIC VAPOR
CARTRIDGE: FULL RECOMMENDED TO SAFEGUARD AGAINST POTENTIAL EYE CONTACT: FACE ORGANIC VAPOR
CARTRIDGE IF EYE PROTECTION IS NEEDED.
EYE: CHEMICAL GOGGLES AND/OR FACE SHIELD ARE RECOMMENDED AGAINST IRRITATION OR INJURY.
GLOVES: IMPERVIOUS GLOVES, (CHEMICAL RESISTANT) SUCH AS NEOPRENE, LATEX OR PVA.
OTHER CLOTHING AND EQUIPMENT: TO PREVENT BODY CONTACT, IMPERVIOUS CLOTHING AND BOOTS ARE
RECOMMENDED WHEN WORKING WITH THIS PRODUCT. THE AVAILABILITY OF EYE WASHES AND SAFETY SHOWERS IN
WORK AREAS IS RECOMMENDED.
--------------------------------------
SECTION IX SPECIAL PRECAUTIONS
--------------------------------------
PRECAUTIONARY STATEMENTS: PERSONNEL SHOULD AVOID INHALATION OF VAPORS. PERSONAL CONTACT WITH THE
PRODUCT SHOULD BE AVOIDED. SHOULD CONTACT BE MADE, REMOVE SATURATED APPAREL AND FLUSH AFFECTED
BODY AREAS WITH WATER, CLOTHING MUST BE WASHED/DRIED BEFORE RE-USE. CONTAINERS OF THIS MATERIAL
MAY BE HAZARDOUS WHEN EMPTIED SINCE EMPTIED CONTAINERS RETAIN PRODUCT RESIDUE (VAPOR, LIQUID
AND/OR SOLID). ALL HAZARD PRECAUTIONS GIVEN IN THIS DATA SHEET MUST BE OBSERVED.
OTHER HANDLING AND STORAGE REQUIREMENTS: STORE IN WELL VENTILATED AREA. KEEP CONTAINER TIGHTLY
CLOSED. DO NOT STORE WITH INCOMPATIBLE MATERIALS. STORE IN ACCORDANCE WITH FEDERAL REGULATIONS.
DO NOT STORE OR CONSUME FOOD, DRINK, OR TOBACCO IN AREA WHERE THEY MAY BECOME CONTAMINATED WITH
THIS MATERIAL. KEEP AWAY FROM HIGH TEMPERATURES, OPEN FLAMES, SPARKS, ETC. USE WITH EXPLOSION
PROOF EQUIPMENT IS HIGHLY ADVISABLE.
HMIS HAZARD RATINGS:
NPCA-HMIS NFPA 704 KEY
HEALTH 1 1 4=SEVERE
FLAMMABILITY 1 1 3=SERIOUS
REACTIVITY 0 O 2=MODERATE
1=SLIGHT
0=MINIMAL
ADDITIONAL REGULATORY CONCERNS: (FEDERAL, FDA, USDA, CPSC, STATE, OTHER).
FEDERAL: None FDA: None USDA: None
TSCA: IS THIS PRODUCT, OR ALL ITS INGREDIENTS, BEING CERTIFIED INCLUSION ON THE TOXIC SUBSTANCES
CONTROL ACT INVENTORY OF CHEMICAL SUBSTANCES? YES
THE INFORMATION PROVIDED IN THIS MATERIAL SAFETY DATA SHEET HAS BEEN OBTAINED FROM SOURCES
BELIEVED TO BE RELIABLE. SRW PRODUCTS PROVIDES NO WARRANTIES, EXPRESS OR IMPLIED, AND ASSUMES NO
RESPONSIBILITY FOR THE ACCURACY OR COMPLETMENT OF THE INFORMATION CONTAINED HEREIN.
|