MATERIAL SAFETY 3M
DATA SHEET 3M Center
St. Paul, Minnesota
55144-1000
1-800-364-3577 or (651) 737-6501 (24 hours)
Copyright, 2001, Minnesota Mining and Manufacturing Company.
All rights reserved. Copying and/or downloading of this
information for the purpose of properly utilizing 3M products
is allowed provided that:
1) the information is copied in full with no changes unless
prior agreement is obtained from 3M, and
2) neither the copy nor the original is resold or otherwise
distributed with the intention of earning a profit thereon.
DIVISION: ENGINEERED ADHESIVES
TRADE NAME:
3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
ID NUMBER/U.P.C.:
62-4991-0026-1 - - - 62-4991-0047-7 - - -
62-4991-0930-4 00-21200-31320-2 62-4991-0931-2 - - -
62-4991-4930-0 00-21200-65055-0 62-4991-4935-9 - - -
62-4991-4936-7 00-21200-82242-1 62-4991-4937-5 00-21200-82242-0
62-4991-4938-3 - - - 62-4991-7830-9 00-21200-49157-3
62-4991-8830-8 00-21200-49158-0 62-4991-8835-7 00-21200-49158-9
CS-0406-2031-5 - - - CS-0406-6932-0 - - -
ISSUED: May 24, 2001
SUPERSEDES: April 03, 2001
DOCUMENT: 10-3323-2
-----------------------------------------------------------------------------
1. INGREDIENT C.A.S. NO. PERCENT
-----------------------------------------------------------------------------
DIMETHYL ETHER.......................... 115-10-6 30.0 - 40.0
PENTANE................................. 109-66-0 20.0 - 30.0
NON-VOLATILE COMPONENTS - N.J. TRADE
SECRET (T.S.) REGISTRY NO. 04499600-
5490P ++.............................. TradeSecret 20.0 - 30.0
ACETONE................................. 67-64-1 7.0 - 13.0
NAPHTHOL SPIRITS........................ 64742-48-9 1.0 - 5.0
IN CASE OF EMERGENCY: THE NUMBERS AT THE TOP OF THIS PAGE PROVIDE 24
HOUR RESPONSE FROM ANY PHONE FOR ALL EMERGENCIES WITH THIS PRODUCT.
The components of this product are in compliance with the chemical
notification requirements of TSCA.
++ synthetic polymers, resins, filler, antioxidant, rosin and u.v.
absorber. Not hazardous according to Canadian WHMIS criteria.
Non-WHMIS controlling.
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 2
-----------------------------------------------------------------------------
2. PHYSICAL DATA
-----------------------------------------------------------------------------
BOILING POINT:................. N/A
VAPOR PRESSURE:................ Compressed gas
VAPOR DENSITY:................. > 2.00 Air=1
EVAPORATION RATE:.............. 2.00 Ether=1
SOLUBILITY IN WATER:........... nil
SPECIFIC GRAVITY:.............. 0.725 Water=1
PERCENT VOLATILE:.............. ca. 78 % by wt
pH:............................ N/D
VISCOSITY:..................... N/A
MELTING POINT:................. N/D
APPEARANCE AND ODOR:
liquid in aerosol, orange, sweet/fruity odor.
-----------------------------------------------------------------------------
3. FIRE AND EXPLOSION HAZARD DATA
-----------------------------------------------------------------------------
FLASH POINT:................... -50.00 F TCC
(Propellant)
FLAMMABLE LIMITS - LEL:........ 1.00 % by vol
FLAMMABLE LIMITS - UEL:........ Flammable Gas
AUTOIGNITION TEMPERATURE:...... N/D
EXTINGUISHING MEDIA:
Water spray, Carbon dioxide, Dry chemical, Foam
SPECIAL FIRE FIGHTING PROCEDURES:
Wear full protective clothing, including helmet, self-contained,
positive pressure or pressure demand breathing apparatus, bunker coat
and pants, bands around arms, waist and legs, face mask, and
protective covering for exposed areas of the head. Water may not
effectively extinguish fire; however, it should be used to keep fire-
exposed containers and surfaces cool and prevent explosive rupture.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
Closed containers exposed to heat from fire may build pressure and
explode. Vapors may travel long distances along the ground or floor
to an ignition source and flash back.
NFPA HAZARD CODES: HEALTH: 2 FIRE: 4 REACTIVITY: 1 AEROSOL STORAGE: 2
UNUSUAL REACTION HAZARD: none
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 3
-----------------------------------------------------------------------------
4. REACTIVITY DATA
-----------------------------------------------------------------------------
STABILITY: Stable
INCOMPATIBILITY - MATERIALS/CONDITIONS TO AVOID:
Heat.
HAZARDOUS POLYMERIZATION: Hazardous polymerization will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS:
Carbon Monoxide and Carbon Dioxide, Aldehydes, Ketones, Hydrocarbons.
-----------------------------------------------------------------------------
5. ENVIRONMENTAL INFORMATION
-----------------------------------------------------------------------------
SPILL RESPONSE:
Refer to other sections of this MSDS for information regarding
physical and health hazards, respiratory protection, ventilation, and
personal protective equipment. Ventilate area. Extinguish all
ignition sources. Cover with absorbent material. Collect using non-
sparking tools. Place in a U.S. DOT-approved container.
RECOMMENDED DISPOSAL:
Incinerate in a permitted hazardous waste incinerator in the presence
of a combustible material. Facility must be capable of handling
aerosol cans. Dispose of empty cans in a sanitary landfill. Dispose
of completely absorbed waste product in a facility permitted to
accept chemical wastes.
RECYCLE EMPTY AEROSOL CONTAINERS WHERE AVAILABLE.
ENVIRONMENTAL DATA:
Not determined.
REGULATORY INFORMATION:
Volatile Organic Compounds: ca. 66 % by wt.
VOC Less H2O & Exempt Solvents: ca. 563 gms/liter calculated per SCAQMD
rule 443.1.
Hazardous Air Pollutants: 0 % by wt calculated.
Since regulations vary, consult applicable regulations or authorities
before disposal. U.S. EPA Hazardous Waste Number = D001 (Ignitable)
EPCRA HAZARD CLASS:
FIRE HAZARD: Yes PRESSURE: Yes REACTIVITY: No ACUTE: Yes CHRONIC: Yes
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 4
-----------------------------------------------------------------------------
6. SUGGESTED FIRST AID
-----------------------------------------------------------------------------
EYE CONTACT:
Immediately flush eyes with large amounts of water. Get immediate
medical attention.
SKIN CONTACT:
Flush skin with large amounts of water. If irritation persists, get
medical attention.
INHALATION:
Remove person to fresh air. If not breathing, give artificial
respiration. If breathing is difficult, get immediate medical
attention.
IF SWALLOWED:
Do not induce vomiting. Drink two glasses of water. Call a physician.
-----------------------------------------------------------------------------
7. PRECAUTIONARY INFORMATION
-----------------------------------------------------------------------------
EYE PROTECTION:
Avoid eye contact with vapor, spray, or mist. Wear safety glasses
with side shields.
SKIN PROTECTION:
Avoid prolonged or repeated skin contact.
RECOMMENDED VENTILATION:
Do not use in a confined area or areas with little or no air
movement. If exhaust ventilation is not adequate, use appropriate
respiratory protection. Provide ventilation adequate to control vapor
concentrations below recommended exposure limits and/or control spray
or mist.
RESPIRATORY PROTECTION:
Avoid breathing of vapors, mists or spray. Select one of the
following NIOSH approved respirators based on airborne concentration
of contaminants and in accordance with OSHA regulations: half-mask
organic vapor respirator.
PREVENTION OF ACCIDENTAL INGESTION:
Do not ingest.
RECOMMENDED STORAGE:
Store at temperatures below 120 degrees F (49 degrees C). Store out
of direct sunlight. Keep out of the reach of children.
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 5
-----------------------------------------------------------------------------
7. PRECAUTIONARY INFORMATION (continued)
-----------------------------------------------------------------------------
FIRE AND EXPLOSION AVOIDANCE:
Aerosol container contains flammable gas under pressure. Keep away
from heat, sparks, open flame, and other sources of ignition.
Extremely flammable liquid and vapor. Do not pierce or burn
container, even after use. No smoking while handling this material.
Avoid static discharge.
EXPOSURE LIMITS
INGREDIENT VALUE UNIT TYPE AUTH SKIN*
-----------------------------------------------------------------------------
DIMETHYL ETHER....................... 1000 PPM TWA CMRG
DIMETHYL ETHER....................... 500 PPM TWA AIHA
PENTANE.............................. 600 PPM TWA ACGIH
PENTANE.............................. 600 PPM TWA OSHAV
OSHA VACATED PEL
PENTANE.............................. 750 PPM STEL OSHAV
OSHA VACATED PEL
PENTANE.............................. 1000 PPM TWA OSHA
NON-VOLATILE COMPONENTS - N.J.
TRADE SECRET (T.S.) REGISTRY NO.
04499600-5490P ++.................. NONE NONE NONE NONE
ACETONE.............................. 500 PPM TWA ACGIH
ACETONE.............................. 750 PPM STEL ACGIH
ACETONE.............................. 750 PPM TWA OSHAV
OSHA VACATED PEL
ACETONE.............................. 1000 PPM STEL OSHAV
OSHA VACATED PEL
ACETONE.............................. 1000 PPM TWA OSHA
NAPHTHOL SPIRITS..................... 100 PPM TWA 3M
NAPHTHOL SPIRITS..................... 300 PPM TWA CMRG
* SKIN NOTATION: Listed substances indicated with 'Y' under SKIN refer to
the potential contribution to the overall exposure by the cutaneous route
including mucous membrane and eye, either by airborne or, more particularly,
by direct contact with the substance. Vehicles can alter skin absorption.
SOURCE OF EXPOSURE LIMIT DATA:
- 3M: 3M Recommended Exposure Guidelines
- ACGIH: American Conference of Governmental Industrial Hygienists
- AIHA: American Industrial Hygiene Assoc. Workplace Environmental
Exposure Level Guideline
- CMRG: Chemical Manufacturer Recommended Exposure Guidelines
- OSHA: Occupational Safety and Health Administration
- OSHAV: Occupational Safety and Health Administration Vacated PEL.
Vacated Permissible Exposure Limits (PEL) are enforced as
the OSHA PEL in some states. Check with your local
regulatory authority.
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 6
EXPOSURE LIMITS (continued)
INGREDIENT VALUE UNIT TYPE AUTH SKIN*
-----------------------------------------------------------------------------
- NONE: None Established
-----------------------------------------------------------------------------
8. HEALTH HAZARD DATA
-----------------------------------------------------------------------------
EYE CONTACT:
Moderate Eye Irritation: signs/symptoms can include redness, swelling,
pain, tearing, and hazy vision.
SKIN CONTACT:
Mild Skin Irritation (after prolonged or repeated contact):
signs/symptoms can include redness, swelling, and itching.
INHALATION:
Intentional concentration and inhalation may be harmful or fatal.
Central Nervous System Depression: signs/symptoms can include
headache, dizziness, drowsiness, incoordination, slowed reaction time,
slurred speech, giddiness and unconsciousness.
Irritation (upper respiratory): signs/symptoms can include soreness
of the nose and throat, coughing and sneezing.
IF SWALLOWED:
Ingestion is not a likely route of exposure to this product.
WHILE THE FOLLOWING EFFECTS ARE ASSOCIATED WITH ONE OR MORE OF THE
INDIVIDUAL INGREDIENTS IN THIS PRODUCT AND ARE REQUIRED TO BE
INCLUDED ON THE MSDS BY THE U.S. OSHA HAZARD COMMUNICATION STANDARD,
THEY ARE NOT EXPECTED EFFECTS DURING FORESEEABLE USE OF THIS PRODUCT.
Irritation of Gastrointestinal Tissues: signs/symptoms can include
pain, vomiting, abdominal tenderness, nausea, blood in vomitus, and
blood in feces.
-----------------------------------------------------------------------------
SECTION CHANGE DATES
-----------------------------------------------------------------------------
HEADING SECTION CHANGED SINCE April 03, 2001 ISSUE
-----------------------------------------------------------------------------
Abbreviations: N/D - Not Determined N/A - Not Applicable CA - Approximately
MSDS: 3M(TM) Foam Fast 74 Spray Adhesive and 3M(TM) Foam Fast 74 Cylinder
Spray Adhesive
May 24, 2001 PAGE 7
-----------------------------------------------------------------------------
The information in this Material Safety Data Sheet (MSDS) is believed to
be correct as of the date issued. 3M MAKES NO WARRANTIES, EXPRESSED OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR COURSE OF
PERFORMANCE OR USAGE OF TRADE. User is responsible for determining
whether the 3M product is fit for a particular purpose and suitable for
user's method of use or application. Given the variety of factors that
can affect the use and application of a 3M product, some of which are
uniquely within the user's knowledge and control, it is essential that
the user evaluate the 3M product to determine whether it is fit for a
particular purpose and suitable for user's method of use or application.
3M provides information in electronic form as a service to its customers.
Due to the remote possibility that electronic transfer may have resulted
in errors, omissions or alterations in this information, 3M makes no
representations as to its completeness or accuracy. In addition,
information obtained from a database may not be as current as the
information in the MSDS available directly from 3M.
|