FLAME RETARDANT HOSTAPHAN?POLYESTER FILM NUMBER G000FR
Issue Date: March 7, 2002
Revised: May 30, 2008
Emergency Contact
For Emergency Call 1-800-334-5902
Product Identification
This MSDS applies to Hostaphan?flame retardant polyester film. Polyester film is polyethylene terephthalate
(CAS# 25038-59-9).
Hazardous Ingredients
Low levels of Acetaldehyde (CAS# 75-07-0) are present in the film. Under normal use conditions, release would be
negligible.
Established exposure limits for acetaldehyde in the U.S. are:
ACGIH TLV = 25 ppm (ceiling)
OSHA PEL = 200 ppm TWA
Physical-Chemical Data
The clear, odorless film is chemically stable and resistant to attack by oils, solvents, weak acids and weak alkalis.
The film melts at 250癈 and decomposes at temperatures above 250癈. It has a specific gravity of 1.4 - 1.5.
Physical Hazards
Heavy gauges of polyester film can contain sharp edges. Proper protective gear, such as gloves, is recommended.
Unwinding, winding and passage of polyethylene terephthalate film through and over rollers will tend to generate a
strong electrostatic charge on the web. Static discharge devices should be properly positioned at such points to
eliminate the charge and to prevent uncontrolled discharge from the web. This is particularly required in potentially
explosive atmospheres and to protect personnel from the effect of a static discharge.
Health Hazard Data
No adverse health effects have been attributed to polyester film.
KEY
Hazard Designations
NFPA 0-None
Health: 0 1-Slight
Flammability: 1 2-Moderate
Reactivity: 0 3-Severe
4-Extreme
MSDS Number G00001FR
Page 2 of 2
May 30, 2008
Control Measures and Safe Handling Procedures
The film will burn if exposed to flame. Fire fighters must protect themselves from hazardous decomposition and
combustion products that may include acetaldehyde, carbon monoxide and other toxic gases. Wear self-contained
breathing apparatus and complete personal protective equipment when potential for exposure to products of
combustion exists. Fire fighting extinguishing media include carbon dioxide, water spray, foam or dry chemical.
If the film could be subjected to conditions releasing acetaldehyde, then powered supply and exhaust ventilation
must be used to ensure compliance with regulations. Alternatively, self-contained breathing apparatus should be
used.
Disposal and Shipping Information
Polyester film is not classified as a hazardous waste under the Resource Conservation And Recovery Act and,
unless prohibited by state or local regulation, can be disposed of in a municipal landfill or incinerated.
This product is not classified by the Department of Transportation as a hazardous material.
Regulatory
U.S. Regulations
This product is classified as an article under the TSCA.
No components are listed on SARA 313.
Canada and Europe
Polyethylene terephthalate polymer is listed on the Canadian DSL and its reactants are listed on EINECS.
Information Contact
Mitsubishi Polyester Film, Inc.
Environmental, Safety, and Health Affairs
P. O. Box 1400
Greer, S.C. 29652
(864) 879-5000
Judgments as to the suitability of information herein are the purchaser's responsibility. Although reasonable care
has been taken in the preparation of such information, Mitsubishi Polyester Film, Inc. extends no warranties, makes
no representations, and assumes no responsibility as to the accuracy or suitability of such information to the
purchaser's intended purpose or for consequences of its use.