232376 E. Pacifica Place Rancho Dominguez, CA 90220 (800) 675-1118 www.alliedhightech.com
MATERIAL/CHEMICAL SAFETY DATA SHEET
SECTION 3: HAZARDS IDENTIFICATION
SECTION 1: CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Hazard Statement: Not listed as a carcinogen by IARC, NTP or
Product Details OSHA.
Cutting Fluid - Low Speed
Product Name:
Medical Restrictions: Significant exposure to this chemical may
adversely affect people with chronic disease of the nervous system,
skin, gastrointestinal tract and/or eyes.
60-20110, 60-20115
Allied Item No.:
For Industrial use only by trained personnel.
Chemical Name: Cutting Fluid/Lapping Vehicle
SECTION 4: FIRST AID MEASURES
Company Identification Potential First Aid/
Health Effects Medical Info.
Allied High Tech Products, Inc.
Eye Contact: May cause eye injury. Flush with water for 15
2376 East Pacifica Place
Liquid and vapor in high minutes, holding eyelids
Rancho Dominguez, CA 90220 concentrations may open. Seek medical
(310) 635-2466 cause irritation, tearing attention.
and burning sensation.
Contact Point
Transportation for United States
Skin Contact: Repeated or prolonged Remove any contami-
Chemtrec (800) 424-9300 * (202) 483-7616 contact may cause irritation nated clothing and wash
and drying of skin. Repeated skin with large amounts of
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENT contact with methyl alcohol-
water. Seek medical
soaked material may be toxic
Exposure Limits in Air Carcin. attention if irritation
and cause vision effects and
Chemical Name CAS No. ACGIH TLV or TWA OSHA PEL Y/N persists.
death.
Remove victim to fresh air.
Inhalation: Vapors may cause
Propylene Glycol 57-55-6 NE NE N
If patient not breathing,
stupor, headache,
70-95%
give artificial respiration
nausea, dizziness, then administer oxygen if
unconsciousness and
Methyl Alcohol 67-56-1 200 ppm 200 ppm N necessary. Seek medical
blindness.
5-30% attention immediately.
Ingestion: Poisonous or fatal if Give two glasses of water
swallowed. Small and induce vomiting.
amounts may cause Seek medical attention
mental sluggishness, immediately.
nausea, vomiting, and
blindness.
Note:
SECTION 5: FIRE FIGHTING MEASURES
Extinguishing Media: Alcohol foam, carbon dioxide or dry chemical.
Fire Fighting Instruction: Wear full protective clothing and OSHA/NIOSH self-
contained breathing apparatus with full facepiece.
Special Hazards: Vapors can flash back to a source of ignition.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Eliminate ignition sources. If fire potential exists, disperse vapors
with water spray. Contain with absorbent material such as clay, soil or
any commercially available absorbent. Transfer contaminated
HMIS Ratings
Ingredients are listed on the TSCA Inventory of absorbent, soil and other materials into recovery or salvage drums for
2
Health:
Chemical Substances. disposal. Avoid runoff into storm sewers and ditches that lead to
Flammability: 2
Those not identified are non-hazardous.
natural waterways.
Reactivity: 0
Page 1 of 2:
2376 E. Pacifica Place ?Rancho Dominguez, CA 90220 ?(800) 675-1118 ?www.alliedhightech.com
SECTION 7: HANDLING & STORAGE SECTION 12: ECOLOGICAL INFORMATION
Handling: Use proper grounding procedures when transferring. No information available.
Use spark-resistant tools. Use adequate ventilation. Avoid skin
contact and breathing vapors; wash with soap and water after
handling. Wash contaminated clothing thoroughly before re-use.
Observe good house keeping practices.
Storage: Store in a cool ventilated area. Keep away from sparks,
heat and flame. Keep container closed when not in use.
SECTION 8: EXPOSURE CONTROL & PERSONAL PROTECTION SECTION 13: DISPOSAL INFORMATION
Engineering Measures: Local exhaust system designed for flammable gas
Incinerate or biological treatment in accordance to
atmospheres to remove vapors.
Federal, State and Local regulations.
Respiratory Protection: Use OSHA/NIOSH approved respiratory protection if level
of air contaminants is excessive.
RCRA Hazardous Waste: Methanol listed under
40CFR261
Protective Gloves: Neoprene or rubber gloves.
Eye Protection: Safety glasses or chemical splash goggles.
Other: Eyewash, safety shower and impervious clothing are recommended.
SECTION 9: PHYSICAL & CHEMICAL PROPERTIES SECTION 14: TRANSPORT INFORMATION
DOT Shipping Name: Flammable liquid, n.o.s.
Appearance: Red liquid
(Methanol) air shipment
Odor: Mild astringent odor
Solubility: 100%
DOT Hazard Class: 3
Boiling Point: 148癋 (64癈)
Melting Point: -76癋 (-60癈)
DOT Id Number: UN1933
Flash Point: 110癋 (43癈) Pensky-Martens closed cup
Vapor Pressure: 8 mm/Hg @ 68癋 (20癈)
Vapor Density: 2.5
Evaporation Rate: 0.14
SECTION 15: REGULATORY INFORMATION
Specific Gravity: 1.018
Flammable Limits LEL: 2.6 SARA Title III: Yes, subject to reporting under section 313.
Flammable Limits UEL: 36.5 Toxic Substance Control Act TSCA: All ingredients are TSCA listed.
SECTION 10: STABILITY & REACTIVITY CA Proposition 65/Florida/Massachusetts/New Jersey: Not known.
Pennsylvania: Propylene glycol; methyl alcohol.
Stability: Stable
Canada WHMIS Hazard Class: Not known.
Conditions to Avoid/Incompatibles: Sulfuric acid, strong oxidizing
agents such as hydrogen peroxide, nitric acid, perchloric acid and
chromium trioxide.
SECTION 16: OTHER INFORMATION
Decomposition Products: Carbon monoxide and/or carbon dioxide.
Hazardous Polymerization: Will not occur.
Legend
SECTION 11: TOXICOLOGICAL INFORMATION NAIF: No Applicable Information Found
NA: Not Available/Applicable
This material is not listed as a carcinogen by IARC, NTP or
NE: None Established
OSHA.
DISCLAIMER: The above information and recommendations are
believed accurate and reliable. Because it is not possible to anticipate
Acute Toxicity: Not listed all conditions of use, additional safety precautions may be required.
ALLIED HIGH TECH PRODUCTS, INC. makes no warranty, either
express or implied, as to its accuracy or completeness and none is
made as to the fitness of this material for any purpose. The
manufacturer/distributor shall not be liable for damages to person or
property resulting from its use. Nothing herein shall be construed as a
recommendation for use in violation of any patent.
Page 2 of 2: Form Prepared By: Allied High Tech Products, Inc. January 2010
|