Exposure Limits: Not applicable
Cancer Information: Contains no NTP or OSHA listed carcinogens.
Primary Route of Exposure: Skin contact and inhalation.
Skin: May cause skin irritation. Symptoms may include stinging and burning of skin.
Effects of Overexposure: It is unlikely that any potential health hazards will be expressed.
4. FIRST AID MEASURES
It is not anticipated that any firstaid requirements will be necessary from normal industrial handling of
this material.
5. FIRE AND EXPLOSION HAZARD DATA
This material will burn if exposed to flame. Fire fighters should protect themselves from combustion
products that may include acetic acid, carbon dioxide, carbon monoxide and other organic vapors. Wear
selfcontained breathing apparatus and complete personal protective equipment when potential for
exposure to products of combustion exists. Fire and extinguishing media include water, carbon dioxide,
foam or dry chemical.
Page 2 of 3
NEPTCO LT200 Ultraviolet Dicing Tape
6. ACCIDENTAL RELEASE MEASURES
Spill and Leak Procedures: Broken pieces, cuttings, or other debris should be swept or vacuumed.
7. STORAGE
LT200 dicing tapes should be stored in a controlled environment where conditions do not exceed 27oC +/
10o and 30% RH +/20%. This product is sensitive to UV light, so store away from heat and direct sunlight.
If stored as recommended, the product will yield a shelf life of 12 months from the date of manufacture
found on the core label.
8. EXPOSURE CONTROLS AND PERSONAL PROTECTION
Appropriate Hygienic Practices: Wash thoroughly after handling, and before eating, drinking or smoking.
Personal Protective Equipment: Not normally required. Handle with gloves.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance and Odor: Yellow with no odor.
Boiling Point (癋): N/A
Vapor Pressure (mm Hg): N/A
Vapor Density (Air = 1): N/A Solid Material
Solubility in Water: Insoluble
Specific Gravity: Avg. 1.03
Volatile (Wt.) %: Nonvolatile
pH: N/A
Evaporation Rate: N/A
Melting Point: N/A
10. STABILITY AND REACTIVITY
Chemical Stability: Mild polymerization of adhesive on exposure to switch or UV light
sources.
Incompatibilities: Strong oxidizing agents, strong acids, strong bases.
Decomposition Products: Via incomplete combustion only (see Section III)
Polymerization: Will self polymerize in sunlight or UV light.
Conditions to Avoid: Softened by hydrocarbons such as benzene, gasoline, lubricating oils,
petroleum ether and by chlorinated hydrocarbons.
11. TOXICOLOGICAL INFORMATION
Not Available at this time
12. ECOLOGICAL INFORMATION
Not available at this time
Page 3 of 3
NEPTCO LT200 Ultraviolet Dicing Tape
13. DISPOSAL CONSIDERATIONS
Used or unused product should be disposed of in accordance with Federal, State, or Local laws or
Regulations.
14. TRANSPORT INFORMATION
USDOT: Not Regulated
15. REGULATORY INFORMATION
Regulatory References:
OSHA: Occupational Health and Safety Administration
NTP: National Toxicology Program
USDOT: United States Department of Transportation
TSCA: Toxic Substances Control Act (USA)
SARA: Superfund Amendments and Reauthorization Act
16. OTHER INFORMATION
The information presented in this MSDS was obtained from sources which NEPTCO believes are reliable;
however, the information is provided without any representation or warranty, expressed or implied,
regarding accuracy or correctness.
NEPTCO Incorporated
Department of Regulatory Affairs
Box 2323, 30 Hamlet Street
Pawtucket, RI 028610323
Web site: www.neptco.com
Email: efranklin@neptco.com
TEL: 4017225500 FAX: 4017259962