MATERIAL SAFETY DATA SHEET breathing, begin CPR, get immediate medical attention.
Cortec, Spray Technologies Division Ingestion: If material is swallowed, consult a physician
1300 South River Street immediately; DO NOT induce vomiting unless physician
Spooner, WI 54801 directed. If spontaneous vomiting occurs, keep victim's
PHONE: 715-635-8711 TOLL FREE 1-800-826-6791 head below hips to prevent aspiration of vomitus into lungs.
FAX: 715-635-2200 MEDICAL CONDITIONS PRONE TO AGGRAVATION BY
EMERGENCY PHONE NO.: (FOR SPILL, LEAK, FIRE, EXPOSURE: Cardiovascular disease, pre-existing skin
EXPOSURE OR ACCIDENT): 1-800-535-5053 conditions
PRIMARY ROUTES OF ENTRY: Inhalation, skin and eye
* * * * * * * * * * * CLEANER LUBE 12103, 12106 * * * * * * * contact.
** HEALTH HAZARDS (acute and chronic) / EFFECTS OF
OVEREXPOSURE: Excessive inhalation of high vapor
SECTION I - PRODUCT IDENTIFICATION concentrations may cause dizziness, weakness, fatigue,
PRODUCT NAME: Cleaner Lube (aerosol) nausea, headache, unconsciousness, or, in extreme
PRODUCT DESCRIPTION: Nonflammable, safe for use on overexposures, asphyxiation.
energized equipment. Protects metal contacts from carbon
buildup, oxidation and corrosion ?minimizes friction and SECTION VI - REACTIVITY DATA
metal wear. Fast drying, excellent dielectric properties, deep STABILITY: Stable under normal use and storage conditions.
penetrating action. Not recommended for use on acrylic, Aerosol containers may fail explosively when heated under
polystyrene or polycarbonates! fire conditions.
RESTRICTIONS: Commercial / industrial use only. HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS (under fire
SECTION II - HAZARDOUS INGREDIENTS conditions): Hydrochloric acid, hydrofluoric acid, carbonyl
INGREDIENT CAS# OCCUPATIONAL halides such as phosgene, small amounts of carbon oxides.
NAME(S) EXPOSURE LIMITS INCOMPATIBILITY: Avoid contact with strong acids,
alkalies, reactive metals, sodium, calcium, magnesium, zinc,
TLV OR PEL ORAL
lithium shavings, etc., as well as strong oxidizing agents.
LD-50
CONDITIONS TO AVOID: Avoid potential ignition sources
1,1,-Dichloro-1- 1717-00-6 500 ppm 5 gm/kg
such as sparks, flames, electric arcs or other high intensity
fluoroethane (See below*) (Rat)
energy sources.
SECTION VII - SPILL OR LEAK PROCEDURES
Carbon Dioxide 124-38-9 5000 ppm N.E.
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED
OR SPILLED: Immediately extinguish potential ignition
sources, ventilate area. Take up spilled material on an inert,
*Recommended Workplace Environmental Exposure Level
absorbant material and place into a closed-top, DOT
(WEEL) as established by American Industrial Hygene
approved container for disposal. Prevent liquid from
Association
entering sewers or drains.
Carcinogenic: OSHA = no NTP = no IARC = no
WASTE DISPOSAL: Comply with all existing Federal, State
and Local environmental regulations. Waste or unwanted
SECTION III - PHYSICAL DATA
material may be reclaimed or incinerated by permitted
APPEARANCE: Transparent, colorless liquid
facilities.
ODOR: Slight ethereal, sweet odor
BOILING POINT: 89.6 Degrees F. (31.66 degrees C.)
SECTION VIII - SAFE HANDLING AND USE INFORMATION
VAPOR DENSITY (Air = 1): 4.1
RESPIRATORY PROTECTION: Not normally required;
VAPOR PRESSURE: 518 mmHg @ 70 degrees F.
mechanical (general) ventilation is usually adequate. Wear a
SOLUBILITY IN WATER: Negligible
NIOSH approved organic respirator in nuisance level
SPECIFIC GRAVITY: 1.24
concentrations, a positive pressure, air-supplied respirator in
EVAPORATION RATE (Ether = 1): >1
high vapor concentrations or oxygen-deficient atmospheres.
Local exhaust ventilation may also be used to control
SECTION IV - FIRE AND EXPLOSION DATA
airborne vapor levels in work areas.
HMIS RATING: Health ?1, Fire - 1, Reactivity - 1
PROTECTIVE GLOVES: PVA or Neoprene gloves
FLASH POINT : None to boiling (TCC)
EYE PROTECTION: Safety glasses, splash goggles, face
FLAMMABLE LIMITS: LEL: 7.6 UEL:
shield
17.7
OTHER PROTECTIVE EQUIPMENT: Eye wash station.
EXTINGUISHING MEDIA: Dry chemical, CO2, water fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: Heated
SECTION IX - SPECIAL PRECAUTIONS AND STORAGE
containers may over-pressurize and fail explosively. Heat or
DATA
flame may thermally decompose this material to produce
PRECAUTIONS TO BE TAKEN IN HANDLING: Avoid eye and
hazardous, toxic and corrosive gases.
skin contact with liquid. Avoid excessive inhalation of
SPECIAL FIRE FIGHTING PROCEDURES: Fire fighters
vapors. Use in a well-ventilated environment. Intentional
should wear self-contained breathing apparatus and
inhalation of contents is harmful and may be fatal.
protective clothing. Cool fire exposed containers with water
PRECAUTIONS TO BE TAKEN IN STORING: Store
fog
containers below 120篎 (48篊), away from heat or ignition
sources, open flame, out of direct sunlight.
SECTION V - HEALTH HAZARD DATA
EMERGENCY AND FIRST AID PROCEDURES:
SECTION X ?SHIPPING DATA
Eye Contact: Flush eyes with water for at least 15 minutes.
U.N./N.A. NUMBER: UN1950
Consult a physician. Skin Contact: Wash affected area with
soap and water. If irritation develops or persists, consult a
(continued on page 2)
physician. Inhalation: Remove victim to fresh air,
Page 2
administer oxygen if necessary. If victim has stopped
Cleaner Lube 12103, 12106
DOT/IATE SHIPPING NAME: Aerosols, non-flammable, (each not
exceeding 1L capacity)
DOT/IATA HAZARD CLASS: 2.2
DOT/IATA REQUIRED LABELS: 2, Flammable gas (air shipment
only)
DOT EXCEPTION: See Code 49 section 172.101, column (8A).
Section 173.306(h) permits "limited quantity" materials (inner
packagings which do not exceed 1L capacity / 61 cubic inches and
for which internal pressures do not exceed 180 psig at 130 degrees
F.) meeting section 171.8 definition of "consumer commodity" to
be renamed Consumer commodity, reclassed as ORM-D when
shipped via ground mode, domestically.
IMDG SHIPPING NAME: Aerosols, non-flammable, (each not
exceeding 1L capacity)
FREIGHT CLASS: NMFC 48580, Sub 3
LTL: 55 TL: 35 MW: 36
TSCA STATUS: All components listed
PREPARED BY: Roger Hanson
DATE PREPARED: 01-26-00 SUPERSEDES: 01-13-00
DISCLAIMER: This information is furnished without warranty,
expressed, or implied, except that it is accurate to the best
knowledge of Cortec, Spray Technologies Division. The data
on this sheet relates only to the specific material designated
herein. Cortec, Spray Technologies Division assumes no
legal responsibility for use or reliance upon this data.
N.E. = NOT ESTABLISHED N.A. = NOT APPLICABLE
|