I. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
REVISION DATE: 11/04/01
SUPERCEDES: 11/04/01
MSDS NO. RPMFILSTIK
II. COMPOSITION/INFORMATION ON INGREDIENTS
CHEMICAL NAME % CAS # PEL
epoxy resin 91-100 25036-25-3 No PEL established
titanium dioxide 1-10 13463-67-7 total dust: 15 mg/m3 TWA
iron oxide yellow 1-10 51274-00-1 No PEL established
Quartz <1 14808-60-7 see Table Z-3
III. HAZARDS IDENTIFICATION
Ingestion.Skin contact.Eye contact.
Routes of Entry:
Eye disease. Respiratory disease including asthma and bronchitis.
Medical Conditions Aggravated:
Immediate (Acute) Health Effects
May cause skin irritation.
Skin Contact:
Can cause minor irritation, tearing and reddening.
Eye Contact:
Mildly irritating to mouth, throat, and stomach. Can cause abdominal discomfort.
Ingestion:
Target Organ Acute Toxicity:
Titanium dioxide respiratory system (in animals: lung tumors)
Silica, crystalline respiratory system, eyes (in animals: lung cancer)
B320-005 Fruitwood Burn In Stick Page 1 of 4
Long-Term (Chronic) Health Effects:
Contains a substance that is a probable cancer hazard as a
Carcinogenicity
respirable state based on human studies.
No data available to indicate product or any components present at greater than 0.1%
Mutagenicity:
is mutagenic or genotoxic.
Eyes. Respiratory Tract.
Target Organ Chronic Toxicity
No additional health information available.
Supplemental Health Hazard
Information:
IV. FIRST AID
Immediately flush with plenty of water. After initial flushing, remove any contact
Eyes:
lenses and continue flushing for at least 15 minutes. Have eyes examined and tested
by medical personnel.
Wash with soap and water. Get medical attention if irritation develops or persists.
Skin Contact:
No hazard expected under normal industrial use. If a large quantity is swallowed, seek
Ingestion:
medical attention. Do not induce vomiting.
No additional first aid information available.
Notes to MD:
Spill Mitigation Procedures
None Known.
General Methods:
VII. HANDLING AND STORAGE
Wash thoroughly after handling.
Handling:
Store in a cool dry place. Isolate from incompatible materials.
Storage:
VIII. ENGINEERING CONTROLS AND PERSONAL PROTECTIVE EQUIPMENT
Check ventilation codes.
Engineering Controls:
Protective Equipment
No respiratory protection required under normal conditions of use.
Respiratory Tract:
No special requirements under normal industrial use.
Eyes:
B320-005 Fruitwood Burn In Stick Page 2 of 4
Not normally considered a skin hazard. Where use can result in skin contact, practice
Skin:
good personal hygiene. Wash hands and other exposed areas with mild soap and water
before eating, drinking, and when leaving work.
IX. PHYSICAL DATA
Physical State: Colored Solid
Odor: None to very faint
Solids Vol % 100
Solids Wt % 100
Material VOC lbs/gal: 0
Material VOC gms/l: 0
Weight per gallon: 10.3009
X. STABILITY AND REACTIVITY
Stable under normal conditions.
Stability Information:
Contamination.High temperatures.
Conditions to Avoid:
Hazardous Polymerization will not occur.
Hazordous Polymerization:
XI. TOXICOLOGICAL INFORMATION
Chemical Name CAS Number LD50/LC50
No data available
XII. ECOLOGICAL INFORMATION
None Known
Ecological Values:
XIII. DISPOSAL CONSIDERATIONS
Dispose of in a landfill. Disposal is not likely to be regulated.
Disposal Methods:
Components Subject to USEPA Land Disposal Restrictions:
No chemicals subject to land disposal restrictions. %
XIV. TRANSPORTATION INFORMATION
Non-regulated
DOT
XV. REGULATORY INFORMATION
Toxic Substances Control Act (TSCA): In compliance.
Chemical Name Regulation CASRN %
No 313-listed chemicals in this product SARA 313 Reportable:
25036-25-3 93.57
epoxy resin New Jersey Right To Know:
13463-67-7 2.91
titanium dioxide New Jersey Right To Know:
51274-00-1 2.06
iron oxide yellow New Jersey Right To Know:
PROPRIETARY 0.98
Modified Epoxy Resin New Jersey Right To Know:
14808-60-7 0.04
Quartz New Jersey Right To Know:
B320-005 Fruitwood Burn In Stick Page 3 of 4
XVI. ADDITIONAL INFORMATION
IMPORTANT: WHILE THE DESCRIPTIONS, DATA AND INFORMATION
Other Information:
CONTAINED HEREIN ARE PRESENTED IN GOOD FAITH AND BELIEVED TO BE
ACCURATE, IT IS PROVIDED FOR YOUR GUIDANCE ONLY. BECAUSE MANY
FACTORS MAY AFFECT PROCESSING OR APPLICATION/USE, WE RECOMMEND
THAT YOU PERFORM AN ASSESSMENT TO DETERMINE THE SUITABILITY OF A
PRODUCT FOR YOUR PARTICULAR PURPOSE PRIOR TO USE. NO WARRANTIES
OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING FITNESS FOR A
PARTICULAR PURPOSE, ARE MADE REGARDING PRODUCTS DESCRIBED, DATA
OR INFORMATION SET FORTH. IN NO CASE SHALL THE DESCRIPTIONS,
INFORMATION,OR DATA PROVIDED BE CONSIDERED A PART OF OUR TERMS
AND CONDITIONS OF SALE. FURTHER, THE DESCRIPTIONS, DATA AND
INFORMATION FURNISHED HEREUNDER ARE GIVEN GRATIS. NO OBLIGATION
OR LIABILITY FOR THE DESCRIPTION, DATA AND INFORMATION GIVEN ARE
ASSUMED. ALL SUCH BEING GIVEN AND ACCEPTED AT YOUR RISK.