GMX MATERIAL SAFETY DATA SHEET
MSDS Status: Current Product Status: Active
Revision Date: 01/19/2005
ULTRA-SHIELD EXTERIOR WALL
Product Name:
WATERPROOFING WB
Supersedes Date: 12/12/03
1724
Product Code:
MSDS No.: 200113
SECTION I - CHEMICAL PRODUCT/COMPANY IDENTIFICATION
MIXTURE
Chemical Name:
NOT APPLICABLE
CAS No.:
WATER-BASED POLYMER MODIFIED ASPHALT EMULSION
Product Description:
1 0 0
Hazard Classification: HEALTH - FLAMMABILITY - REACTIVITY -
GMX, INC.
Manufacturer/Supplier:
9105 WAY AVE.
CLEVELAND, OHIO 44105
PH: (216) 641-7502 FAX: (216) 641-0633
http://www.gmxwaterproofing.com
Internet Address:
24HR. EMERGENCY ASSISTANCE: 1-800-762-8225
SECTION II - HAZARDOUS
INGREDIENTS/COMPOSITION
OSHA PEL AGCIH TLV
COMPONENTS %WT CAS NUMBER (TWA) (TWA)
PETROLEUM ASPHALT 40-70 8052-42-4 * 0.5mg/m3
(asphalt fumes)
WATER 15-40 7732-18-5 NAV NAV
ELASTOMERIC LATEX 7-13 - NAV NAV
SYNTHETIC RESIN 0.5-3 8050-90-7 5ppm 10ppm
POTASSIUM HYDROXIDE 0.5-3 1310-58-3 2ppm 2ppm
STODDARD SOLVENT 0.5-1.5 8052-41-3 100ppm 100ppm
2-AMINO-2-METHYL-1-PROPANOL 0.1-1 124-68-5 NAV NAV
BYCYCLIC OXAZOLIDINES 0.1-1 56709-13-8 NAV NAV
DEFOAMER 0.1-1 - NAV NAV
DISPERSANT 0.1-1 - NAV NAV
RHEOLOGICAL MODIFIERS 0.1-1 - NAV NAV
2,2,4-TRIMETHYL-1,2-PENTANEDIOL 0.1-1 25265-77-4 NAV NAV
MONO(20METHYLPROPANOATE
* OSHA HAS NOT ESTABLISHED A SPECIFIC PEL FOR ASPAHLT FUMES. THEY ARE CONSIDERED
AS PARTICULATES NOT OTHERWISE REGULATED" WITH A PEL OF 5mg/m3 FOR RESPIRABLE
DUST FRACTION AND 15mg/m3 FOR THE TOTAL DUST FRACTION.
NAV = Not Available
SECTION III - HAZARDS IDENTIFICATION
INHALATION, DERMAL, INGESTION
ROUTES OF ENTRY:
NOT ESTABLISHED
CARCINOGENICITY:
HEALTH HAZARDS (Acute & Chronic):
INHALATION: Prolonged inhalation of vapor or mist of sufficient concentration
may cause interference with respiratory function.
Minimal irritation. Repeated or prolonged contact may cause dermatitis.
SKIN:
For Product: 1724 Page No. 1
EYES: Minimal irritation.
INGESTION: Product has low order of acute toxicity and may cause gastrointestional
irritation, nausea, vomiting and diarrhea.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: This product as with any chemical, may
enhance allergic conditions on certain people. Above results are based on similar
product testing. Chronic skin or respiratory disorders.
SECTION IV - FIRST AID PROCEDURES
EYE CONTACT: Flush eyes with water for at least 15 minutes, contact physician.
Wash with soap and water. Contact physician if redness or itching
SKIN CONTACT:
persists.
INHALATION: Remove to fresh air and obtain medical attention if respiratory functions
are impaired.
INGESTION: Do not induce vomiting, contact physician.
SECTION V - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: Water based
Not available
AUTOIGNITION TEMP.:
Not applicable
LEL (LOWER EXPLOSION LIMIT):
Not applicable
UEL (UPPER EXPLOSION LIMIT):
NAP, but if water dries, then use FOAM, CARBON DIOXIDE, DRY
EXTINGUISHING MEDIA:
CHEMICAL, or WATER FOG.
SPECIAL FIRE FIGHTING PROCEDURES: Use light water spray to cool exposed surfaces.
Wear self contained breathing apparatus with full facepiece operating in positive
pressure mode.
0
UNUSUAL FIRE AND EXPLOSION HAZARD: May foam if heated to temperatures of 212 F or
0
higher, or if mixed with materials above 212 F. Avoid using water stream to
prevent frothing. Carbon monoxide and other organic compounds may be formed upon
combustion.
A) SENSITIVITY TO IMPACT: NO
B) SENSITIVITY TO STATIC DISCHARGE: NO
SECTION VI - ACCIDENTAL RELEASE
MEASURES
SMALL SPILL: Wipe up material with absorbant material. Use soap and water
immediately for easy cleanup.
LARGE SPILL: Contain spilled material with dike and pump salvageable material into
clean container for re-use. Mix remaining material with sand, aggregate or other
absorbant material and shovel into containers.
SECTION VII - SAFE HANDLING AND STORAGE
Keep material from freezing. Store in a cool, dry, well ventilated area. Do not take
internally.
DO NOT LET AIR INTAKES DRAW ODOR INDOORS
KEEP OUT OF REACH OF CHILDREN
SECTION VIII - EXPOSURE CONTROL/PERSONAL
PROTECTION
VENTILATION: ADEQUATE LOCAL EXHAUST. NO MECHANICAL NEEDED.
GLOVES: IMPERVIOUS OR RUBBER GLOVES.
For Product: 1724 Page No. 2
EYE PROTECTION: CHEMICAL OR SAFETY GLASSES.
INHALATION: NIOSH APPROVED CARTRIDGED RESPIRATOR WITH ORGANIC VAPOR CARTRIDGES SHOULD
BE WORN IN CONFINED AREA.
CLOTHING: NORMAL LONG-SLEEVED AND LONG-PANTS WORK CLOTHES. WEAR BOOTS, IMPERVIOUS
COATS AND FACE SHIELDS WHEREVER NECESSARY. CHANGE IMMEDIATELY IF CONTAMINATED AND
BE SURE TO WASH THOROUGHLY BEFORE REUSE.
HYGIENIC PRACTICES: DO NOT WEAR CONTACT LEASES WHEN HANDLING THIS MATERIAL. WASH
HANDS BEFORE EATING, SMOKING OR USING THE TOILET. DO NOT SMOKE IN ANY CHEMICAL
HANDLING OR STORAGE AREA. FOOD OF BEVERAGES SHOULD NOT BE CONSUMED IN THE AREAS
IMMEDIATE TO THE USE OF THIS PRODUCT. A COMPLETE SOAP/WATER SHOWER SHOULD BE
TAKEN AT THE END OF EACH WORK DAY. PROVIDE READILY AVAILABLE EYE WASH STATIONS
AND WASHING STATIONS.
OTHER PROTECTIVE EQUIPMENT: ON SPECIFIC SITUATIONS, SPECIAL RECOMMENDATIONS SHOULD
BE USED.
SECTION IX - PHYSICAL/CHEMICAL
CHARACTERISTICS
EVAPORATION RATE: <1 (Butyl Acetate = 1)
miscible
SOLUBILITY IN WATER:
0 0
BOILING POINT: 212 F (100 C) (water)
liquid
PHYSICAL STATE:
0
VAPOR PRESSURE: 18 mm Hg @ 20 C (water)
1.0 g/cc
SPECIFIC GRAVITY:
>1 (air = 1)
VAPOR DENSITY:
60-65%
VOLATILES:
0 0
FREEZING POINT: 32 F (0 C) (water)
9.0 - 11.0
pH:
ODOR AND APPEARANCE: brown-black liquid with mild oil/asphalt odor
SECTION X - STABILITY AND REACTIVITY DATA
STABILITY: Stable.
Avoid contact with water, acids, petroleum solvents and soaps.
MATERIALS TO AVOID:
HAZARDOUS DECOMPOSITION: Thermal decomposition may produce carbon monoxide and other
unknown organic compounds.
WILL POLYMERIZATION OCCUR: No
SECTION XI - TOXICOLOGICAL INFORMATION
No information available.
SECTION XII - ECOLOGICAL INFORMATION
No data available.
SECTION XIII - DISPOSAL CONSIDERATIONS
Dispose of according to applicable Federal, State, County, and Local requirements.
SECTION XIV - TRANSPORTATION INFORMATION
DOT-U.S./MOT-CANADA (All modes)
PROPER SHIPPING NAME: NONREGULATED MATERIALS
HAZARD CLASS: NOT APPLICABLE
IDENTIFICATION NO: NOT APPLICABLE
PACKAGING GROUP: NOT APPLICABLE
For Product: 1724 Page No. 3
SECTION XV - REGULATORY INFORMATION
WHMIS: This material contains the following ingredient(s) at, or above the
minimum concentration specified on the WHMIS Ingredient Disclosure List under
the Hazardous Products Act of Canada:
Stoddard Solvent CAS No. 8052-41-3 >1.0%
Potassium Hydroxide CAS No. 1310-58-3 >0.1%
SARA313: This product DOES NOT contain material(s) subject to the reporting
requirements under Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40 CFR 372.
VOC STATUS: <30 g/L VOCs max. This product complies with the VOC codes of CA, MA,
NJ, NY, and Jefferson County, KY for Architectural and Maintenance Coatings.
SECTION XVI - ADDITIONIAL INFORMATION
CHANGES: Section II. New MSDS Format.
Disclaimer
The information contained in this Material Safety Data Sheet has been prepared in accordance
with the OSHA Hazard communication Standard CFR 1910.1200. This information relates
specifically to the product designated and may not be valid for the product when used in
combination with any other materials or products or in a particular process. The information
is, to the best of our knowledge and belief, accurate and reliable as of the date compiled.
However, no representation, warranty or guarantee is made as to its accuracy, reliability or
completeness, whether originating within the company or not. The user should review this
information, satisfy itself as to its suitability and completeness, and pass on the information
to its employees or customers in accordance with applicable federal, state or local hazard
communications requirements. We do not accept responsibility for any loss or damage which may
occur from the use of this information.
M. SEIFRIED 09/25/98
Prepared By: Date:
John Wenneman Modified on: 04/30/2003 02:00:13 PM
Modified By:
End of MSDS Document
For Product: 1724 Page No. 4
|