HT 181 FILLER MATERIAL SAFETY DATA SHEET
PART NO. CS-600 (Sub-component of CS-460) Page 1 of 5
CS-620 (Sub-component of CS-462)
Effective Date: 03/18/2008
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
HMIS RATING
Tradename: RP 4014 RESIN 1 HEALTH 2
2 0 FLAMMABILITY 1
Chemical family: Epoxy REACTIVITY 0
NFPA RATING PROTECTIVE
Intended Use or Product Type: Heat resistant laminating. EQUIPMENT
SHIPPER EMERGENCY INFORMATION
Clock Spring Company, L.P. Emergency telephone number
14107 Interdrive West (CHEMTREC): (800) 424-9300
Houston, TX 77032 Other Calls: (800) 471-0060
2. COMPOSITION / INFORMATION ON INGREDIENTS
EXPOSURE LIMITS CARCINOGEN
STATUS
OSHA CAS# CHEMICAL IDENTITY AGGIH OSHA MFR IARC NTP OSHA
TWA STEL PEL STEL
2425-79-8 Oxirane, 2,2'-(1,4- NE NE NE NE NE NR NR NR
butanediylbis(oxymethylen)bis-
Common Name: Butanediol Diglycidyl Ether
25068-38-6 Phenol, 4,4'(1- NE NE NE NE NE NR NR NR
methylethylidene)bis-, polymer
with (chloromethyl) oxirane
Common Name: Bisphenol A Diglycidyl Ether
Polymer
28064-14-4 Phenol, polymer with NE NE NE NE NE NR NR NR
formaldehyde, glycidyl ether
Common Name: Epoxy Phenol Novalac
NE - Not Established NR - Not Reviewed
MSDS NO: 6082
HT 181 FILLER MATERIAL SAFETY DATA SHEET
PART NO. CS-600 (Sub-component of CS-460) Page 2 of 5
CS-620 (Sub-component of CS-462)
MSDS NO: 6082
3. HAZARDS IDENTIFICATION
Emergency Overview: Danger! Causes severe skin irritation. Causes eye irritation. May cause skin burns and allergic
skin reaction.
Primary Route(s) of Entry: Dermal; heated product may produce inhalable vapors.
4. FIRST AID MEASURES
First aid for ingestion:
If conscious, give plenty of water to drink. Do NOT induce vomiting. Call a physician.
First aid for skin:
Wash with soap and water. Remove contaminated clothing and launder before re-use.
First aid for inhalation:
Remove to fresh air. Give oxygen and/or artificial respiration, if needed. Call a physician.
First aid for eyes:
Immediately flush eyes with water for 15 minutes. Call a physician.
Overexposure Effects:
Causes severe skin irritation. Causes eye irritation. May cause skin burns and allergic skin reaction.
Medical Conditions Aggravated by Exposure:
Skin and eye conditions.
Additional Information:
Referral to a physician is recommended if there is any question about the serious of any injury.
5. FIRE FIGHTING MEASURES
o o
Flash Point: 300 F (149 C))
Flash Point Method Used: PMCC
Flammable Limits in Air (lower - % by volume): Not established yet
Flammable Limits in Air (upper - % by volume): Not established yet
Fire Fighting Extinguishing Media: Carbon dioxide, dry chemical, foam, water.
Fire Fighting Equipment: Use self-contained breathing apparatus.
Fire and Explosion Hazards: Decomposition and combustion products may be toxic.
6. ACCIDENTAL RELEASE MEASURES
Spill control:
Remove spillage by absorbing in absorbent material. Avoid contact.
MSDS NO: 6082
HT 181 FILLER MATERIAL SAFETY DATA SHEET
PART NO. CS-600 (Sub-component of CS-460) Page 3 of 5
CS-620 (Sub-component of CS-462)
7. HANDLING AND STORAGE
Handling precautions:
Danger! Causes severe skin irritation. Causes eye irritation. May cause skin burns and allergic skin reaction. Avoid
contact with eyes, skin, or clothing. Avoid prolonged or repeated contact with skin. Wash thoroughly after handling.
Other handling information:
Nuisance dust may be generated when sanding or sawing cured material.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Skin protection:
Impermeable gloves and protective clothing.
Respiratory Protection:
Use NIOSH approved organic vapor cartridge respirator when vapor/mist exposure is likely.
Eye protection:
Wear splash-proof chemical goggles.
Engineering controls:
General mechanical and local exhaust in accordance with ACGIH recommendations.
9. PHYSICAL AND CHEMICAL PROPERTIES
Color: Grey
Physical State: Filled Liquid
Solubility in Water: Negligible
o o
Vapor Pressure: 0.0073 mm Hg at 80 C (176 F)
Specific Gravity: 1.3 - 1.36 (water = 1)
Boiling Point: Not determined
Evaporation Rate: Not determined
Vapor Density: Not determined
VOC: 0 g/L
pH Not determined
Percent Volatile: Negligible
10. STABILITY AND REACTIVITY
Conditions to avoid:
Excessive heat for prolonged periods of time.
Stability:
Stable.
Incompatibility:
Strong oxidizing agents, acids, and bases.
Hazardous Decomposition Products:
Combustion may form toxic materials, such as carbon dioxide, carbon monoxide.
Hazardous Polymerization: Will not occur.
MSDS NO: 6082
HT 181 FILLER MATERIAL SAFETY DATA SHEET
PART NO. CS-600 (Sub-component of CS-460) Page 4 of 5
CS-620 (Sub-component of CS-462)
11. TOXICOLOGICAL INFORMATION
Sensitization:
Possible in susceptible individuals.
Skin Irritation: .
Severe skin irritant.
Eye Irritation:
Irritant.
12. ECOLOGICAL INFORMATION
13. DISPOSAL CONSIDERATIONS
Waste disposal method:
Consult qualified local or corporate personnel for method that will comply with local, state and federal health and
environmental regulations.
14. TRANSPORT INFORMATION:
DOT: Non-Bulk
Proper shipping name: Resin compounds, N.O.I.
Department of Transportation: Not regulated as a hazardous material by the U.S. Dept. of Transportation
(DOT) 49 CFR 172.101 hazardous materials table.
15. REGULATORY INFORMATION
OSHA Status: This Material Safety Data Sheet (MSDS) has been prepared in compliance with the federal OSHA Hazard
Communication Standard 29 CFR 1910.1200. This product is considered to be a hazardous chemical under that
standard.
TSCA Inventory Status: Chemical components listed on TSCA Inventory.
SARA Title III: Section 313 - Toxic Chemical(s): This product does not contain a toxic chemical for routine annual Toxic
Chemical Release Reporting' under Sec. 313 (40 CFR 372).
RCRA: Not a hazardous waste under RCRA (40 CFR 261).
MSDS NO: 6082
HT 181 FILLER MATERIAL SAFETY DATA SHEET
PART NO. CS-600 (Sub-component of CS-460) Page 5 of 5
CS-620 (Sub-component of CS-462)
California Proposition 65: The following is required composition information. This product contains the following
chemicals that are listed on the California list of Known Carcinogens and reproductive Toxins.
Chemical Name: Oxirane, (phenoxymethyl)
CASRN: 122- 60-1
Common Name: Phenyl Glycidyl Ether
% in Composition: 0.00
Comment: Warning! This chemical is known to the state of California to cause cancer.
Chemical Name: Oxirane, (Chloromethyl)-
CASRN: 106-89-8
Common Name: Epichlorohydrin
% in Composition: Trace
Comment: Warning! This chemical is known to the state of California to cause cancer and birth defects or
other reproductive harm.
Pennsylvania Right to Know: The following is required composition information:
Chemical Name: Phenol, 4,4'(1-methylethylidene)bis-, polymer with (chloromethyl) oxirane
CASRN: 25068-38-6
Common Name: Bisphenol A Diglycidyl Ether Polymer
Comment: Not on Pennsylvania Hazardous Substance List.
Chemical Name: LIMESTONE
CARSN: 1317-65-3
Comment: Hazardous Substance
Chemical Name: Phenol, polymer with formaldehyde, glycidyl ether
CARSN: 28064-14-4
Common Name: Epoxy Phenol Novolac
Comment: Not on Pennsylvania Hazardous List.
Chemical Name: Oxirane, 2,2'-(1,4-butanediylbis(oxymethylene)bis-
CASRN: 2425-79-8
Common Name: Butanediol Diglycidyl Ether
Comment: Not on Pennsylvania Hazardous Substance List.
Chemical Name: TALC (MG3H2(SIO3)4)
CARSN: 14807-96-6
Comment: Hazardous Substance.
VOC's: 0 grams/liter (state of California).
16. OTHER INFORMATION:
MSDS No. 6082
Approved by: Jim Souza
Title: SH&E Manager
Disclaimer: This material will not be sold for use in products for which prolonged contact with mucous membranes or abraded skin, or implantation
within the human body, is specifically intended. Because of the wide range of such potential uses, Clock Spring Company, L.P. is not able to
recommend this material as safe and effective for such uses and assumes no liability for any such uses.
MSDS NO: 6082
|