MATERIAL SAFETY DATA SHEET
ESC-3000 Epoxy Floor Covering: PART A
SECTION 1 -- MATERIAL IDENTIFICATION
PRODUCT NAME: StaticWorx ESC-3000 Epoxy - Part A
PRODUCT USE/CLASS: Esc-3000 Epoxy
SUPPLIER: StaticWorx Inc.
PO Box 590069.
Newton, MA 02459
www.staticworx.com
TELEPHONE NUMBER: 617-923-2000
EMERGENCY TELEPHONE NUMBER: 800-424-9300
REVISION DATE: 07/08/2004
SECTION 2 -- COMPOSITION/INFORMATION ON INGREDIENTS
CHEMICAL NAME CAS Number Weight % Less Than ACGIH (TLV-TWA) OSHA (PEL-TWA)
Bis-A Liquid Epoxy Resin 25085-99 -8 35% N.E. N.E.
Benzyl Alcohol 100-51-6 10% N.E. N.E.
3 -TOTL 80MG/M 3 /%SiO
AMORPHOUS SILICA 7631-86-9 10.0 10MG/M
3 10 mg/m 3
Titanium Dioxide 13463-67-7 5.0 10 mg/m
MG/M3 0.5 MG/M 3
Antimony 7440-36-0 5.0 0.5
3 5 MG/M 3
CALCIUM OXIDE 1305-78-8 5.0 2 MG/M
SECTION 3 -- HAZARDOUS IDENTIFICATIONS
EMERGENCY OVERVIEW: Causes eye irritation. Causes skin irritation. May cause allergic skin reaction.
POTENTIAL HEALTH EFFECTS DUE TO OVEREXPOSURE:
EYE CONT ACT: Extremely irritating to the eyes and may cause severe damage, including blindness. Substance causes severe
eye irritation. Injury may be permanent.
SKIN CONT ACT: May cause skin sensitization, an allergic reaction, which becomes evident on reexposure to this material.
INHALATION: High vapor concentrations are irritating to the eyes, nose, throat and lungs.
INGESTION: Substance may be harmful if swallowed.
CHRONIC HAZARDS:
Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous
system damage.
PRIMARY ROUTES OF ENTRY: Skin Contact, Inhalation, Eye Contact.
ESC-3000 Epoxy 02/05 -- Page 1
SECTION 4 -- FIRST AID MEASURES
EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention.
SKIN CONTACT: Wash with soap and water. Get medical attention if irritation develops or persists. Immediately remove
contaminated clothing.
INGESTION: If swallowed, do not induce vomiting. Give victim a glass of water or milk. Call a physician or poison control
center immediately. Never give anything to an unconscious person.
INHALATION: Remove to fresh air. Restore breathing if necessary. If breathing is difficult, give oxygen. Get medical attention.
DO NOT LEAVE VICTIM UNATTENDED.
SECTION 5-- FIRE-FIGHTING MEASURES AND FIRE HAZARDS
FLASH POINT(Setaflash): >200?F
LOWER EXPLOSIVE LIMIT: UPPER EXPLOSIVE LIMIT:
0.6 % 9.0 %
EXTINGUISHING MEDIA: Dry Chemical, Foam, Water Fog.
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS TESTED TO BE GREATER THAN 200 DEGREES FAHRENHEIT
SPECIAL FIRE-FIGHTING PROCEDURES: Evacuate area and fight fire from a safe distance. Full protective equipment including
self-contained breathing apparatus should be used. Water may be used to cool closed containers to prevent buildup of steam.
SECTION 6 -- ACCIDENTAL RELEASE MEASURES (SPILLS OR LEAKS)
STEPS TO BE T AKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. Do not use combustible
materials such as sawdust. Dispose of according to Local, State (Provincial) and Federal regulations. DO NOT INCINERATE
CLOSED CONTAINERS.
SECTION 7 -- HANDLING AND STORAGE
HANDLING: Wash thoroughly after handling. Use only in a well-ventilated area. Follow all MSDS/Label precautions even after
container is emptied because it may retain product residues. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame.
SECTION 8 -- EXPOSURE CONTROLS, PERSONAL PROTECTION
RESPIRA TORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with an
organic vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expect-
ed to exceed exposure limits.
Protection provided by air purifying respirators is limited. Use a positive pressure air supplied respirator if there is any potential
for an uncontrolled release, exposure levels are not known, or any other circumstances where air purifying respirators may not
provide adequate protection.
Continued on next page ...
ESC-3000 Epoxy 02/05 -- Page 2
SECTION 8 -- EXPOSURE CONTROLS, PERSONAL PROTECTION ... continued
SKIN PROTECTION: Nitrile or Neoprene gloves may afford adequate skin protection. Use gloves to prevent prolonged skin
contact.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
ENGINEERING CONTROLS: Prevent buildup of vapors by opening all doors and windows to achieve cross-ventilation. Use
process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below recommended
exposure limits.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further information regarding personal
protective equipment and its application.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated
clothing immediately and launder before reuse.
SECTION 9 -- PHYSICAL AND CHEMICAL PROPERTIES
SPECIFIC GRAVITY: 1.3201 Ph: N.A.
BOILING RANGE: 205 - 350癋 FREEZE POINT: N.A.
ODOR: Not Applicable. SOLUBILITY IN WATER: Slightly Soluble
APPEARANCE: Liquid PHYSICAL STATE: Liquid
VAPOR DENSITY: Heavier than air. EVAPORATION RATE: Slower than Ether.
SECTION 10 -- STABILITY AND REACTIVITY
CONDITIONS TO A VOID: Avoid temperatures above 120癋.
INCOMPATIBLE MATERIALS: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
HAZARDOUS DECOMPOSITION PRODUCTS: When heated to decomposition it emits acrid smoke and irritating fumes.
HAZARDOUS POLYMERIZATION: No Information.
STABILITY: No Information.
SECTION 11 -- TOXICOLOGICAL INFORMATION
Product LD50: N.D. Product LC50: N.D.
CHEMICAL NAME LD50 LC50
Bis-A Liquid Epoxy Resin >5000 mg/kg (RAT) N.D.
Benzyl Alcohol 1230 mg/kg (ORAL, RAT) 1000 PPM (8HR, RAT)
>250mg/m 3 (RAT, 6HR)
Amorphous Silica >7500 mg/kg (RAT)
Titanium Dioxide >7500 mg/kg (ORAL, RAT) N.D.
Antimony 7000 mg/kg (RAT)
Calcium Oxide
ESC-3000 Epoxy 02/05 -- Page 3
SECTION 12 -- ECOLOGICAL INFORMATION
Product is a mixture of listed components.
SECTION 13 -- DISPOSAL CONSIDERATIONS
Dispose of in accordance to all Federal, State and Local regulations.
Do not allow to enter storm drains or sewer systems.
PROPER WASTE DISPOSAL IS THE RESPONSIBILITY OF THE OWNER OF THE WASTE!
SECTION 14 -- TRANSPORTATION INFORMATION
D.O.T.:
PROPER SHIPPING NAME: P AINT U.N.#:
HAZARD CLASSIFICATION: PACKING GROUP:
ALL PACKAGED MATERIAL MUST BE LABELED IN ACCORDANCE WITH D.O.T. AND OSHA STANDARDS.
SECTION 15 -- REGULATORY INFORMATION
CERCLA - SARA Hazard Category
This product has been reviewed according to the EPA "Hazard Categories" promulgated under Sections 311 and 312 of the
Superfund Amendment and Reauthorization Act of 1986 (SARA Title III) and is considered, under applicable definitions, to meet
the following categories:
IMMEDIATE HEALTH HAZARD, CHRONIC HEALTH HAZARD
SARA Section 313:
Listed below are the substances (if any) contained in this product that are subject to the reporting requirements of Section 313
of Title III of the Superfund Amendment and Reauthorization Act of 1986 and 40 CFR part 372:
Chemical Name CAS Number
Antimony 7440-36-0
Toxic Substances Control Act:
Listed are the substances (if any) contained in this product that are subject to the reporting requirements of TSCA 12(B) if
exported from the United States: -- None Known --
U.S. State Regulations: As follows -
New Jersey Right-to-Know:
The following materials are non-hazardous, but are among the top five components in this product.
Chemical Name CAS Number
Liquid Bis-A Epoxy Alkyl Monoglycidyl Ether Mixture MIXTURE
Electroconductive Tin Oxide MIXTURE
Continued on next page...
ESC-3000 Epoxy 02/05 -- Page 4
SECTION 15 -- REGULATORY INFORMATION ... continued
GLYCIDYL ETHER 120547-52-6
Epoxy Pigment Dispersion MIXTURE
Epoxy Pigment Dispersion MIXTURE
Liquid Epoxy Mixed Metal Oxides Pigment Dispersion MIXTURE
California Proposition 65:
Warning: The following ingredients present in the product are known to the state of California to cause Cancer:
Chemical Name CAS Number
Phenyl glycidyl ether 122-60-1
Warning: The following ingredients present in the product are known to the state of California to cause birth defects, or other
reproductive hazards: -- None Known --
INTERNATIONAL REGULATIONS: As follows -
CANADIAN WHMIS:
This MSDS has been prepared in compliance with Controlled Product Regulations except for the use of the 16 headings.
CANADIAN WHMIS CLASS: D2B
SECTION 16 -- OTHER INFORMATION
HMIS Ratings:
Health: 1 Flammability: 0 Reactivity: 0 Personal Protection: X
VOLATILE ORGANIC COMPOUNDS, g/l:
REASON FOR REVISION:
Legend: N.A. - Not Applicable, N.E. - Not Established, N.D. - Not Determined
The information contained on this MSDS has been checked and should be accurate. However, it is the responsibility of the user
to comply with all Federal, State, and Local laws and regulations.
ESC-3000 Epoxy 02/05 -- Page 5
|