MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Name: Henry 317 Multi-Purpose Construction Adhesive
317
Description: Filled water-dispersed latex adhesive
II. TRANSPORTATION DATA
SHIPPING NAME: Not Classified. HAZARD CLASS: N/A. ID#: N/A.
Revised 7/97
EMERGENCY ONLY CONTACT: CHEM-TEL-1-800-255-3924
III. HMIS (0=minimal hazard; 4 = severe hazard)
The W.W. Henry Company
400 Ardex Park Drive
Health = 1 Flammability = 1 Reactivity = 0
Aliquippa, PA 15001
IV. PRODUCT CONTENT
(724) 203-8000
This product contains chemicals subject to the reporting requirements of Visit our Website: http://www.wwhenry.com
Section 313 of SARA Title III and 40 CFR 372. All components are on TSCA
inventory. This product does NOT contain asbestos.
V. HAZARDOUS INGREDIENTS
INGREDIENT: PERCENT OCCUP. EXPOS. LMT.
PEL: TLV:
VM&P Naphtha CAS #64742-89-8 2-3 300 ppm 300 ppm
STEL: 400 ppm
Toluene CAS #108-88-3 1 100 ppm 50 ppm
STEL: 150 ppm (Skin)
VI. PHYSICAL DATA X. SPILL OR LEAK PROCEDURES
APPEARANCE: Off white paste. ODOR: Mild solvent odor. BOILING STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Ventilate
POINT: Approx. 212癋 (Similar to water). MELTING POINT: N/A. VAPOR area of spill or release. Contain spill, preventing it from entering sewer
PRESSURE (mm Hg @ 20癈): N/K. VAPOR DENSITY: Heavier than air. % lines or waterways. Use absorbent to assist with the pick-up of material.
VOLATILE BY WEIGHT (30 min. @ 275癋): 17.0. EVAPORATION RATE: Scrape up product and place into container. Residual of product, while
< 1. WT/GAL (water =8.3): 12.0. SOLUBILITY IN WATER: Miscible. still wet, can be cleaned up with warm soapy water. WASTE DISPOSAL
SPECIFIC GRAVITY: 1.45. VOC: 47-61 g/l calculated at 70癋/21癈, METHOD: Dispose of container and any unused contents in accordance
SCAQMD. pH: 9.45. Non-Photochemically reactive. with Federal, State, and Local Waste Disposal Regulations. Do not flush
unused contents or residue down drains. Do not reuse container.
VII. FIRE AND EXPLOSION HAZARD DATA
XI. SAFE HANDLING AND USE INFORMATION
FLASH POINT (METHOD): > 200癋 (Setaflash Closed Tester)
FLAMMABLE RANGE: LEL: N/A; UEL: N/A. EXTINGUISHING MEDIA: VENTILATION: Use natural cross-ventilation, local (mechanical) pick-up,
Carbon dioxide, dry chemical, Halon, water spray. SPECIAL FIRE FIGHT- and/or general area (mechanical) ventilation to prevent an accumulation
ING PROCEDURES: Protect fire fighters from toxic products of combustion of solvent vapors, keeping in mind that the ventilation pattern must
by wearing self-contained breathing apparatus. UNUSUAL FIRE AND remove the heavier-than-air solvent vapors from the lower levels of the
EXPLOSION HAZARDS: Closed containers in a fire may rupture due to work spaces. The ventilation should be sufficient to keep the solvent
pressure build-up; use water to cool containers to prevent this. vapor concentration below the TLV. RESPIRATORY PROTECTION: With
adequate ventilation, respiratory equipment should not be needed. If ade-
quate ventilation is not afforded, wear respiratory equipment approved for
VIII. HEALTH HAZARD DATA
organic vapors. SKIN AND EYE PROTECTION: During normal end-prod-
uct use, cotton or loop-pile gloves and spectacle-type safety glasses are
PRIMARY ROUTE(S) OF ENTRY: Inhalation, ingestion, and direct dermal
recommended to prevent contact with this mastic product.
exposure. TARGET ORGANS: Upper respiratory tract, skin, eyes.
EFFECTS OF OVEREXPOSURE: SKIN AND EYES: Excessive skin contact
may cause drying and cracking of the skin, defatting of tissue, and result XII. SPECIAL PRECAUTIONS
in dermatitis. Contact with eyes may cause irritation. INHALATION:
VM&P Naphtha and toluene may cause irritation of respiratory tract, PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Store in
coughing, and CNS effects such as headache, dizziness, drowsiness or an area suitable for combustible mixtures. Recommended storage tem-
nausea. CARCINOGENICITY: NTP: No; IARC Monographs: No; OSHA perature is below 90?F. OTHER PRECAUTIONS: Vapors are heavier-than-
Regulated: No. MEDICAL CONDITIONS GENERALLY AGGRAVATED BY air. Use precautions that are common with the safe handling of com-
EXPOSURE: Any condition generally aggravated by solvents, including bustible liquids. WARNING: This product contains toluene; a chemical
preexisting upper respiratory and lung disease such as, but not limited to known to the state of California to cause birth defects or other reproduc-
bronchitis, emphysema, and asthma. Existing skin conditions. FIRST AID tive harm. WORK SITE ENVIRONMENT: Initially there may be a potential
PROCEDURES: SKIN AND EYES: Flush any eye contact with plenty of adverse impact on indoor air quality within the general work area during
water. Additionally with skin contact, wash with soap and water. Refer to the installation process. Therefore you should advise the building man-
physician if irritation or symptoms persist. INHALATION: Remove to fresh ager or other appropriate person that: ?It will be necessary to establish
air if exposed to excess concentrations of vapor. Seek medical attention if and maintain adequate ventilation of the work area, without causing the
symptoms persist. INGESTION: Do not induce vomiting. Call a Poison entry of contaminants to other parts of building; and ?Persons who are
Control Center or physician for guidance. sensitive to odors and/or chemicals should be advised to avoid the work
area during this process.
IX. REACTIVITY DATA
The information presented herein is supplied as a guide to those who han-
STABILITY: Stable. INCOMPATIBILITY: Strong oxidizing agents. HAZ- dle or use this product. Safe work practices must be employed when
ARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon working with any materials. It is important that the end user makes a
dioxide, and other toxic vapors and gases that are common to thermal determination regarding the adequacy of the safety procedures employed
degradation of organic compounds. HAZARDOUS POLYMERIZATION: during the use of this product.
Will not occur.
N/A - not applicable or not available
N/K - none known or not known
|