Material Safety Data Sheet

Kilfrost Tool Oil

Product Description: A synthetic lubricant which combines permanently with water. It positively prevents the

freezing of pneumatic equipment and provides superior lubrication of working surfaces in the tool. (Ingersoll

Rand Part # 3537918, 35379726, 35379734, 35379742)

Transportation Emergency Response

CHEMTREC: (800) 424-9300 or (202) 483-7616





SECTION 1 COMPOSITION/ INFORMATION ON INGREDIENTS

COMPONENTS                               CAS NUMBER                         AMOUNT

                                                                            100 mg/M3 (as an aerosol)

Ethylene glycol                          107-21-1

Water                                    7732-18-5                          NE

Synthetic sulfonated hydorcarbon         78330-12-8,                        NE

Triethanolamine Napthenate               68410-61-7                         NE

Oleyl Alcohol                            143-28-2                           NE



 SECTION 2 FIRST AID MEASURES

Eye: Immediately flush with water, and continue washing the eyes for several minutes.

Skin: Remove contaminated clothing and flush skin with water.

Ingestion: If conscious, give two glasses of water and induce vomiting. Call a physician immediately.

Inhalation: Remove to fresh air. Call a physician if discomfort persists.

NOTES TO PHYSICIAN: The principal toxic effects of ethylene glycol, when swallowed, are kidney damage and

metabolic acidosis. Ethanol is antidotal, and its early administration may block the formation of nephrotoxic

metabolites of ethylene glycol in the liver. Ethanol should be given intravenously, as a 5% solution in sodium

bicarbonate, at a rate of about 10mL ethanol per hour. A desired thereapeutic level of ethanol in blood is 100

mg/dl. Hemodialysis may be required. Pulmonary edema with hypoxemia has been described in a number of

patients following poisoning with ethylene glycol. The mechanism of production has not been elucidated, but it

appears to be noncardiogenic in origin in several cases. Respiratory support with mechanical ventilation and

positive end-expiratory pressure may be required.



 SECTION 3 FIRE FIGHTING MEASURES

FIRE CLASSIFICATION:

OSHA Classification (29 CFR 1910.1200): Not classified by OSHA as flammable or combustible.

NFPA RATINGS:            Health: 1      Flammability: 0 Reactivity: 0

(0-Least, 1-Slight, 2-Moderate, 3-High, 4-Extreme)

FLAMMABLE PROPERTIES:

Flashpoint: NA

Autoignition: NE

Flammability (Explosive) Limits (% by volume in air): Lower: NA Upper: NA

EXTINGUISHING MEDIA: Alcohol type or all purpose type foams for large fires, water spray , carbon dioxide or

dry chemical media for small fires.







_____________________________________________________________________

Revision Number: 0                                1 of 3              Kilfrost Tool Oil

Revision Date: 11/04/2003

 SECTION 4 ACCIDENTAL RELEASE MEASURES

Waste Disposal Method: Dispose in accordance with local, state, or federal regulations. Dispose of absorbed

material at an approved waste site or facility.

Steps to be taken in Case of Spills: Keep product out of sewers and watercourses by diking or impounding.

Absorb with san or inert material. Sweep or scoop up and remove. Prevent spread of spill. Advise authorities

with local regulations.



 SECTION 5 EXPOSURE CONTROLS/PERSONAL PROTECTION

Exposure limit for total product : 50 PPM ceiling for vapor and mist combined. ACGIH: 1984-85

Swallowing: May cause abdominal discomfort or pain, dizziness, malaise, lumbar pain, oliguria, uremia, and

central nervous system depression. Severe kidney damage follows the swallowing of large volumes of ethylene

glycol. May be fatal.

Inhalation: May cause irritation of the nose and throat with headache, particularly from mists. High vapor

concentrations caused, for example, by heating the material in an enclosed and poorly ventilated workplace may

produce nausea, vomiting, headache, and dizziness.

Skin Contact: No evidence of adverse health effects from available information.

Eye Contact: Liquid, vapor, and mist may cause discomfort in the eye with transient conjunctivitis. Serious

corneal injury is not anticipated.

Effects of repeated overexposure: Inhalation of mist may produce signs of central nervous system

involvement, particularly dizziness and nystagmus.



 SECTION 6 PHYSICAL AND CHEMICAL PROPERTIES

Attention: the data below are typical values and do not constitute a specification.

 Color: Clear yellow      Vapor Density (Air = 1): NE

 liquid

 Physical State: Liquid   Boiling Point: Wide range

 Odor: Chemical odor      Solubility: Soluble in H2O

 pH: NA                   Freezing Point: NE

 Vapor Pressure: NE         Specific Gravity: > 1.0 @ 25°C /



 SECTION 7 STABILITY AND REACTIVITY

Chemical Stability: This material is considered stable under normal ambient and anticipated storage and

handling conditions of temperature and pressure.

Incompatibility With Other Materials: May react with strong oxidizing agents, such as liquid chlorine,

concentrated oxygen, sodium hypochlorite or calcium hypochlorite, etc., as this represents a serious explosion

hazard.

Hazardous Decomposition Products: Fumes, smoke, carbon monoxide, oxides of sulfur, and other

decomposition products, in case of incomplete combustion.

Hazardous Polymerization: Hazardous polymerization will not occur.



 SECTION 8 ECOLOGICAL INFORMATION

Oral, dermal, eye, inhalation, chronic, subchronic, etc. NE

WHMIS: Does not meet the definition of a controlled product under the WHMIS regulations

DSL: All components are listed in DSL, except one. This one chemical appears on the NDSLlist, and is present

in the product at <5% (wt.).



 SECTION 9 TRANSPORT INFORMATION

DOT Shipping Name: NOT REGULATED AS A HAZARDOUS MATERIAL FOR TRANSPORTATION UNDER

49 CFR

DOT Hazard Class: NOT HAZARDOUS BY U.S. DOT. ADR/RID HAZARD CLASS NOT APPLICABLE.



SECTION 10 REGULATORY INFORMATION



SARA 313 CATEGORIES: This product contains ethylene glycol, 107.21.1 @ 59.5%

For WHMIS and DSL information, see Section 8.



_____________________________________________________________________

Revision Number: 0                                2 of 3             Kilfrost Tool Oil

Revision Date: 11/04/2003

SECTION 11 OTHER INFORMATION



The above information is accurate to the best of our knowledge. However, since data, safety

standards, and government regulations are subject to change and the conditions of handling and

use, or misuse beyond our control, seller makes no warranty, either express or implied, with

respect to the completeness or continuing accuracy of the information contained herein and

disclaims all liability for reliance thereon. User should satisfy himself that he has all current data

relevant to his particular use.









_____________________________________________________________________

Revision Number: 0                             3 of 3             Kilfrost Tool Oil

Revision Date: 11/04/2003