MATERIAL SAFETY DATA SHEET
MSDS 0236
=============================================================================
Section 1 -- PRODUCT AND COMPANY IDENTIFICATION
-----------------------------------------------------------------------------
HMIS CODES
PRODUCT NAME Health 1
Fluorocleen Flammability 2
Reactivity 0
PRODUCT CODES PPI B
65602
CHEMICAL FAMILY
Organic
USE
Leak Locator
MANUFACTURER'S NAME EMERGENCY TELEPHONE NO.
The RectorSeal Corporation Chemtrec 24 Hours
2601 Spenwick Drive (800) 424-9300
Houston, Texas 77055 USA
DATE OF PREPARATION TECHNICAL SERVICE TELEPHONE NO.
August 22, 2002 (800) 231-3345
=============================================================================
Section 2 -- COMPOSITION/INFORMATION ON INGREDIENTS
-----------------------------------------------------------------------------
% by WT CAS No. INGREDIENT UNITS
86.29 64742-47-8 Mineral Spirits
ACGIH TLV N/D
OSHA PEL N/D
NIOSH REL 100 mg/m3
9.72 5131-66-8 Propylene Glycol Ether
ACGIH TLV N/D
OSHA PEL N/D
2.78 10024-97-2 Nitrous Oxide
ACGIH TLV 50 ppm
OSHA PEL N/D
=============================================================================
Section 3 -- HAZARDS IDENTIFICATION
-----------------------------------------------------------------------------
SUMMARY OF ACUTE HAZARDS
Irritation to eyes, nose, and throat; drowsiness, narcosis, tremors, and
other CNS effects at high concentrations. Skin irritation, dermatitis, and
defatting.
ROUTE OF EXPOSURE, SIGNS AND SYMPTOMS
INHALATION
Nasal and respiratory irritation, dizziness, narcosis, headache, nausea,
CNS depression, and unconsciousness.
EYE CONTACT
Watering, blurred vision, inflammation, and irritation which can result in
corneal injury.
SKIN CONTACT
Irritation, dermatitis.
INGESTION
Nausea, vomiting; CNS depression; irritation of gastrointestinal tract,
liver and peritoneal wall; lung congestion.
SUMMARY OF CHRONIC HAZARDS
Skin irritation, contact dermatitis, and defatting.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
Individuals with pre-existing or chronic diseases of the eyes, skin,
respiratory system, cardiovascular system, gastrointestinal system, liver,
or kidneys may have increased susceptibility to excessive exposure.
=============================================================================
Section 4 -- FIRST AID MEASURES
-----------------------------------------------------------------------------
If INHALED: If overcome by exposure, remove victim to fresh air
immediately. Give oxygen or artificial respiration as
needed. Obtain emergency medical attention. Prompt
action is essential.
If on SKIN: Immediately wash with soap and water. Remove and wash
any contaminated clothing.
If in EYES: Flush eyes with large amounts of water for 15 minutes.
Get medical attention if irritation persists.
If SWALLOWED: If swallowed, call a physician immediately. Only induce
vomiting at the instruction of a physician. Never give
anything by mouth to an unconscious person.
=============================================================================
Section 5 -- FIRE FIGHTING MEASURES
-----------------------------------------------------------------------------
FLASH POINT LEL UEL
107 F(42 C) SETA CC, N/D N/D
Positive Flame Extension, (NFPA) Level 3 Aerosol
EXTINGUSING MEDIA
Foam, dry chemical, CO2, or water fog.
SPECIAL FIRE FIGHTING PROCEDURES: Wear self-contained full face piece
breathing apparatus and full body protective clothing. Hazardous
decomposition products possible (see Section 10). Evacuate area. Dike area
as run-off may create additional environmental contamination.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Aerosol cans are under pressure -
exposure to temperatures above 120F can cause bursting or "rocketing" of
cans.
=============================================================================
Section 6 -- ACCIDENTAL RELEASE MEASURES
-----------------------------------------------------------------------------
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Remove all
sources
of ignition. Use absorbent materials to prevent footing hazard and to
contain.
Ventilate area with natural or explosion-proof, forced air ventilation.
Avoid
flushing into sewers, drains, waterways, and soil. Wear protective clothing
and respiratory protection during cleanup.
=============================================================================
Section 7 -- HANDLING AND STORAGE
-----------------------------------------------------------------------------
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Shake well before using.
Keep away from heat, sparks and open flames. Prolonged exposure to direct
sunshine or storage above 120 F may cause can to burst. Do not puncture or
incinerate can.
OTHER PRECAUTIONS: Avoid prolonged or repeated contact with skin or
clothing.
Empty containers may contain residues; treat as if full and observe all
products precautions. Do not reuse empty containers.
=============================================================================
Section 8 -- EXPOSURE CONTROLS/PERSONAL PROTECTION
-----------------------------------------------------------------------------
RESPIRATORY PROTECTION (SPECIFY TYPE): In confined, poorly ventilated areas,
use NIOSH/MSHA approved air purifying or supplied air respirators during
soldering operations until fumes have dissipated.
VENTILATION - LOCAL EXHAUST: Acceptable
SPECIAL: Explosion proof
MECHANICAL (GENERAL): Acceptable
OTHER: N/A
PROTECTIVE GLOVES: Wear rubber gloves.
EYE PROTECTION: Safety glasses (ANSI Z-87.1 or equivalent)
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Chemical resistant coveralls
recommended.
WORK/HYGIENIC PRACTICES: Where use can result in skin contact, wash exposed
areas thoroughly before eating, drinking, smoking, or leaving work area.
Launder contaminated clothing before reuse.
=============================================================================
Section 9 -- PHYSICAL AND CHEMICAL PROPERTIES
-----------------------------------------------------------------------------
BOILING POINT: >212 F (100 C) @ 760mm Hg
SPECIFIC GRAVITY (H20 = 1): 0.79
VAPOR PRESSURE (mm Hg): N/D
MELTING POINT: N/A
VAPOR DENSITY (AIR = 1): <1
EVAPORATION RATE (ETHYL ACETATE = 1): >1
APPEARANCE/ODOR: Clear / Petroleum Odor
SOLUBILITY IN WATER: Soluble
=============================================================================
Section 10 -- STABILITY AND REACTIVITY
-----------------------------------------------------------------------------
STABILITY: Stable
CONDITIONS TO AVOID: Do not store in temperatures above 120 F.
INCOMPATIBILITY (MATERIALS TO AVOID): Oxidizers, acids and bases.
HAZARDOUS DECOMPOSITION PRODUCTS: CO, CO, and fragmented hydrocarbons.
HAZARDOUS POLYMERIZATION: Will not occur.
=============================================================================
Section 11 -- TOXICOLOGY INFORMATION
-----------------------------------------------------------------------------
CHRONIC HEALTH HAZARDS
No ingredient in this product is an IARC, NTP or OSHA listed carcinogen.
-----------------------------------------------------------------------------
TOXICOLOGY DATA
Ingredient Name
-----------------------------------------------------------------------------
Mineral Spirits
Oral-Rat LD50:>34,600 mg/kg
Inhalation-Rat LC50:>21,400 mg/m3/4H
Propylene Glycol Ether
Skin-Rabbit, adult LD50:3100 mg/kg
Inhalation-Rat LC50:N/D
Nitrous Oxide
Oral-Rat LD50:N/D
Inhalation-Rat LC50:160 mg/m3/6H
=============================================================================
Section 12 -- Ecological Information
-----------------------------------------------------------------------------
ECOLOGICAL DATA
Ingredient Name
-----------------------------------------------------------------------------
Mineral Spirits
Food Chain Concentration Potential N/D
WATERFOWL TOXICITY N/D
BOD N/D
AQUATIC TOXICITY N/D
Propylene Glycol Ether
Food Chain Concentration Potential N/D
WATERFOWL TOXICITY N/D
BOD N/D
AQUATIC TOXICITY N/D
Nitrous Oxide
Food Chain Concentration Potential None
WATERFOWL TOXICITY None
BOD None
AQUATIC TOXICITY None
=============================================================================
Section 13 -- DISPOSAL CONSIDERATIONS
-----------------------------------------------------------------------------
Waste Classification: Aerosols
Disposal Method: Empty containers can be disposed of in trash. Full
containers should be depressurized to separate liquid phase. The liquid
phase is considered a D001 ignitable waste and should be incinerated.
Dispose of all liquid waste in accordance with all local, state and federal
regulations.
=============================================================================
Section 14 -- TRANSPORTATION INFORMATION
-----------------------------------------------------------------------------
DOT: Consumer Commodity ORM-D
OCEAN (IMDG): Aerosols, Class 2.1, UN 1950, IMDG#2102, EMS#2-13
AIR (IATA): Aerosols, Class 2.1, UN 1950, ERG#126
WHMIS (CANADA): Class A
=============================================================================
Section 15 -- REGULATORY INFORMATION
-----------------------------------------------------------------------------
REGULATORY DATA
Ingredient Name
-----------------------------------------------------------------------------
Mineral Spirits
SARA 313 No
TSCA Inventory Yes
CERCLA RQ N/A
RCRA Code N/A
Propylene Glycol Ether
SARA 313 No
TSCA Inventory Yes
CERCLA RQ N/A
RCRA Code N/A
Nitrous Oxide
SARA 313 No
TSCA Inventory Yes
CERCLA RQ N/A
RCRA Code N/A
=============================================================================
Section 16 -- OTHER INFORMATION
-----------------------------------------------------------------------------
This document is prepared pursuant to the OSHA Hazard Communication
Standard (29 CFR 1910.1200). The information herein is given in good faith,
but no warranty, expressed or implied is made. Consult RectorSeal for
further
information: (713) 263-8001
|