Material Safety Data Sheet                                                       Revised: 11/09

Chromatic Technologies, Inc.             Phone: (719) 592-1557

4870 Centennial Blvd., Suite 126         Emergency phone: (800)424-9300

Colorado Springs, CO 80919



Section I -- Product Identification

Identity: Thermochromic Pencil Dipping Dispersion

Section II -- Ingredient Information

                                                                 EXPOSURE GUIDELINES

                                                                  OSHA        ACGIH

        COMPONENT            CAS #       % wt.                     PEL         TLV

 Isobutyl Methacrylate       97-86-9      5-15

 Petroleum Ether           8032-32-4      5-10

 Petroleum Hydrocarbons    8052-41-3     15-36                                     100 ppm

 Trimethyl Benzene                        <2.0                                      25 ppm

HAZARDOUS MATERIALS IDENTIFICATION SYSTEM (HMIS):

 Health Flammability Reactivity Personal Protection

    2           2       0                B



This product contains proprietary ingredients that are not required to be listed in Section II under OSHA Hazard

   Communication Standard 29 CFR 1928 (i), Trade secrets.



Section III -- Physical Data

Appearance: Colored Paste

Vapor pressure (mm Hg): ND                                 Boiling Point: 315 F - 357 F

Solubility in Water: Insoluble                             Vapor Density: Heavier than air.

Freezing point: ND                                         Evaporation Rate: Less than 0.1

Liquid Density: Lighter than water.                        (n Butyl Acetate = 1)

Percent Volatiles by Volume: 12-14%



Section IV -- Fire and Explosion Information

Flash Point: Approx. 104?F.                              Extinguishing Media: Foam, Water Spray, Dry

Use Class B extinguishers (NFPA)                             chemical.

Combustible Liquid: OSHA Class IIIB

Special fire fighting procedures: Water may be used to cool closed containers to prevent pressure buildup

   possible autoignition or explosion when exposed to extreme heat. If water is used, fog nozzles are

   preferable.

Unusual fire and explosion hazards: Isolate from heat, electrical equipment, sparks and open flame.

   Closed container may explode when exposed to extreme heat. Invisible vapors may be generated while

   burning. Carbon monoxide, carbon dioxide, and other oxides may be generated as products of

   combustion.









Chromatic Technologies, Inc.                                                              Page 1

4870 Centennial Blvd., Suite 126            Tel. (719) 592-1557

Colorado Springs, CO 80919                  Fax (719) 592-1455 www.ctiinks.com

Section V -- Health Hazard Data

FIRST AID PROCEDURES:

Eye Contact: May cause eye irritation. Flush with water for 15 minutes. Get medical attention.

Skin Contact: May cause skin irritation. Thoroughly wash exposed area with soap and water. Remove

   contaminated clothing. Launder contaminated clothing before re-use.

Inhalation: May be harmful if inhaled. May cause respiratory irritation. If affected, remove individual to fresh

   air. If breathing is difficult, administer oxygen. If breathing is stopped, give artificial respiration. Get

   medical attention.

Ingestion: May be harmful if swallowed. DO NOT induce vomiting. Get medical attention. Aspiration of

   material into the lungs due to vomiting can cause chemical pneumonitis.



Section VI -- Reactivity Data

Stability: Stable                                        Hazardous polymerization: Will not occur.

Incompatibility: May react with strong oxidizing         Hazardous polymerization-conditions to avoid:

   agents.                                                  None Known

Hazardous decomposition products: None.                  Stability conditions to avoid: None known



Section VII - Spill or Leak Procedures, Environmental Precautions

Steps to be taken in case material is released or spilled: Do not let spilled or leaking material enter

   watercourse. May be toxic to aquatic life. Absorb with inert material. Sweep or scrape up and

   containerize. Remove all sources of ignition. Follow health and safety precautions. Notify appropriate

   authorities of the spill.

Waste disposal information: All disposals must comply with Federal, State, and Local regulations. The

   material, if spilled or discarded, may be a regulated waste. Refer to State and Local regulations. Caution!

   If regulated solvents are used to clean up spilled material, the resulting waste mixture may be regulated.

   Department of Transportation (DOT) regulations may apply for transporting this material when spilled.

   Waste material may be landfilled or incinerated at an approved facility.



Section VIII -- Special Protection Information

Respiratory protection: NIOSH/MSHA approved respirators may be necessary to prevent overexposure by

  inhalation.

Ventilation: General room ventilation in accordance with good engineering practice must be provided to

  maintain concentrations below the specified exposure or flammable limits.

Protective gloves: If skin contact is possible: Any impervious material, such as Neoprene, is advised.

Eye protection: Eye protection not required unless direct contact with product is possible. Chemical splash

  goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other

  types of safety glasses.

Other protective measures: Use good personal hygiene practices. Where eye/skin contact may occur

  wear/use appropriate protective equipment. Launder contaminated clothing/equipment before reuse.



Section IX -- Special Precautions

Precautionary labeling: CAUTION: Avoid contact with eyes. If such contact occurs, flush immediately with

   water for 15 minutes. If irritation persists, see a doctor. Wear protective gloves. Avoid contact with skin.

Other handling and storage conditions: Store in a cool, dry place with adequate ventilation. Wash

   thoroughly after handling. Keep out of reach of children.







Chromatic Technologies, Inc.                                                               Page 2

4870 Centennial Blvd., Suite 126             Tel. (719) 592-1557

Colorado Springs, CO 80919                   Fax (719) 592-1455 www.ctiinks.com

Section X -- Transportation Information

DOT Class: Printing Ink, Class 3, Packing Group III, UN 1210

DOT Hazard Class: Combustible liquid

INTERNATIONAL TRANSPORTATION: Hazardous Material: IATA

AIR FREIGHT TRANSPORTATION: Hazardous Material: IATA



Section XI -- Regulatory Information

MA -- These ingredients are subject to the reporting requirements under the Massachusetts Hazardous

   Substance List.

NJ -- These ingredients are subject to the reporting requirements under the New Jersey Right to Know

   Hazardous Substance List.

PA -- These ingredients are subject to the reporting requirements under the Pennsylvania Hazardous

   Substance List.

                                 NA -- Not Applicable. ND -- Not Determined.

  The information herein is given in good faith, and is confidential. No warranty is expressed or implied. Any

                              use of these data must be determined by the users.









Chromatic Technologies, Inc.                                                              Page 3

4870 Centennial Blvd., Suite 126            Tel. (719) 592-1557

Colorado Springs, CO 80919                  Fax (719) 592-1455 www.ctiinks.com