MATERIAL SAFETY DATA SHEET
MANUFACTURER'S NAME: EMERGENCY TELEPHONE NO.:
QUALITY SYSTEMS, INC. (800) 535-5053
1101 Menzler Road
Nashville, TN 37210
DATE OF PREPARATION: INFORMATION TELEPHONE NO.:
04/22/91 (800) 607-3762
SECTION I-PRODUCT IDENTIFICATION
PRODUCT NAME: PERMA稧EL EPOXY
(Part A)
SECTION II-HAZARDOUS INGREDIENTS
INGREDIENT CAS # OSHA PEL VAP/PRESS % IN
PROD.
BISPHENOL A DIGLYCIDYL
ETHER RESIN 25068-38-6 N/D N/A PROP.
AROMATIC HYDROCARBON 70955-17-8 N/D N/A PROP.
SECTION III-PHYSICAL DATA
BOILING POINT: 3920F EVAPORATION
WT/GAL: 9.99 - 10.33 lbs. RATE: N/A
SOLUBILITY IN WATER: Negligible VAPOR DENSITY: Heavier than air
SECTION IV-FIRE AND EXPLOSION HAZARD DATA
FLAMMABILITY CLASSIFICATION: Non-Flammable
FLASH POINT: 4900 F
EXTINGUISHING MEDIA: Water Fog, Alcohol Foam, CO2, Dry Chemical
LEL: N/A
UNUSUAL FIRE & EXPLOSION HAZARDS: Decomposition and combustion products may
be toxic. Use full protective clothing (See Section VIII). Use water to cool fire-exposed container.
Use a positive pressure, self-contained breathing apparatus.
SECTION V-HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE:
INHALATION: Inhalation of vapors could cause headaches, nausea, dizziness and
respiratory tract irritation. EYE CONTACT: May cause eye irritation. Repeated contact of
eyes may cause severe eye injury. Damage may be irreversible. SKIN CONTACT: Product
is moderately irritating to the skin. May cause skin irritation and/or sensitization after
repeated contact. INGESTION: Expected to be slightly toxic by this route.
CARCINOGENICITY:
YES IARC MONOGRAPHS #19
Regulated by OSHA at greater than 0.1% (Polynuclear Aromatics)
PermaGelEpoxyA
Rev042291
Page 1 of 3
SECTION V-HEALTH HAZARD DATA-Cont'd.
EFFECTS OF OVEREXPOSURE:
INHALATION: Dizziness, breathing difficulty, headaches, loss of coordination,
unconsciousness, and death. EYE CONTACT: Severe irritation, tearing, redness, blurred
vision, and blindness. SKIN CONTACT: Can dry and defat skin causing cracks, irritation, and
dermatitis. INGESTION: Can cause gastrointestinal irritation, vomiting, nausea, diarrhea, and
death.
MEDICAL CONDITIONS PRONE TO AGGRAVATION BY EXPOSURE:
Asthma, respiratory tract irritation, dermatitis, nausea, vomiting.
FIRST AID:
INHALATION: Move exposed person to fresh air and provide oxygen if breathing is difficult.
Give artificial respiration if not breathing. GET MEDICAL ATTENTION.
EYE CONTACT: Flush eyes with plenty of water for 15 minutes while holding eye lids open.
GET MEDICAL ATTENTION.
SKIN CONTACT: Remove contaminated clothing/shoes and wipe excess from skin. Flush skin
with water, wash with soap and water. If irritation occurs GET MEDICAL ATTENTION.
Wash clothing before reuse.
INGESTION: Do not induce vomiting. If vomiting occurs spontaneously, keep head below hips to
prevent aspiration of liquid into lungs. GET MEDICAL ATTENTION.
SECTION VI-REACTIVITY DATA
STABILITY: Stable.
CONDITIONS TO AVOID: Elevated temperatures, amine compounds under
uncontrolled conditions.
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION: Carbon monoxide, carbon dioxide, aldehydes.
INCOMPATIBILITY
(MATERIALS TO AVOID): Acids, base and amine compounds under uncontrolled
conditions.
SECTION VII-SPILL AND DISPOSAL PROCEDURES
SPILL RESPONSE: Absorb into sand or other absorbent material. Shovel into closed container
for disposal. Wear protective equipment specified below. Flush contaminated area with water.
RECOMMENDED DISPOSAL: Place in appropriate disposal facility in compliance with local,
state, and federal protection agency regulations. Keep out of surface waters, sewers and
waterways entering or leading to surface waters. Notify authorities of when any exposure to
the general public or environment occurs and/or is likely to occur. DO NOT HEAT OR CUT
EMPTY CONTAINERS WITH ELECTRIC OR GAS TORCH.
PermaGelEpoxyA
Rev042291
Page 2 of 3
SECTION VIII-SAFE HANDLING AND USE INFORMATION
RESPIRATORY PROTECTION: Use NIOSH approved respirator for organic vapors if required.
VENTILATION: Good mechanical ventilation and local exhaust. Control airborne concentration
below exposure limits.
PROTECTIVE GLOVES: Wear impervious gloves.
EYE PROTECTION: Wear splash proof chemical goggles. Eye wash fountain should be available.
OTHER PROTECTIVE EQUIPMENT: Wear protective equipment to prevent exposure and
personal contact. Use of barrier cream is recommended.
HYGIENIC PRACTICES: Use good caution and personal cleanliness. Avoid contact with eyes,
skin and clothing. Avoid breathing vapors, mists or sprays. Use only with adequate ventilation.
Contaminated clothing to be washed before re-use.
SECTION IX-SPECIAL PRECAUTIONS
RECOMMENDED STORAGE: Avoid contact with skin, avoid breathing vapor, mist or spray.
Store in closed, cool and dry area. Provide good ventilation; wash after handling; for Industrial
Use Only. Keep away from heat and open flame.
OTHER PRECAUTIONS: Smoking in areas where this material is used should be strictly
prohibited.
(Please continue for Part B)
Abbreviations: N/D - Not Determined N/A - Not Applicable
This information is accurate to the best knowledge of Quality Systems, Inc., but is furnished without any expressed or implied
warranties. Recipients are advised to confirm in advance of need that the information is current, applicable, and suitable to their
circumstances.
PermaGelEpoxyA
Rev042291
Page 3 of 3
MATERIAL SAFETY DATA SHEET
MANUFACTURER'S NAME: EMERGENCY TELEPHONE NO.:
QUALITY SYSTEMS, INC. (800) 535-5053
1101 Menzler Road
Nashville, TN 37210
DATE OF PREPARATION: INFORMATION TELEPHONE NO.:
04/22/91 (800) 607-3762
SECTION I-PRODUCT IDENTIFICATION
PRODUCT NAME: PERMA稧EL EPOXY
(Part B)
SECTION II-HAZARDOUS INGREDIENTS
INGREDIENT CAS # OSHA PEL VAP/PRESS % IN
PROD.
ALKYLPHENOL 25154-52-3 N/D 2 mm Hg PROP.
2, 4, 6-TRI (DIMETHYL-
AMININOMETHYL) PHENOL 90-72-2 N/D 2 mm Hg PROP.
BIS TRAIAMINE 143-23-7 N/D 2 mm Hg PROP.
AROMATIC HYDROCARBON 70955-17-8 N/D 2 mm Hg PROP.
SECTION III-PHYSICAL DATA
BOILING POINT: 3200 F EVAPORATION
WT/GAL: 8.41 - 8.58 lbs. RATE: Less than 1
SOLUBILITY IN WATER: Slight VAPOR DENSITY: Heavier than air
SECTION IV-FIRE AND EXPLOSION HAZARD DATA
FLAMMABILITY CLASSIFICATION: Corrosive Liquid, NOS-UN/NA Number: 1760
FLASH POINT: 2500 F
EXTINGUISHING MEDIA: Water Fog, Alcohol Foam, CO2, Dry Chemical
LEL: N/A
UNUSUAL FIRE & EXPLOSION HAZARDS: Decomposition and combustion products may
be toxic. Use full protective clothing (See Section VIII). Use water to cool fire-exposed container.
Use a positive pressure, self-contained breathing apparatus.
SECTION V-HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE:
INHALATION: Inhalation of vapors could cause headaches, nausea, dizziness and
respiratory tract irritation. EYE CONTACT: May cause eye irritation. Repeated contact of
eyes may cause severe eye injury. Damage may be irreversible. SKIN CONTACT: Product
is moderately irritating to the skin. May cause skin irritation and/or sensitization after
repeated contact. INGESTION: Expected to be slightly toxic by this route.
PermaGelEpoxyB
Rev042291
Page 1 of 3
SECTION V-HEALTH HAZARD DATA-Cont'd.
CARCINOGENICITY:
YES IARC MONOGRAPHS #19
Regulated by OSHA at greater than 0.1% (Polynuclear Aromatics)
FIRST AID:
INHALATION: Move exposed person to fresh air and provide oxygen if breathing is difficult.
Give artificial respiration if not breathing. GET MEDICAL ATTENTION.
EYE CONTACT: Flush eyes with plenty of water for 15 minutes while holding eye lids open.
GET MEDICAL ATTENTION.
SKIN CONTACT: Remove contaminated clothing/shoes and wipe excess from skin. Flush skin
with water, wash with soap and water. If irritation occurs GET MEDICAL ATTENTION.
Wash clothing before reuse.
INGESTION: Do not induce vomiting. If vomiting occurs spontaneously, keep head below hips to
prevent aspiration of liquid into lungs. GET MEDICAL ATTENTION.
SECTION VI-REACTIVITY DATA
STABILITY: Stable.
CONDITIONS TO AVOID: Elevated temperatures, strong oxidizing and reducing
agents, strong oxidants and epoxy resins under uncontrolled conditions.
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION: Carbon monoxide, carbon dioxide, ammonia and oxides of
nitrogen may be formed in limited air supply. Decomposition temperature is normally
greater than 5720F.
INCOMPATIBILITY
(MATERIALS TO AVOID): Strong oxidizing agents and epoxy resins under
uncontrolled conditions.
SECTION VII-SPILL AND DISPOSAL PROCEDURES
SPILL RESPONSE: Absorb into sand or other absorbent material. Shovel into closed container
for disposal. Wear protective equipment specified below. Flush contaminated area with water.
RECOMMENDED DISPOSAL: Place in appropriate disposal facility in compliance with local,
state, and federal protection agency regulations. Keep out of surface waters, sewers and
waterways entering or leading to surface waters. Notify authorities of when any exposure to
the general public or environment occurs and/or is likely to occur. DO NOT HEAT OR CUT
EMPTY CONTAINERS WITH ELECTRIC OR GAS TORCH.
SECTION VIII-SAFE HANDLING AND USE INFORMATION
RESPIRATORY PROTECTION: Use NIOSH approved respirator for organic vapors if required.
VENTILATION: Good mechanical ventilation and local exhaust. Control airborne concentration
below exposure limits.
PROTECTIVE GLOVES: Wear impervious gloves.
EYE PROTECTION: Wear splash proof chemical goggles. Eye wash fountain should be available.
OTHER PROTECTIVE EQUIPMENT: Wear protective equipment to prevent exposure and
personal contact. Use of barrier cream is recommended.
PermaGelEpoxyB
Rev042291
Page 2 of 3
SECTION VIII-SAFE HANDLING AND USE INFORMATION-Cont'd.
HYGIENIC PRACTICES: Use good caution and personal cleanliness. Avoid contact with eyes,
skin and clothing. Avoid breathing vapors, mists or sprays. Use only with adequate ventilation.
Contaminated clothing to be washed before re-use.
SECTION IX-SPECIAL PRECAUTIONS
RECOMMENDED STORAGE: Avoid contact with skin, avoid breathing vapor, mist or spray.
Store in closed, cool and dry area. Provide good ventilation; wash after handling; for Industrial
Use Only. Keep away from heat and open flame.
OTHER PRECAUTIONS: Smoking in areas where this material is used should be strictly
prohibited.
Abbreviations: N/D - Not Determined N/A - Not Applicable
This information is accurate to the best knowledge of Quality Systems, Inc., but is furnished without any expressed or implied
warranties. Recipients are advised to confirm in advance of need that the information is current, applicable, and suitable to their
circumstances.
PermaGelEpoxyB
Rev042291
Page 3 of 3
|