8414
MATERIAL SAFETY DATA SHEET
8/15/00
INTERNATIONAL EPOXIES & SEALERS 24 HOUR EMERGENCY INFORMATION TELEPHONE
30241 COMMERCE DR. CALL INFOTRAC (800)535-5053
SAN ANTONIO, FL 33576 INFORMATION PHONE (800)451-7206
SECTION l - PRODUCT IDENTIFICATION
PART NUMBER: 8414
PRODUCT NAME: Inter-Mix 60 SMC Panel Bonding Adhesive
TRADE NAME/SYNONYMS: Inter-Mix 60 SMC Panel Bonding Adhesive
CHEMICAL FAMILY: Epoxy Adhesive
SECTION ll - HAZARDOUS INGREDIENTS
INGREDIENT CAS NO. WT% PEL TLV STEL UNITS LC50 LD50 MG/KG
PPM
Part A -BASE
Bisphenol A 25068-38-6 83-95 0.1 0.1 N/A PPM N/A RAT l 1100
Polyglycidyl Ether
Silica (Fumed) 112945-52-53-6 <6 6* 10* N/A MG/M3 N/A RAT l 3160
Pigment Purple N/A <1 1* 1* N/A MG/M3 N/A N/A N/A
PART B - HARDENER
Polyamid Curing Proprietary 35-55 N/A N/A N/A N/A N/A N/A N/A
Agent
Polymercaptan Proprietary 7-15 N/A N/A N/A N/A N/A N/A N/A
Resin
Tris (2,3,6- 90-72-2 5-9 N/A N/A N/A N/A N/A RAT l 1200
Dimethylaminomonomethyl) Phenol
Polyamid Resin Proprietary 15-30 N/A N/A N/A N/A N/A N/A N/A
Silica (Fumed) 112945-52-53-6 <6 6* 10* N/A MG/M3 N/A RAT l 3160
Glass Beads 65997-17-3 1-3 N/A N/A N/A N/A N/A N/A N/A
Zinc Phosphate 7779-90-0 1-4 N/A N/A N/A N/A N/A N/A N/A
Titanium Dioxide 13463-67-7 <1 10* 10* N/A MG/M3 N/A N/A N/A
Symbols, Abbreviations and Notations:
N/A=Not applicable or available, C=Ceiling limit, S=Skin designation, #=Listed in
SARA Title lll Section 313, *=If found as dust, mist or fume, l=Ingestion, A=Skin
absorption, LO=Little observable effect, NO=No effect, PEL=OSHA Permissible
exposure limit, TLV=ACGIH Threshold limit value, STEL= Short term exposure limit,
@=Non-Haz. Ingred. Among 5 most Predom. Subst.
SECTION lll - PHYSICAL DATA
Boiling Point DEG F/C: A=500/260(B=601/316)
Specific Gravity: A=1.20-1.23 B=1.06-1.10
Vapor Pressure (MM HG): A=N/A B=0.01
%Volatile Volume: A&B=0.0%
Vapor Density (AIR=1): A=Heavier B=9.0
Evaporation Rate: (Water=1)0.01
Solubility in Water: A=N/A B=Slight
Water/Oil Dist COEFF: A&B=0
Appearance and Odor: A=Purple Paste/
Physical State: Paste PH: N/A Freeze Point DEG F/C: N/A
Threshold Odor, PPM: N/A Other: N/A Voc: LBS/GAS=N/A; Grams/Liter=N/A;
Grams Voc/Gram Solid=N/A; % Voc N/A
Page 1 of 3
8414
MATERIAL SAFETY DATA SHEET
8/15/00
SECTION lV - FIRE AND EXPLOSION HAZARD DATA
Classification: N/A
NFPA Rating: N/A
Combustion Products: Sulfur, Oxides of Nitrogen
Flash Point DEG F/C: A=200F(93C) TOC/B=315F (257C)COC LEL%: N/A
UEL%: N/A
Extinguishing Media: Water, Fog, Foam, Dry Chemical, Carbon Dioxide
UN/NA/PIN#: N/A
Special Fire Fighting Procedures: A & B= Firefighters should wear self-
contained breathing equipment.
Auto IGN. Temp DEG F/C: N/A
Unusual fire and explosion Hazards: A & B=Contact with flame or hot surfaces
may produce toxic gases.
Explosive Power: No
Impact Sensitive: No
Burning Rate: Low
Static Sensitive: No
SECTION V ?HEALTH HAZARD DATA
Product Guide: TLV (See Section II) STEL: (See Section II)
Routes of Entry: Skin contact, absorption, eye, inhalation, ingestion
Effects of Overexposure:
A&B=Causes eye irritation, may cause skin sensitization or other allergic
responses. Prolonged and repeated inhalation may be harmful to respiratory system
or central nervous system.
Listed as a suspected carcinogen: No
Emergency and First Aid Procedures:
A&B=Eye: Immediately flush with plenty of water for 15 minutes and call
physician.
Skin: Wash thoroughly with plenty of water and soap. Inhalation: If
affected, remove to fresh air and see physician.
Ingestion: Seek Physician immediately. Show MSDS or label. Induce Vomiting.
SECTION Vl - REACTIVITY DATA
Stable: Yes Conditions to Avoid: A&B=Keep away from heat or flame
Incompatibility (Materials to Avoid): Yes Acids, Amines, Mercaptan, STRG Oxidant
Hazardous decomposition products: es Amines, CO, H2S, SO2, NO2
Hazardous Polymerization: No conditions to avoid: A&B=N/A
SECTION Vll - SPILL OR LEAK PROCEDURES
LISTED IN: SARA Title lll, #302: NO #304, CERCLA: No #313: No
Steps to be taken in case material is released or spilled:
A&B=In case of spill: Ventilate the area, wear approved respiratory protection,
wear eye/face protection, clean up with absorbent material, contain & pick-up
waste materials, put in a sealed approved container.
Report Quantity, LB: N/A KG: N/A TPQ,LB: N/A
Regulations: PROV/State, WHMIS
Hazard Waste: No
No.: N/A
A&B=Do not empty into drains. Dispose of wastes in accordance with Federal,
State, and Local regulations.
Page 2 of 3
8414
MATERIAL SAFETY DATA SHEET
8/15/00
SECTION Vlll-SAFE HANDLING AND PROTECTION INFORMATION
Respiratory Protection: Use only in well ventilated areas.
Ventilation-Local: Recommended Special: Keep away from heat/flame.
Mechanical: Required Other: N/A
Protective Gloves: Solvent Resistant Eye Protection: Goggles
Other Protective Equipment:
If ventilation is inadequate, wear approved respiratory equipment
Wear suitable protective clothing, gloves, and eye/face protection.
Estimated L 50, MG/KG: Yes ORAL RAT 1100; DERMAL RABBIT 1280
Estimated LC50, PPM: No
Sensitization: Yes Possible skin.
Irritant: Yes eyes & skin
Synergistic Agents: No
SECTION lX - SPECIAL PRECAUTIONS
Precautions to be taken in handling and storage:
A&B=Keep in a cool place. Avoid contact with eyes and skin. Do not take
internally. Wash thoroughly after using. In case of accident or illness, seek
Physician immediately, show label or MSDS. Keep away from food, drink & animal
feeds.
Other Precautions:
A&B=Keep out of reach of children. Keep only in original labeled containers.
Always read and follow directions on product label or data sheet. Additional
technical data sheets and/or material safety data sheets MSDS are available upon
request.
The information and recommendations provided herein are believed to be accurate
as of the date hereof. However, such information and recommendations are
provided without warranty of any kind and International Epoxies and Sealers
disclaims any and all liability or legal responsibility or use or reliance upon
same.
Page 3 of 3
|