MERCURY PRECISION PARTS Mercury Marine MSDS 110-3257
Product: Touch-Up Paint - Light Gray Primer (Aerosol) Product #: 92-802878 52
SECTION I - MANUFACTURER INFORMATION
Name: Mercury Marine Emergency: 800-424-9300 (ChemTrec)
Address: W6250 W. Pioneer Rd. Information: 920-929-5418
PO Box 1939 Date Prepared: 01-23-96
Fond du Lac WI 54936-1939 Revised: 02-14-05
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
Hazardous Components* OSHA PEL ACGIH TLV % (Opt.)
Other
N-Butane (106-97-8) 800ppm 800ppm 6
Propane (74-98-6) N/D 1000ppm 17
2mg/m3 2mg/m3
Talc (14657-73-8) 8
10mg/m3 10mg/m3
Titanium Dioxide (13463-67-7) 1
VMP Naptha (64742-89-3) N/D 300ppm 2
Acetone (67-64-1) 1000ppm 750ppm 41
Glycol Ether PM Acetate (108-65-6) N/D N/E 11
Toluene (108-88-3)*** 50ppm 50ppm 1
Isobutyl Acetate (110-19-0) 150ppm 150ppm 2
Isopropyl Alcohol (67-63-0)** 400ppm 400ppm 2
Isobutyl Alcohol (78-83-1) 50ppm 50ppm 2
* Specific Chemical Identity, Common Name (CAS)
**This component is listed as a SARA Section 313 Toxic Chemical.
**This component is listed as a SARA Section 313 Toxic Chemical and as a California Prop 65 chemical.
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: 1?to 999癋 Specific Gravity (H20=1): 0.782
Vapor Pressure (mmhg): 5585.2 @ 20癈 Melting Point: N/D
Vapor Density (Air=1): N/A Evaporation Rate: 7.700
Solubility in Water: N/D (Butyl Acetate=1)
Appearance and Odor: Opaque liquid, solvent odor HMIS Rating: H-2 F-4 R-0 P-Section VIII
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): < -25癋 (No Method Listed) NFPA Rating: N/D
Flammable Limits: LEL - 0.9 UEL - 110.0
Extinguishing Media: Dry chemical, carbon dioxide, foam
Special Fire Fighting Procedures: Full protective equipment including self-contained breathing apparatus (SCBA) to avoid
inhalation of vapors should be used. Water spray should not be used except to keep down vapors or cool closed containers to
prevent build up of pressure. If water is used, fog nozzles are preferred.
Unusual Fire and Explosion Hazards: Contents under pressure. Aerosol and closed containers may explode when exposed to
extreme heat. Product vapors are heavier than air and may travel a long distance to a source of ignition and flash back.
SECTION V - REACTIVITY DATA
Stability: Unstable ( ) Stable (X)
Conditions to Avoid: Contact with heat, sparks, and open flame.
Incompatibility (Materials to Avoid): Strong oxidizing agents
Hazardous Decomposition or Byproducts (Thermal): May produce carbon dioxide, carbon monoxide, and unidentifiable
organic materials.
Hazardous Polymerization: May Occur ( ) Will Not Occur (X)
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry: Inhalation (Y) Skin (Y) Eye (Y) Ingestion (Y)
Health Hazards (Acute and Chronic): Liquid or vapor may be irritating to skin, eyes, throat, and lungs. Intentional
misuse by deliberately concentrating and inhaling the contents of this product can be harmful or fatal. Chronic
overexposure to a component or components in this material has been found to cause the following effects in
laboratory animals: anemia and damage to kidney, eye, lung, liver, spleen and brain. Chronic overexposure has also
been found to cause liver damage and cardiac abnormalities in humans. Reports have associated repeated and
prolonged overexposure to solvents with permanent brain and nervous system damage.
Mercury Marine MSDS 110-3257
SECTION VI - HEALTH HAZARD DATA (cont)
Carcinogenicity: NTP (N) IARC Monographs (N) OSHA Regulated (N)
Signs and Symptoms of Exposure: Eye - Severe corneal injury if liquid comes in contact with eyes. Skin - May
cause irritation. Prolonged contact with the skin can cause chemical burns. Skin contact may aggravate existing
dermatitis. Inhalation - Exposure to high concentrations of vapors may cause dizziness, breathing difficulty,
headaches, or respiratory irritation. Extremely high concentrations may also cause drowsiness, staggering, confusion,
unconsciousness, coma, or death. Ingestion - Moderately toxic. May cause stomach discomfort, nausea, vomiting,
diarrhea, and narcosis. Aspiration of material into the lungs if swallowed or if vomiting occurs can cause chemical
pneumonitis, which can be fatal.
Medical Conditions Generally Aggravated by Exposure: Existing dermatitis. Persons with pre-existing, non-
specific bronchial hyperreactivity can respond to concentrations below the TLV with symptoms as well as an asthma
attack.
Emergency and First Aid Procedures: Eye - Immediately flush with plenty of water for 15 minutes. If irritation
persists, get medical attention. Skin - Remove contaminated clothing and wash affected skin thoroughly with soap
and water. Seek medical attention if irritation persists. Launder contaminated clothing before reuse. Inhalation -
Move person to fresh air. If breathing stops, apply artificial respiration and seek medical attention. Ingestion - SEEK
MEDICAL ATTENTION IMMEDIATELY! The decision to induce vomiting or not must be made by a physician
after careful consideration of all materials ingested.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled: Remove all sources of ignition. Ventilate area of spill
and adjacent low-lying areas. Avoid breathing solvent vapors. Remove with inert absorbent materials with non-
sparking tools.
Waste Disposal Method: Place in closed containers. Dispose of product in accordance with federal, state, county,
and local regulations.
Precautions to be taken in Handling and Storing: Store in a cool, dry area (<120癋) with ventilation suitable for
storing materials shown in Section II. Keep away from heat, sparks, and flame. Store away from direct sunlight or
sources of ignition. Wash hands thoroughly after handling.
Other Precautions: KEEP AWAY FROM CHILDREN!
SECTION VIII - CONTROL MEASURES
Respiratory Protection (Specify Type): A NIOSH/OSHA-approved respirator suitable for components listed in
Section II is recommended if workplace exposure limits are to be exceeded.
Ventilation: Local Exhaust & Mechanical - Provide sufficient ventilation, in volume and pattern, to keep air
contamination below current applicable PELs and TLVs.
Protective Gloves: Chemical-resistant plastic or rubber for prolonged or repeated contact.
Eye Protection: Chemical goggles with side shields or face shield
Other Protective Clothing or Equipment: Impervious clothing for prolonged or repeated contact.
Work/Hygiene Practices: Always follow good housekeeping and personal hygiene practices.
ADDITIONAL INFORMATION
Mercury Marine Emergency Information Number: 920-929-5000
Manufacturer, Raabe Corp., Emergency Number: 262-255-9500
N/D = NOT DETERMINED (NO DATA) N/E = NONE ESTABLISHED Y = YES
N/A = NOT APPLICABLE N/AV = NOT AVAILABLE N = NO
California Proposition 65 Information:
This product contains chemical(s) which are listed on California's proposition 65 list. If the product is to be sold or
used in California, the following warning statement must appear on the label: Warning! This product contains a
chemical or chemicals known to the State of California to cause birth defects or other reproductive harm.
|