MSDS# 2024-B
Product Code: S.GSSNOWI
Date of Preparation: 11/17/05 Rev. B
Material Safety Data Sheet
SECTION 1 IDENTIFICATION
Product Name: GOLDEN SPECTRO ?Sno Injector Manufacturer:
Intercontinental Lubricants Corp./
Spectro Oils of America
993 Federal Road
Brookfield, CT 06804
(203) 775-1291 Fax: (203) 775-8720
MSDS Date of Preparation: 11/17/05
SECTION 2 PR O DUCT COMPO NENTS
INGREDIENTS CAS#. WT.%
Petroleum Oils Proprietary 50-70
Stoddard Solvent 8052-41-3 20-30
Proprietary Additives Proprietary 1-10
1,2,4 Trimethylbenzene 95-63-6 1-5
Ethylbenzene 100-41-4 0.1-1
Naphthalene 91-20-3 0.1-1
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
This product is a green liquid with a mild petroleum odor. Combustible liquid (Flash Point 170癋). May cause mild eye
and skin irritation. Accidental ingestion may cause gastrointestinal effects with nausea and diarrhea. Aspiration into the
lungs during ingestion or vomiting may cause lung damage. Possible cancer hazard. May cause cancer based on
animal data.
HEALTH HAZARDS:
INHALATION: Excessive inhalation of vapors or mists may cause upper respiratory tract irritation and central nervous
system effects including headache, dizziness and nausea. Breathing high concentrations of oil mists may cause lipid
pneumonia.
SKIN CONTACT: Prolonged or repeated contact may cause mild irritation or dryness.
EYE CONTACT: May cause mild irritation.
INGESTION: Swallowing large amounts may cause gastrointestinal effects including nausea and diarrhea. Aspiration
into the lungs during ingestion or vomiting may cause lung damage which can be fatal.
CHR O NIC EFFECTS OF OVEREXPOSU RE: Repeated skin contact may cause dermatitis. Naphthalene has been
found to cause lung tumors in laboratory animals.
CARCIN OGENICITY: Naphthalene and ethylbenzene are listed as possibly carcinogenic to humans (Group 2B) by
IARC. Naphthalene is listed as reasonably anticipated to be a carcinogen by NTP.
MEDICAL CONDITIONS AGGRAVATED BY EXPO SURE: Individuals with chronic skin diseases may be at
increased risk from exposure to this material.
Page 1 of 1
MSDS# 2024-B
Product Code: S.GSSNOWI
Date of Preparation: 11/17/05 Rev. B
SECTION 4 EMERGENCY and FIRST AID PR OCEDURES
EYE CONTACT: Immediately flush eye with water for at least 15 minutes while lifting the upper and lower lids. Get
medical attention.
SKIN CONTACT: Wash thoroughly with soap and water. Remove contaminated clothing and launder before reuse. Get
medical attention if irritation develops.
INHALATION: Remove victim to fresh air. If breathing has stopped give artificial respiration. If breathing is difficult have
qualified personnel administer oxygen. Get medical attention.
INGESTION: Do not induce vomiting. Never give anything by mouth to an unconsciousness person. Get immediate
medical attention by calling a Poison Control Center or hospital emergency department. If vomiting occurs, keep head
below hips to prevent aspiration into the lungs.
SECTION 5 FIRE and EXPLOSION HAZARD DATA
FLASH POINT: 170癋/76癈
METHO D: COC
FLAMMABLE LIMITS: (vol % in air) LEL: 1% UEL: 6%
AUTOIGNITION TEMPERATURE: Not established
EXTINGUISHING MEDIA: Water spray or fog, foam, carbon dioxide, dry chemical.
SPECIAL FIREFIGHTING PR OCEDURES: Firefighters should wear full emergency equipment and NIOSH approved
positive pressure self-contained breathing apparatus. Cool exposed intact containers with water spray or stream.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Combustible liquid. May form combustible mixtures at
temperatures at or above the flashpoint.
SECTION 6 ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Wear appropriate protective equipment.
Remove all sources of ignition. Ventilate area. Collect material for disposal using non-combustible absorbent material and
place in a container suitable for flammable waste. Report spill as required by local and federal regulations.
SECTION 7 HANDLING and STORAGE
Avoid eye and prolonged/repeated skin contact. Avoid breathing vapors and mists. Use with adequate ventilation.
Wash thoroughly after handling. Remove oil-soaked clothing and launder before re-use. Discard oil soaked shoes and
other items than cannot be laundered.
Protect containers from physical damage. Store in a cool area away from heat, sparks, open flames and oxidizers.
Empty containers retain product residues. Do not cut, weld, braze, etc. on or near empty containers. Follow all MSDS
precautions in handling empty containers.
Page 2 of 2
MSDS# 2024-B
Product Code: S.GSSNOWI
Date of Preparation: 11/17/05 Rev. B
SECTION 8 EXPOSURE CONTR OLS and PERSO NAL PR OTECTION
INGREDIENTS CAS#. EXPOSURE LIMITS
.
Petroleum Oils Proprietary 5 mg/m3 TWA OSHA PEL
Stoddard Solvent 8052-41-3 100 ppm TWA ACGIH TLV
500 ppm TWA OSHA PEL
Proprietary Additives Proprietary None Established
1,2,4 Trimethylbenzene 95-63-6 25 ppm TWA ACGIH TLV
Ethylbenzene 100-41-4 100 ppm TWA OSHA PEL
100 ppm TWA ACGIH TLV
125 ppm STEL ACGIH
Naphthalene 91-20-3 10 ppm TWA OSHA PEL
10 ppm skin TWA ACGIH TLV
15 ppm STEL ACGIH
RESPIRATORY PR OTECTION: None needed under normal use conditions with adequate ventilation. If the TLV is
exceeded use a NIOSH approved respirator with organic vapor cartridges and a particulate pre-filter (R or P series). For
higher concentrations (greater that 10 times the TLV) a NIOSH approved supplied air respirator (with escape bottle if
required) or self-contained breathing apparatus may be required. Selection of respiratory protection depends on the
contaminant type, form and concentration. Select in accordance with OSHA 1910.134 and good Industrial Hygiene
practice.
VENTILATION: Good general room ventilation (equivalent to outdoors) should be adequate under normal conditions.
If the recommended exposure limit is exceeded increased mechanical ventilation such as local exhaust may be
required.
GLOVES: Nitrile rubber or other impervious gloves are recommended where prolonged or repeated skin contact is
likely.
EYE PR OTECTION: Safety glasses or goggles recommended.
OTHER PR OTECTIVE EQUIPMENT: Impervious apron, boots and other clothing are recommended if needed to
avoid prolonged/repeated skin contact. Suitable washing facilities should be available.
SECTION 9 PHYSICAL and CHEMICAL PR OPERTIES
MELTING POINT: Not available
B OILING POINT (@ 760 mmHg): 325癋
SPECIFIC GRAVITY (H2O=1): 0.876 VOLATILE: 0.14%
VAPOR PRESSURE (@ 20 C mm Hg): 0.01 (VAPOR DENSITY (AIR=1): 5
EVAPORATION RATE (But yl Acetate =1): 0.01 COEFFICIENT OF WATER/OIL: Not available
FLASH POINT: 170癋/76癈
APPEARANCE AND O D O R: Green liquid, mild petroleum odor.
SECTION 10 STABILITY and REACTIVITY
STABILITY: This material is stable.
CONDITIONS TO AVOID: Avoid heat, sparks and open flames.
INCOMPATIBILITY: Strong oxidizing agents.
HAZARD O US DECOMPOSITION PR O DUCTS: Thermal decomposition may yield carbon monoxide, carbon dioxide,
sulfur oxides and hydrocarbon fragments.
Page 3 of 3
MSDS# 2024-B
Product Code: S.GSSNOWI
Date of Preparation: 11/17/05 Rev. B
HAZARD O US POLYMERIZATION: Will not occur.
SECTION 11 TOXICOLOGICAL INFO RMATION
ACUTE TOXICITY VALUES:
Product: Oral rat LD50 > 5 g/kg
Skin rabbit LD50 >2 g/kg
Naphthalene and ethylbenzene are listed as possibly carcinogenic to humans (Group 2B) by IARC. Naphthalene is listed
as reasonably anticipated to be a carcinogen by NTP.
Ethylbenzene and 1,2,4-trimethylbenzene have been found to be mutagenic in some test systems.
None of the components are known to cause sensitization in animals or humans.
Naphthalene has been found to cause adverse reproductive effects in laboratory animals.
SECTION 12: ECOLOGICAL INFOR MATION
There is no ecotoxicity data available for this product at this time.
SECTION 13: DISPOSAL INFORMATION
WASTE DISPOSAL METHOD: Dispose in accordance with all local, state and federal regulations.
SECTION 14: TRANSPO RTATION INFORMATION
D OT SHIPPING DESCRIPTION: Not Regulated (Excepted from Hazmat 49CFR173.150)
D OT HAZARD CLASSIFICATION: None
D OT LABELS REQ UIRED (49CFR172.101): None
UN NUMBER: None
SECTION 15: REGULATORY INFORMATION
O SHA HAZARD CLASSIFICATION: Combustible liquid, irritant, carcinogen
EPA SARA 302: This product does not contain chemicals regulated under SARA Section 302.
EPA SARA 311 HAZARD CLASSIFICATION: Acute heath, chronic health, fire hazard
EPA SARA 313: This product contains the following chemicals that are regulated under SARA Title III, section 313:
Pseudocumene 95-63-6 1-5
(1,2,4 Trimethylbenzene)
Ethylbenzene 100-41-4 0.1-1
Naphthalene 91-20-3 0.1-1
CERCLA Hazardous Substances (Section 103)/RQ : This product has a Reportable Quantity (RQ) of 10,000 lbs.
based on the RQ for Naphthalene of 100 lbs. Releases above the RQ must be reported to the National Response
Center. Many states have more stringent release reporting requirements. Report spills required under federal, state
and local regulations.
Page 4 of 4
MSDS# 2024-B
Product Code: S.GSSNOWI
Date of Preparation: 11/17/05 Rev. B
W H MIS CLASSIFICATION: Class B3: Combustible liquid; Class D2 Subdivision A: Very toxic material causing other toxic
effects.
This product has been classified in accordance with the hazard criteria in the CPR and the MSDS contains all the
information required by the CPR.
TOXIC SUBSTANCES CONTR OL ACT: All of the components of this product are listed on the TSCA inventory.
CALIFORNIA PR OPOSITION 65: This product contains the following chemicals known to the State of California to
cause cancer: naphthlene <0.6%, ethylbenzene <0.6%, acetaldehyde <0.02 ppm, 1,4 dioxane <0.02 ppm, ethylene
oxide < 0.04 ppm, formaldehyde <0.2 ppm, benzene <15 ppm, lead <0.9 ppm, chromium < 0.9 ppm, cadmium <0.9 ppm,
beryllium <0.9 ppm, arsenic <0.9 ppm.
This product contains the following chemicals known to the State of California to cause reproductive toxicity: ethylene
oxide <0.0007 ppm (female), lead <0.9 ppm (male, female, developmental), cadmium <0.9 ppm (developmental, male),
benzene <15 ppm (male, developmental), toluene 297 ppm (developmental), mercury <0.9 ppm (developmental).
Australia: All of the ingredients of this product are listed on the Australian Inventory of Chemical Substances.
Canada: All of the components of this product are listed on the Canadian Domestic Substances List (DSL).
European Union: All of the ingredients are listed on the European Inventory of New and Existing Chemical Substances
(EINECS) inventory.
Korea: All of the components of this product are listed on the Korean Existing Chemicals List.
Philippines: All of the components of this product are listed on the Philippine Inventory of Chemicals and Chemical
Substances List.
SECTION 16: OTHER INFOR MATION
NFPA Rating: Health: 1 Fire: 2 Reactivity: 0
Page 5 of 5
|