Material Safety Data Sheet
------------------------------------------------------------------------
1. Chemical Product and Company Identification
DESCRIPTION: ELMER'S REGULAR EPOXY, RESIN PHASE
PRODUCT TYPE: EPOXY RESIN COMPOUND
APPLICATION: 60602PART1
------------------------------------------------------------------------
* Manufacturer/Supplier Information
MSDS Prepared by:
Elmer's Products, Inc. Emergency Phone Number
1000 Kingsmill Parkway Poison Control Center
Columbus, OH 43229 1-800-228-5635 ext 22
For additional health, safety or regulatory information, call 614-225-7689.
Call 1-800-848-9400 to place an order or request additional MSDSs.
------------------------------------------------------------------------
2. Composition, Information on Ingredients
The ingredients listed below have been associated with one or more
immediate and/or delayed(*) health hazards. Risk of damage and effects
depends upon duration and level of exposure. BEFORE USING, HANDLING, OR
EXPOSURE TO THESE INGREDIENTS, READ AND UNDERSTAND THE MSDS.
% by weight
25068-38-6 *4,4'-Isopropylidenediphenol-Epichlorohydrin Copolymer >70
112945-52-5 Silica, Amorphous, Fumed, Cryst.-Free 10-30
------------------------------------------------------------------------
3. Hazards Identification
------------------------------------------------------------------------
3.1 Emergency Overview
Appearance Transparent viscous paste
Odor Mild
CAUTION!
Will burn.
Skin irritant.
May cause allergic skin reaction.
Eye irritant.
------------------------------------------------------------------------
* HMIS Rating
HEALTH = 2 (moderate)
FLAMMABILITY = 1 (slight)
REACTIVITY = 0 (minimal)
CHRONIC = *
------------------------------------------------------------------------
3.2 Potential Health Effects
------------------------------------------------------------------------
* Immediate Hazards
INGESTION: Not expected to be harmful under normal conditions of
use.
INHALATION: Not expected to be harmful under normal conditions of
use. However, if allowed to become airborne, may cause
irritation of nose, throat and lungs.
SKIN: Causes irritation.
EYES: Causes irritation.
------------------------------------------------------------------------
* Delayed Hazards
4,4'-Isopropylidenediphenol-Epichlorohydrin Copolymer 25068-38-6
May cause allergic skin reaction.
-- See Footnote C.
Footnote C: As of the date of issuance of this document, this
material has not been listed by NTP, classified by IARC nor regulated
by OSHA as a carcinogen.
------------------------------------------------------------------------
4. First Aid Measures
INGESTION: If accidently swallowed, dilute by drinking large
quantities of water. Immediately contact poison control
center or hospital emergency room for any other
additional treatment directions.
INHALATION: Remove to fresh air.
SKIN: Flush with plenty of water. Remove contaminated
clothing. Call a physician if irritation persists.
EYES: Immediately flush eyes with plenty of water for at
least 15 minutes. Eyelids should be held apart during
irrigation to insure water contact with entire surface of
eyes and lids. Call a physician.
------------------------------------------------------------------------
5. Fire Fighting Measures
Autoignition Temperature Not available
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available
Flash Point 480 deg F (249 deg C) (PMCC)
Will burn.
In case of fire, use water spray, dry chemical, foam or CO2. Use
water to keep fire-exposed containers cool.
------------------------------------------------------------------------
6. Accidental Release Measures
Sweep (scoop) up and remove to a chemical disposal area. Prevent
entry into natural bodies of water.
------------------------------------------------------------------------
7. Handling and Storage
------------------------------------------------------------------------
7.1 Handling
Handle in accordance with good industrial hygiene and safety
practices. These practices include avoiding unnecessary exposure and
removal of the material from eyes, skin and clothing.
Wash thoroughly after handling.
INHALATION: Avoid prolonged or repeated breathing of vapor.
SKIN: Avoid contact with skin and clothing.
EYES: Avoid contact with eyes.
------------------------------------------------------------------------
7.2 Storage
Store in a cool, dry place.
Keep containers tightly closed.
------------------------------------------------------------------------
8. Exposure Controls/Personal Protection
------------------------------------------------------------------------
8.1 Exposure Controls
ENGINEERING CONTROLS: The following exposure control techniques may
be used to effectively minimize employee exposure: local exhaust
ventilation, enclosed system design, process isolation and remote
control in combination with appropriate use of personal protective
equipment and prudent work practices. These techniques may not
necessarily address all issues pertaining to your operations. We,
therefore, recommend that you consult with experts of your choice to
determine whether or not your programs are adequate.
If airborne contaminants are generated when the material is heated or
handled, sufficient ventilation in volume and air flow patterns should
be provided to keep air contaminant concentration levels below
acceptable criteria.
------------------------------------------------------------------------
8.2 Personal Protection
Where air contaminants can exceed acceptable criteria, use NIOSH/MSHA
approved respiratory protection equipment. Respirators should be
selected based on the form and concentration of contaminants in air
in accordance with OSHA laws and regulations or other applicable
standards or guidelines, including ANSI standards regarding
respiratory protection. Use goggles if contact is likely. Wear
impervious gloves as required to prevent skin contact.
------------------------------------------------------------------------
8.3 Exposure Guidelines
4,4'-Isopropylidenediphenol-Epichlorohydrin Copolymer 25068-38-6
ACGIH TLV: NONE ESTABLISHED
OSHA PEL: NONE ESTABLISHED
Silica, Amorphous, Fumed, Cryst.-Free 112945-52-5
ACGIH TLV: 10 mg/m?TWA, inhalable particulate; 3 mg/m?TWA
respirable, Particulates (insoluble) Not Otherwise Classified
OSHA PEL: 20 mppcf; 80/(%SiO2) mg/m?TWA
REMANDED PEL: 6 mg/m?TWA
OSHA 1989 PEL remanded, but in effect in some states
------------------------------------------------------------------------
9. Physical and Chemical Properties
Percent Volatiles Negligible
pH @ 25 C Not available
Specific Gravity 1.17
Appearance Transparent viscous paste
Autoignition Temperature Not available
Boiling Point Not available
Vapor Density (Air=1) Not available
Vapor Pressure, mm Hg @ 20 C 0.03 @ 25 deg C
Evaporation Rate (Butyl Acetate=1) Not applicable
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available
Flash Point 480 deg F (249 deg C) (PMCC)
Freezing Point Not available
Odor Mild
Odor Threshold, ppm Not available
Solubility in Water Negligible
Coefficient of Water/Oil Distrib. Not available
------------------------------------------------------------------------
10. Stability and Reactivity
Normally stable as defined in NFPA 704-12(4-3.1).
------------------------------------------------------------------------
* Incompatibilities:
Oxidizers, acids
------------------------------------------------------------------------
* Decomposition products may include:
CO, aldehydes, organic acids and oxides of nitrogen
------------------------------------------------------------------------
* Hazardous polymerization:
Will not occur.
------------------------------------------------------------------------
* Other Hazards:
None known to Borden.
------------------------------------------------------------------------
11. Toxicological Information
See Section 3 Hazards Identification information.
4,4'-Isopropylidenediphenol-Epichlorohydrin Copolymer 25068-38-6
LC50: Not available
LD50: Not available
Silica, Amorphous, Fumed, Cryst.-Free 112945-52-5
LC50: Not available
LD50: Not available
------------------------------------------------------------------------
12. Ecological Information
Not determined.
------------------------------------------------------------------------
13. Disposal Considerations
Dispose of according to local, state/provincial, and federal
requirements.
------------------------------------------------------------------------
14. Transport Information
------------------------------------------------------------------------
14.1 U.S. Department of Transportation (DOT)
The data provided in this section is for information only and may not
be specific to your package size. You will need to apply the
appropriate regulations to properly classify your shipment for
transportation.
Non-Regulated.
------------------------------------------------------------------------
14.2 Canadian Transportation of Dangerous Goods (TDG)
Non-Regulated.
------------------------------------------------------------------------
15. Regulatory Information (Selected Regulations)
------------------------------------------------------------------------
15.1 U.S. Federal Regulations
------------------------------------------------------------------------
* OSHA Hazard Communication Standard 29CFR1910.1200
This material is a "health hazard" and/or a "physical hazard" as
determined when reviewed according to the requirements of the
Occupational Safety and Health Administration 29 CFR Part 1910.1200
"Hazard Communication" Standard.
------------------------------------------------------------------------
* SARA Title III: Section 311/312
Immediate health hazard
Delayed health hazard
------------------------------------------------------------------------
* SARA Title III Section 313 and 40 CFR Part 372
This product contains the following toxic chemical(s) subject to the
reporting requirements of Section 313 of Title III of the Superfund
Amendments and Reauthorization Act of 1986, and Subpart C-Supplier
Notification Requirement of 40 CFR Part 372.
None required per SARA TITLE III SECTION 313.
------------------------------------------------------------------------
* TSCA Section 8(b) Inventory
All reportable chemical substances are listed on the TSCA Inventory.
We rely on certifications of compliance from our suppliers for
chemical substances not manufactured by Borden.
------------------------------------------------------------------------
15.2 Canadian Regulations
------------------------------------------------------------------------
* Workplace Hazardous Materials Information System (WHMIS)
This product has been classified in accordance with the hazard
criteria of the Controlled Products Regulation (CPR) and the MSDS
contains all the information required by the CPR.
CLASS D, DIV 2B
------------------------------------------------------------------------
* Canadian Environmental Protection Act (CEPA)
All reportable chemical substances are listed on the Domestic
Substances List (DSL) or otherwise comply with CEPA new substance
notification requirements.
------------------------------------------------------------------------
* National Pollutant Release Inventory (NPRI)
This product contains the following chemical(s) subject to the
reporting requirements of the Canadian Environmental Protection Act
(CEPA) subsection 16(1), National Pollutant Release Inventory.
None required.
------------------------------------------------------------------------
16. Other Information
------------------------------------------------------------------------
* User's Responsibility
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace
Hazardous Materials Information System (WHMIS) require that the information
contained on these sheets be made available to your workers. Educate and
train your workers regarding OSHA and WHMIS precautions. Instruct your
workers to handle this product properly. Consult with appropriate experts
to guard against hazards associated with use of this product and its
ingredients.
------------------------------------------------------------------------
* Disclaimer
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE
MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product
shall conform to contracted specifications, and that the product does not
infringe any valid United States or Canadian patent. No claim of any kind
shall be greater in amount than the purchase price of the quantity of
product in respect of which damages are claimed. In no event shall Seller
be liable for incidental or consequential damages, whether Buyer's claim is
based on contract, breach of warranty, negligence or otherwise.
------------------------------------------------------------------------
CUR ISSUE 15-JUN-99
PREVIOUS ISSUE: 16-JUN-98
|