Blastable Adhesive Spray
Material Safety Data Sheet
Issued: 8/17/04
Supercedes: 10/1/02
Section I - Chemical Product and Company Identification
Manufacturers name IKONICS Corporation
Address 4832 Grand Avenue, Duluth, MN 55807
Telephone number 218 628-2217 Customer Service
Emergency phone number 800 424-9300 Chemtrec USA / 703/527-3887 International (collect)
Product name Blastable Adhesive Spray
Use Adhesive Spray
Section II 鈥? Hazardous Ingredients
Ingredients Percent CAS# OSHA PEL ACGIH TLV VAPOR PSI
Not Applicable ----------------------------------------------------------------------------------------
There are no hazardous ingredients
by reference to the O.S.H.A.
Hazardous Communications Standard
(29 CFR 1910.1200)
Section III 鈥? Physical Data
Appearance White liquid
Boiling point Not Applicable
Weight (per gallon) 8.40 lb/gal.
Percent volatile (by wt) 78%
Solubility in water 100% water redispersible
Evaporation rate Not Established
Vapor density Not Established
VOC Not Applicable
Section IV 鈥? Fire and Explosion Data
>250o F
Flash point
Extinguishing media Foam, CO2, dry chemical, or water spray.
Unusual fire & explosion hazards None.
Special fire fighting procedures None.
Section V 鈥? Health Hazard Data
HMIS Codes 1-0-0-G&O Minimal=0, Slight=1, Moderate=2, Serious=3, Severe=4
Effects of overexposure
Eye contact Moderate to severe irritation.
Skin contact Can cause drying of skin leading to irritation and dermatitis.
Inhalation Exposure to vapors in poorly ventilated areas may cause irritation.
Ingestion May cause irritation of gastrointestinal tract, vomiting, diarrhea, and drowsiness.
First aid emergency procedures
Eye Flush with plenty of water for at least 15 minutes and seek medical attention.
Skin Wash with soap and water, should irritation occur, seek medical attention.
Inhalation Remove to fresh air.
Ingestion Drink water, do not induce vomiting.
Page 1
Blastable Adhesive Spray
Material Safety Data Sheet
Issued: 8/17/04
Supercedes: 10/1/02
Section VI 鈥? Reactivity Data
Stability Unstable___ Stable X
Conditions to avoid None known.
Incompatibility (materials to avoid) None known.
Hazardous decomposition products Not established.
Hazardous polymerization May occur __ Will not occur X
Section VII 鈥? Spill or Leak Procedures
Spill cleanup instructions Dike if necessary. Stop leaks, clean up spills immediately. Soak up with inert
absorbent material and place in labeled waste container for disposal. Provide
adequate ventilation into spill area. Use proper PPE when cleaning up a spill.
Waste disposal method Dispose of in accordance with federal, state, and local laws.
We make no guarantee or warranty of any kind that the use or disposal of this product is in compliance with all federal, state, or local laws.
It is the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes.
Section VIII 鈥? Control Measures / Personal Protection
Engineering controls Ventilation 鈥? Local exhaust recommended. Provide adequate ventilation
as necessary.
Personal Protection Equipment (PPE)
Gloves Rubber, neoprene, or plastic gloves are required.
Eye Personal eye protection is required. Chemical splash goggles or face shield.
Respiratory Wear O.S.H.A. (29CFR 1910.134) protection as necessary. Do not breathe
vapors or mists.
Where contact may occur Use a face shield, impervious body coverings, and boots (if exposure is severe).
Safety shower and eyewash Should be available.
Section IX 鈥? Handling and Storage
Handling and storage information This product contains limited amounts of residual monomer. Under normal
handling and use conditions the residual monomer should not present a hazard.
In storage the monomer will migrate from the emulsion and establish
equilibrium between the headspace in the storage container and the liquid
emulsion. Levels in excess of acceptable exposures can accumulate in non-
vented headspaces above the emulsion.
Other precautions Industrial use only. Keep out of reach of children.
Do not take internally. Avoid splashing in eyes.
Section X 鈥? Regulation Information
DOT classification Not a DOT controlled material (United States).
TSCA All ingredients are listed chemicals in the TSCA registry.
California (Prop 65) This product contains chemical(s) known to the State of California to cause
cancer (c) or reproductive (r) damage.
Trace Propylene Oxide (c) 75-56-9 Listed October, 1, 1988
Trace Acetaldehyde (c) 75-07-0 Listed April 1, 1988
Approved by: VP Technology, Toshi Komatsu 218 628-2217 ext.142
Notice to reader
(Approved by U.S. Department of Labor 鈥淓ssentially Similar鈥? to form OSHA-20)
The information contained herein is based on data available to us and is believed to be correct. Since this information may have been obtained in part from
independent laboratories or other sources not under direct supervision, no representation is made that the information is accurate, reliable, complete, or
representative and Buyer may rely thereon only at the Buyer鈥檚 risk. We make no guarantee that the health and safety precautions we have suggested will be
adequate for all individuals and / or situations involving its handling and uses. No warranty is expressed or implied regarding the accuracy of this data or the
results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if
reasonable safety procedures are not adhered to as stipulated in the data sheet.
Page 2
|