Rapid Mask HD and HT
Material Safety Data Sheet
Issued: 11/8/06
Supercedes: NA
Section I - Chemical Product and Company Identification
Manufacturers name IKONICS Corporation
Address 4832 Grand Avenue, Duluth, MN 55807
Telephone number 218-628-2002 Customer Service
Emergency phone number 800-424-9300 Chemtrec USA / 703-527-3887 International (collect)
Product name Rapid Mask HD and Rapid Mask HT Film
Use UV Light Sensitive Film
Section II 鈥? Hazardous Ingredients
Ingredients Percent CAS# OSHA PEL ACGIH TLV VAPOR PSI
Not Applicable ----------------------------------------------------------------------------------------
There are no hazardous ingredients
by reference to the O.S.H.A.
Hazardous Communications Standard
(29 CFR 1910.1200)
Section III 鈥? Physical Data
Appearance Green Film
Boiling point Not Applicable
Weight (per gallon) Not Applicable
Percent volatile (by wt) Not Applicable
Solubility in water Not Applicable
Evaporation rate Not Applicable
Vapor density Not Applicable
VOC Not Applicable
Section IV 鈥? Fire and Explosion Data
Flash point Not Applicable
Extinguishing media Foam, CO2, dry chemical, or water spray.
Unusual fire & explosion hazards None
Special fire fighting procedures None
Section V 鈥? Health Hazard Data
HMIS Codes 0-1-0-B Minimal=0, Slight=1, Moderate=2, Serious=3, Severe=4
Effects of overexposure
Eye contact Avoid contact with eyes.
Skin contact May take the form of redness and itching of the affected area; there may also
be slight blistering. Some people may develop sensitization over a period of time.
(Allergic response/dermatitis).
Inhalation Inhaling vapors from heated film may result in dryness and irritation of the
respiratory tract.
Ingestion No specific information available.
First aid emergency procedures
Eye Flush with plenty of water for at least 15 minutes and seek medical attention.
Skin Wash with soap and water, should irritation occur, seek medical attention.
Inhalation Remove to fresh air.
Ingestion If appreciable quantities are swallowed, seek medical attention.
Page 1
Rapid Mask HD and HT
Material Safety Data Sheet
Issued: 11/8/06
Supercedes: NA
Section VI 鈥? Reactivity Data
Stability Unstable___ Stable X
Conditions to avoid Strong light and high heat.
Incompatibility (materials to avoid) None known.
Hazardous decomposition products None known.
Hazardous polymerization May occur __ Will not occur X
Section VII 鈥? Spill or Leak Procedures
Spill cleanup instructions None.
Waste disposal method Dispose of as solid waste in accordance with federal, state, and local laws.
We make no guarantee or warranty of any kind that the use or disposal of this product is in compliance with all federal, state, or local laws.
It is the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes.
Section VIII 鈥? Control Measures / Personal Protection
Engineering controls Ventilation- Local exhaust recommended but not required.
Personal Protection Equipment (PPE)
Gloves Neoprene or latex gloves recommended.
Eye Recommended.
Respiratory Not required.
Where contact may occur Use recommended PPE.
Safety shower and eyewash Not required.
Section IX 鈥? Handling and Storage
Handling and storage information Keep film away from direct heat (sun, etc). Store film in a cool
(70-80oF, 21-26oC), dark area to maximize shelf life.
Other precautions Industrial use only. Keep out of reach of children. Do not take internally.
Avoid eye and skin contact.
Section X 鈥? Regulation Information
DOT classification Not a DOT controlled material (United States).
TSCA All ingredients are listed chemicals in the TSCA registry.
Approved by: VP Technology, Toshi Komatsu 218 628-2217 ext.142
Notice to reader
(Approved by U.S. Department of Labor 鈥淓ssentially Similar鈥? to form OSHA-20)
The information contained herein is based on data available to us and is believed to be correct. Since this information may have been obtained in part from
independent laboratories or other sources not under direct supervision, no representation is made that the information is accurate, reliable, complete, or
representative and Buyer may rely thereon only at the Buyer鈥檚 risk. We make no guarantee that the health and safety precautions we have suggested will be
adequate for all individuals and / or situations involving its handling and uses. No warranty is expressed or implied regarding the accuracy of this data or the
results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if
reasonable safety procedures are not adhered to as stipulated in the data sheet.
Page 2
|