Diazo Sensitizer for SBX
Liquid Emulsion
Material Safety Data Sheet
Issued: 3/1/04
Supercedes: 7/17/01
Section I - Chemical Product and Company Identification
Manufacturers name IKONICS Corporation
Address 4832 Grand Avenue, Duluth, MN 55807
Telephone number 218 628-2217 Customer Service
Emergency phone number 800 424-9300 Chemtrec USA / 703/527-3887 International (collect)
Product name Diazo Sensitizer for SBX liquid emulsion
Chemical name Diazonium Salt: p-diazodiphenylamine sulfate, formaldehyde condensate (41432-19-3).
Note: End product does not contain free formaldehyde.
Use Sensitizer
Section II 鈥? Hazardous Ingredients
Ingredients Percent CAS# OSHA PEL ACGIH TLV VAPOR PSI
Not Applicable ----------------------------------------------------------------------------------------
There are no hazardous ingredients
by reference to the O.S.H.A.
Hazardous Communications Standard
(29 CFR 1910.1200)
Section III 鈥? Physical Data
Appearance Yellow-Green Powder
Boiling point Not Applicable
Weight (per gallon) Not Applicable
Percent volatile (by wt) Not Applicable
Solubility in water 30%
Evaporation rate Not Applicable
Vapor density Not Applicable
VOC Not Applicable
Section IV 鈥? Fire and Explosion Data
Flash point Not Applicable
Extinguishing media Water
Unusual fire & explosion hazards None known
Special fire fighting procedures None known
Section V 鈥? Health Hazard Data
HMIS Codes 1-1-1-B Minimal=0, Slight=1, Moderate=2, Serious=3, Severe=4
Effects of overexposure
Eye contact No specific information available.
Skin contact Prolonged exposure to large quantities may cause irritation to skin
and mucous membranes.
Inhalation Prolonged exposure to large quantities may cause irritation.
Ingestion No specific information available.
First aid emergency procedures
Eye Flush with plenty of water for at least 15 minutes and seek medical attention.
Skin Wash with soap and water, should irritation occur, seek medical attention.
Inhalation Remove to fresh air.
Ingestion If appreciable quantities are swallowed, drink large quantities of water
and seek medical attention.
Page 1
Diazo Sensitizer for SBX
Liquid Emulsion
Material Safety Data Sheet
Issued: 3/1/04
Supercedes: 7/17/01
Section VI 鈥? Reactivity Data
Stability Unstable___ Stable X
Conditions to avoid Heat and light.
Incompatibility (materials to avoid) Alkaline solutions and chemicals.
Hazardous decomposition products Nitrogen, Sulfates, CO2 and CO.
Hazardous polymerization May occur __Will not occur X
Section VII 鈥? Spill or Leak Procedures
Spill cleanup instructions Contain spill and take up using absorbent. Dispose in appropriate manner.
Waste disposal method Dispose in accordance with federal, state, and local laws.
We make no guarantee or warranty of any kind that the use or disposal of this product is in compliance with all federal, state, or local laws.
It is the obligation of each user of the product mentioned herein to determine and comply with the requirements of all applicable statutes.
Section VIII 鈥? Control Measures / Personal Protection
Engineering controls Ventilation 鈥? Local exhaust recommended but not required.
Personal Protection Equipment (PPE)
Gloves Recommended.
Eye Recommended.
Respiratory Not required.
Where contact may occur Use the proper PPE.
Safety shower and eyewash Should be available.
Section IX 鈥? Handling and Storage
Handling and storage information Store at room temperature. Closed containers exposed to extreme heat will
generate pressure (steam) and may burst.
Other precautions Industrial use only. Keep out of reach of children.
Do not take internally. Avoid splashing in eyes.
Section X 鈥? Regulation Information
DOT classification Not a DOT controlled material (United States).
TSCA All ingredients are listed chemicals in the TSCA registry.
Approved by: VP Technology, Toshi Komatsu 218 628-2217 ext.142
Notice to reader
(Approved by U.S. Department of Labor 鈥淓ssentially Similar鈥? to form OSHA-20)
The information contained herein is based on data available to us and is believed to be correct. Since this information may have been obtained in part from
independent laboratories or other sources not under direct supervision, no representation is made that the information is accurate, reliable, complete, or
representative and Buyer may rely thereon only at the Buyer鈥檚 risk. We make no guarantee that the health and safety precautions we have suggested will be
adequate for all individuals and / or situations involving its handling and uses. No warranty is expressed or implied regarding the accuracy of this data or the
results to be obtained from the use thereof. Vendor assumes no responsibility for injury to vendee or third person proximately caused by the material if
reasonable safety procedures are not adhered to as stipulated in the data sheet.
Page 2
|