WATERPROOFING PUTTY
(Duraseal Putty)
DESCRIPTION COVERAGE
Waterproofing Putty is a thick bitumen putty reinforced Depending on application and porosity of surface, you
with tough inert fibres to produce superior strength. will need 1 cartridges to fill a joint 25mm x 25mm x
Waterproofing Putty has a thick consistency, and dries to 400mm approximately.
form a thick waterproof surface.
CLEAN UP
USES
Use mineral turps to clean up excess Waterproofing
鈥? For repairing cracks and holes in most types of roofing Putty and tools.
material, guttering, downpipes, flashings, valleys and
PACKAGING
water tanks.
鈥? Ideal for sealing laps on sheet roofing material, cracks
Available in 300g cartridges. (It is also sold as Duraseal
in concrete, brickwork and the bedding in deck timber
Putty in 1kg, 4kg and 20kg containers).
(marine).
鈥? Can be used for sealing laps of Alcor dampcourse and SHELF LIFE
flashing.
鈥? Can also be used to form a coving where a concrete
Up to 12 months in an unopened container, stored in a
wall meets the floor such as in concrete water tanks.
cool dry place.
Can be used in conjunction with Ormonoid Brushable
Waterproofer for waterproofing. TECHNICAL DATA
FEATURES AND BENEFITS
Properties:
Flash Point: 370C
鈥? Water, acid (mild), alkali (mild), and vermin resistance
Specific Gravity: 1.3Kg/L approx
ensure longer lasting performance in a variety of
Thinning: Not necessary
applications.
鈥? Applied cold, directly from the container saving you Packaging Group: III
any unnecessary wasted time in heating or mixing with
DISCLAIMER
solvents.
SURFACE PREPARATION The use of this product is beyond the manufacturer鈥檚 control, and
liability is restricted to the replacement of material proven faulty. The
manufacturer is not responsible for any loss or damage arising from
Surface must be dry, clean and free from grease, wax, oil incorrect usage. All workmanship must be carried out in accordance
and any loose or other material, which may inhibit with AS 3740 - 1994.
adhesion of the putty. Remove loose rust and scale with
The information contained herein is to the best of our knowledge true
a wire brush prior to application. Best results are and accurate. No warranty is implied or given as to its completeness or
obtained when the surface is dry. accuracy in describing the performance or suitability of the product for a
particular application. Users are asked to check that the literature in
APPLICATION their possession is the latest issue.
鈥? Apply directly from the cartridge or use a putty knife.
鈥? For large holes or cracks, apply a coating of
Waterproofing Putty around the area to be repaired,
then embed a piece of fibreglass reinforced matting
into the first coat, then apply second coat.
PRECAUTIONS
鈥? Flammable. Store in dry place away from open fires,
stoves and heaters. Keep lid firmly closed.
鈥? Intended for external use only.
鈥? For a full MSDS on Ormonoid Waterproofing Putty
contact your Davco Construction Materials state office.
February 2002
|