For Greenhouse, Nursery, Agriculture and Turf Worker Protection Standard, 40 CFR Part 170. This Standard contains
requirements for the protection of agricultural workers on farms, forests,
ACTINOVATE ® SP
nurseries and greenhouses, and handlers of agricultural pesticides. It
contains requirements for training, decontamination, notification, and
emergency assistance. It also contains specific instructions and exceptions
SPECIMEN LABEL
pertaining to the statements on this label about personal protective
equipment (PPE), and restricted entry intervals (REI). The requirements in
this box only apply to uses of this product that are covered by the Worker
Protection Standard.
*Biological Fungus Control.
*Controls soil-borne plant diseases such as Pythium, Rhizoctonia,
Do not allow worker entry into treated areas during the restricted entry
Phytophthora, Verticillium, Fusarium and others.
interval (REI) of four (4) hours.
*100% Soluble. Will not clog machinery.
* Enhances plant vitality.
PPE requirements for early entry to treated areas (that is permitted under
*Encourages larger root systems.
the Worker Protection Standard and that involves contact with anything that
has been treated, such as plants, soil or water) is: coveralls, waterproof
gloves and shoes plus socks. Exception: If the product is soil-incorporated,
ACTIVE INGREDIENTS:
the Worker protection Standard, under certain circumstances, allows
Streptomyces lydicus*..................00.0371%
workers to enter treated area if there will be no contact with anything that
OTHER INGREDIENTS:..............99.9629%
has been treated.
*End-use product contains not less than 1 X 107 colony forming units per
gram Streptomyces lydicus WYEC108
Non-Agricultural Use Requirements
The requirements in this box apply to uses of the product that are not within
KEEP OUT OF REACH OF CHILDREN
the scope of the Worker Protection Standard for agricultural pesticides (40
CAUTION
CFR Part 170). The WPS applies when this product is used to produce
See back panel for additional precautionary statements.
agricultural plants on farms, forests, nurseries or greenhouses.
Keep unprotected persons out of treated areas until sprays have dried or
US Patent Number: 5,403,584
dusts have settled.
EPA Reg. No.: 73314-1
EPA Establishment No.: 73314-TX-001
General Information:
Actinovate® SP is a biological fungicide for the control of root rot and
damping-off fungi. Fungi controlled include Fusarium, Rhizoctonia,
Manufactured by:
Pythium, Phytophthora, Phytomatotricum, Aphanomyces, Monosporascus,
Natural Industries, Inc.
Armillaria, Sclerotinia, Postia, Verticillium, Geotrichum, and other root-
6223 Theall Road
decay fungi. The active ingredient in Actinovate® SP colonizes the
Houston, Texas 77066
root system and protects it from harmful fungi. Actinovate® SP can also
Questions? (888) 261-4731
effectively suppress foliar diseases such as Powdery Mildew, Botrytis and
Downy Mildew. When applied to the soil Actinovate® SP also breaks down
Net Contents: 18-oz
mineral and micronutrients making them more available to plants resulting
in increased size and vitality. Plants and lawns treated with Actinovate® SP
PRECAUTIONARY STATEMENTS
as a soil drench will become hardier, more vigorous and have a robust and
Hazard to humans and domestic animals: Caution. Avoid contact
protected root system.
with skin, eyes or clothing. Wash thoroughly with soap and water after
handling.
APPLICATION DIRECTIONS:
Actinovate® SP is completely soluble and does not require agitation to
Personal Protective Equipment (PPE): Applicators and other handlers
keep suspended. Avoid applying bactericides and soil fumigants to the
must wear long-sleeved shirt and long pants, and shoes plus socks.
areas treated with Actinovate® SP. Consult manufacturer for compatibility
Mixer/loaders and applicators must wear a dust/mist-filtering respirator
questions.
meeting NIOSH standards of at least N-95, R-95, or P-95. Repeated
exposure to high concentrations of microbial proteins can cause allergic
Greenhouses and Nurseries:
sensitization. Follow manufacturer’s instructions for cleaning / maintaining
Soil Drench/Soil Incorporation
PPE. Keep and wash PPE separately from other laundry.
Mix 6 oz. of Actinovate® SP in 100 gallons of water to create solution.
Apply solution to plants/growing media at a rate of 1 gallon per cubic foot of
User Safety Requirements: Wash hands before eating, drinking,
growing media (enough to saturate soil without creating run-off).
chewing gum, using tobacco or using the toilet. Remove PPE immediately
Consult your potting mix guide for the number of ‘containers per cubic foot�
after handling this product. If gloves are worn, wash the outside of gloves
to determine the ounces of solution to be applied to each pot.
before removing. Users should remove clothing immediately if pesticide
For Example: Filling 6� pots, you get 18 pots per cubic foot of growing media,
gets inside. As soon as possible, wash thoroughly and change into clean
therefore, 1 gallon of solution (128-oz) divided by 18 pots = 7-8 oz. per pot.
clothing.
One container of Actinovate® SP will treat approximately 5,000 6� pots.
Environmental Hazards: Do not apply directly to water, or to areas where
Turf Grass
surface water is present, or to intertidal areas below the mean highwater
Mix Actinovate® SP with appropriate amount of water (100-125 gallons
mark. Do not contaminate water when cleaning equipment or disposing of
per acre). Apply at a rate of 52-oz of Actinovate® SP per acre for initial
equipment washwater.
application or problem areas. Apply maintenance applications of 18 oz. per
acre every 6 to 8 weeks is recommended.
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent
Greenhouses: Foliar Application
with its labeling. Do not apply this product in a way that will contact workers
For preventative control of Botrytis, Powdery Mildew and Downy Mildew
or other persons, either directly or through drift. Only protected handlers
on greenhouse crops. Apply 6-12 oz Actinovate® SP per acre. Dissolve
may be in the area during application. For any requirements specific to your
Actinovate® SP in appropriate amount of water and apply to foliage and
State or Tribe, consult the agency responsible for pesticide regulation.
blossoms every 7 to 14 days depending on disease pressure. Crop size,
spray equipment and local practice will determine the volume of water
Agricultural Use Requirements
needed. Spray to wet, but avoid run-off. Actinovate® SP can be applied
Use this product only in accordance with its labeling and with the
using hand-held backpack or ground spray equipment. Clean application
equipment before use of this product, and use prepared sprays within 4 STORAGE AND DISPOSAL
hours of preparation. For best results use a spreader-sticker in conjunction Do not contaminate water, food or feed by storage or disposal. Pesticide
with application. Consult manufacturer or sales representative for specific Storage: Store in a dry, cool place out of direct sunlight and away from
product recommendations. heat sources. Keep from overheating or freezing. Optimum storage
temperature is 40 F to 85 F.
Cutting or Bare Rooted Transplant Dip: Pesticide Disposal: Wastes resulting from the use of this product may be
Dip cuttings or transplants in Actinovate® SP dry powder or in a solution disposed of on site or at an approved waste disposal facility.
of 18-oz Actinovate® SP and 5 gallons water. Plant treated cuttings or Container Disposal: Completely empty package into application equipment.
transplants in potting mix or soil in the usual manner. Then dispose of empty package in a sanitary landfill or by incineration, or,
if allowed by State and local authorities, by burning. If burned, stay out of
Ornamental Bulb Crops: smoke.
Soak bulbs in solution of Actinovate® SP at 18-oz per 100 lbs. of bulbs.
Thoroughly cover all surfaces of bulbs with solution for 1 hour prior to Limited Warranty / Disclaimer
planting. Manufacturer warrants that this product is suited for the labeled use when
applied according to label directions. Manufacturer makes no warranty
Do not apply through any type of irrigation system. of merchantability. There are no warranties that extend beyond the
description on this label and in no event shall manufacturer be liable for any
consequential damages.
Manufactured By:
Natural Industries, Inc. 6223 Theall Rd. Houston, TX 77066
Questions? (888) 261-4731 www.naturalindustries.com
MATERIAL SAFETY DATA SHEET V. FIRE AND EXPLOSION DATA
Actinovate® SP A. Fire: Not considered a fire hazard.
B. Explosion: Not considered an explosion hazard.
I. PRODUCT INFORMATION
General Use: Biological fungicide
C. Fire Extinguishing Media: Water, CO2, or dry chemicals may be used.
D. Precautions: No precautions are necessary under normal conditions
Chemical Formulation: N/A.
of use. As with any dust avoid high concentrations
Common Name: Actinovate® SP
VI. PERSONAL PROTECTIVE GEAR
Molecular Weight: N/A
A. Eyes and Face: Though not necessary, safety glasses may be worn.
II. PHYSICAL PROPERTIES
B. Respiratory: No respirator is required under normal conditions of
Bulk Density: 5.5
use.
Solubility in H2O: 100% soluble
C. Skin: Though not necessary, gloves may be worn.
pH (apparent): 8.3
D. Shoes: Safety shoes are not necessary.
Appearance: pale white
VII. STORAGE AND HANDLING
Odor: slight odor of rich soil Actinovate® SP may be stored in all types of containers made of various materials of
Boiling Point (degC): N/A construction. Avoid contact with strong oxidizing agents.
Melting Point (degC): N/A VIII. SHIPPING INFORMATION
Evaporation Rate: N/A A. DOT Shipping Name: None
Vapor Pressure: N/A B. DOT Hazard Class: None
III. INGREDIENTS C. DOT Category: None
Components % Range E. Reportable Qualities (RQ): None
Inert Ingredients (confidential) 00.0371 F. HMIS: Personal Protective Code - A (Safety Glasses)
Streptomyces Lydicus WYEC 108 99.9629 G. NFPA Rating: 0 (Health) - 0 (Flammability) - 0 (Reactivity)
IV. HEALTH AND HAZARD INFORMATION IX. ENVIRONMENTAL PROTECTION PROCEDURES
A. Spill Response: No negative environmental impact. No special cleanup
A. Toxicity: none
B. Carcinogenicity: N/A not listed by NTP, LARC, OSHA, ACGIH, requirements
B. Waste Disposal: No negative environmental impact. No special
ORHIOSH
preparation required for disposal.
C. Primary Route(s) of Exposure: Skin Contact, Ingestion
D: Health Effects of Over Exposure: This information presented in this Materials Safety Data Sheet (MSDS) is subject to revisions and is not
all inclusive, but represented as the best information available to date. This information was drawn from
1. Inhalation: Nasal Irritation recognized sources, believed to be reliable. However, Natural Industries, Inc. will not be responsible for
damages of any kind resulting from the use or reliance upon such information. The product discussed is
2. Ingestion: Irritation of mucous membranes. sold without warranty, expressed or implied, and upon conditions that purchasers shall perform their own
verification and testing to determine its suitability for a particular purpose.
3. Skin: No negative side effects. Wash with soap and water.
Prepared by: Fred Sims Effective Date: February 16, 1998
4. Eyes: Slight irritation may occur. Flush with water.
Revisions: Matthew Kowalski - Natural Industries Inc. (281) 580-1643
E. Emergency and First Aid Measures:
1. Inhalation: Flush nose with water
2. Ingestion: Ingestion has shown no mammalian toxicity
3. Skin: Wash with soap and water.
4. Eyes: Flush with water for five minutes
|