TM-100
Material Safety Data Sheet (MSDS)
TM-100
MATERIAL SAFETY DATA SHEET US DEPARTMENT OF LABOR
May be used to comply with OSHA鈥檚 Occupational Safety and Health
Hazard. Administration.
Communication Standard, 29 CFR (Non-mandatory form)
1910.1200
Standard must be consulted for specific Form approved OMB No. 1218-0072
Requirements.
Identity: Product name: TM-100
Synonyms: None
Product type: Organic formulation (liquid formulation) 鈥? Concentrate
Section I. -
Manufacture鈥檚 Name: Emergency telephone number:
Bio-Science Environmental Services and
Laboratory, Inc. 1-(866) 463-2511
149 Boston Turnpike Rd.
Shrewsbury, MA. 01545
Section II. 鈥? HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
Hazardous / Non-hazardous components (specific chemical identity):
A complex of hydrolyzed proteins and enzymes: 100 percent organic components. Specific identities of these ingredients are
considered by Bio-Science Environmental Services and Laboratory, Inc. to be Trade Secrets are withheld in accordance with
provisions 1910.1200 of Title 29 the Code of Federal Regulations. Ingredients are 100 percent safe.
Hazardous ingredients: None
Exposure limits: N/A
Section III. 鈥? PHYSICAL / CHEMICAL CHARACTERISTICS
Boiling point: 100 degrees C Specific gravity (H20 = 1) 1.2
Vapor pressure (mm Hg.): N/A Melting point: N/A
Vapor density (Air = 1): N/A Evaporation rate: N/A (as water)
Butyl acetate = 1: N/A Solubility in water: Total (100%)
Appearance and Odor: opaque liquid 鈥? slight citrus odor
Section IV. 鈥? FIRE AND EXPLOSION HAZARD
Flash point (method used): none Flammable limits: N/A LEL: N/A UEL: N/A
Extinguishing media: N/A
Special fire fighting procedures: N/A (non flammable) Unusual Fire and explosion hazards: N/A
Section V. 鈥? REACTIVITY DATA
Stability: Stable Unstable: No
Conditions to avoid: Avoid strong oxidizing agents. Incompatibility (Materials to Avoid): Avoid strong oxidizers
Hazardous decomposition or by-products: None known
Hazardous polymerization: May occur. No Conditions to avoid
May not occur: X None known
TM-100
Section VI. 鈥? HEALTH HAZARD DATA
Routes of entry: Inhalation, ingestion and skin contact. Inhalation: X Skin: X Ingestion: X
May be irritating to open lesions and may irritate the eyes. May cause eyes to get watery.
Carcinogenicity NIP: N/A IARC Monograms?: N/A OSHA Regulated: No
Signs and symptoms of Exposure: N/A Medical conditions aggravated by exposure: None
EYE CONTACT: If splashed into eyes, flush with clear water for 15 minutes to remove product.
SKIN CONTACT: In case of prolonged skin contact, wash affected areas with soap and water thoroughly.
INGESTION: If digested, give plenty of water to drink and seek medical advice.
Emergency and first aid procedures: If accidentally ingested, rinse mouth with water. Give up to 8 oz. of water. Obtain medical
advice if stomach discomfort occurs. In event of contact with eyes, irrigate immediately with clean water for a minimum of 10 -
15 minutes. Obtain medical advice if irritation persists.
Section VII. 鈥? PRECAUTION FOR SAFE HANDLING AND USE
Steps to be taken in case material is released or spilled:
Wipe up spill with cloth or with paper towel. Rinse area with soap and water and wipe up.
Waste Disposal Method: Flush with water. N/A - Non-hazardous ingredients.
Precautions to be taken in handling and storing:
Keep at room temperature, DO NOT FREEZE. Keep lid closed when not in use. Store in area away from direct sunlight. Use
product at room temperature.
Section VIII. 鈥? CONTROL MEASUREMENTS
Respiratory Protection: (Specify type)
Ventilation: Local exhaust 鈥? Use in well ventilated areas. Special 鈥? N/A
Mechanical: (general)
Protective gloves 鈥? Yes Eye protection 鈥? Yes Protective Masks 鈥? N/A
Other protective clothing 鈥? Wear protective coverall suites or appropriate uniform. Avoid spilling concentrate on clothing. If
spill occurs, change clothing.
Work/Hygienic Practices: If product comes in contact with eyes, rinse with water thoroughly. If product comes in contact with
skin, rinse with soap and water, thoroughly.
TM-100 Plus
Material Safety Data Sheet (MSDS)
TM-100 Plus
MATERIAL SAFETY DATA SHEET US DEPARTMENT OF LABOR
May be used to comply with OSHA鈥檚 Occupational Safety and Health
Hazard. Administration.
Communication Standard, 29 CFR (Non-mandatory form)
1910.1200
Standard must be consulted for specific Form approved OMB No. 1218-0072
Requirements.
Identity: Product name: TM-100
Synonyms: None
Product type: Organic formulation (liquid formulation) 鈥? Concentrate
Section I. -
Manufacture鈥檚 Name: Emergency telephone number:
Bio-Science Environmental Services and
Laboratory, Inc. 1-(866) 463-2511
149 Boston Turnpike Rd.
Shrewsbury, MA. 01545
Section II. 鈥? HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
Hazardous / Non-hazardous components (specific chemical identity):
A complex of hydrolyzed proteins and enzymes: 100 percent organic components. Specific identities of these ingredients are
considered by Bio-Science Environmental Services and Laboratory, Inc. to be Trade Secrets are withheld in accordance with
provisions 1910.1200 of Title 29 the Code of Federal Regulations. Ingredients are 100 percent safe.
Hazardous ingredients: None
Exposure limits: N/A
Section III. 鈥? PHYSICAL / CHEMICAL CHARACTERISTICS
Boiling point: 100 degrees C Specific gravity (H20 = 1) 1.2
Vapor pressure (mm Hg.): N/A Melting point: N/A
Vapor density (Air = 1): N/A Evaporation rate: N/A (as water)
Butyl acetate = 1: N/A Solubility in water: Total (100%)
Appearance and Odor: slight green, opaque liquid 鈥? slight citrus odor
Section IV. 鈥? FIRE AND EXPLOSION HAZARD
Flash point (method used): none Flammable limits: N/A LEL: N/A UEL: N/A
Extinguishing media: N/A
Special fire fighting procedures: N/A (non flammable) Unusual Fire and explosion hazards: N/A
Section V. 鈥? REACTIVITY DATA
Stability: Stable Unstable: No
Conditions to avoid: Avoid strong oxidizing agents. Incompatibility (Materials to Avoid): Avoid strong oxidizers
Hazardous decomposition or by-products: None known
Hazardous polymerization: May occur. No Conditions to avoid
May not occur: X None known
TM-100 Plus
Section VI. 鈥? HEALTH HAZARD DATA
Routes of entry: Inhalation, ingestion and skin contact. Inhalation: X Skin: X Ingestion: X
May be irritating to open lesions and may irritate the eyes. May cause eyes to get watery.
Carcinogenicity NIP: N/A IARC Monograms?: N/A OSHA Regulated: No
Signs and symptoms of Exposure: N/A Medical conditions aggravated by exposure: None
EYE CONTACT: If splashed into eyes, flush with clear water for 15 minutes to remove product.
SKIN CONTACT: In case of prolonged skin contact, wash affected areas with soap and water thoroughly.
INGESTION: If digested, give plenty of water to drink and seek medical advice.
Emergency and first aid procedures: If accidentally ingested, rinse mouth with water. Give up to 8 oz. of water. Obtain medical
advice if stomach discomfort occurs. In event of contact with eyes, irrigate immediately with clean water for a minimum of 10 -
15 minutes. Obtain medical advice if irritation persists.
Section VII. 鈥? PRECAUTION FOR SAFE HANDLING AND USE
Steps to be taken in case material is released or spilled:
Wipe up spill with cloth or with paper towel. Rinse area with soap and water and wipe up.
Waste Disposal Method: Flush with water. N/A - Non-hazardous ingredients.
Precautions to be taken in handling and storing:
Keep at room temperature, DO NOT FREEZE. Keep lid closed when not in use. Store in area away from direct sunlight. Use
product at room temperature.
Section VIII. 鈥? CONTROL MEASUREMENTS
Respiratory Protection: (Specify type)
Ventilation: Local exhaust 鈥? Use in well ventilated areas. Special 鈥? N/A
Mechanical: (general)
Protective gloves 鈥? Yes Eye protection 鈥? Yes Protective Masks 鈥? N/A
Other protective clothing 鈥? Wear protective coverall suites or appropriate uniform. Avoid spilling concentrate on clothing. If
spill occurs, change clothing.
Work/Hygienic Practices: If product comes in contact with eyes, rinse with water thoroughly. If product comes in contact with
skin, rinse with soap and water, thoroughly.
TM-BAC
Material Safety Data Sheet (MSDS)
TM-BAC
MATERIAL SAFETY DATA SHEET US DEPARTMENT OF LABOR
May be used to comply with OSHA鈥檚 Occupational Safety and Health
Hazard. Administration.
Communication Standard, 29 CFR (Non-mandatory form)
1910.1200
Standard must be consulted for specific Form approved OMB No. 1218-0072
Requirements.
Identity: Product name: TM-100
Synonyms: None
Product type: Organic formulation (liquid formulation) 鈥? Concentrate
Section I. -
Manufacture鈥檚 Name: Emergency telephone number:
Bio-Science Environmental Services and
Laboratory, Inc. 1-(866) 463-2511
149 Boston Turnpike Rd.
Shrewsbury, MA. 01545
Section II. 鈥? HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
Hazardous / Non-hazardous components (specific chemical identity):
A complex of hydrolyzed proteins and enzymes: 100 percent organic components. Specific identities of these ingredients are
considered by Bio-Science Environmental Services and Laboratory, Inc. to be Trade Secrets are withheld in accordance with
provisions 1910.1200 of Title 29 the Code of Federal Regulations. Ingredients are 100 percent safe.
Hazardous ingredients: None
Exposure limits: N/A
Section III. 鈥? PHYSICAL / CHEMICAL CHARACTERISTICS
Boiling point: 100 degrees C Specific gravity (H20 = 1) 1.2
Vapor pressure (mm Hg.): N/A Melting point: N/A
Vapor density (Air = 1): N/A Evaporation rate: N/A (as water)
Butyl acetate = 1: N/A Solubility in water: Total (100%)
Appearance and Odor: slight blue, opaque liquid
Section IV. 鈥? FIRE AND EXPLOSION HAZARD
Flash point (method used): none Flammable limits: N/A LEL: N/A UEL: N/A
Extinguishing media: N/A
Special fire fighting procedures: N/A (non flammable) Unusual Fire and explosion hazards: N/A
Section V. 鈥? REACTIVITY DATA
Stability: Stable Unstable: No
Conditions to avoid: Avoid strong oxidizing agents. Incompatibility (Materials to Avoid): Avoid strong oxidizers
Hazardous decomposition or by-products: None known
Hazardous polymerization: May occur. No Conditions to avoid
May not occur: X None known
TM-BAC
Section VI. 鈥? HEALTH HAZARD DATA
Routes of entry: Inhalation, ingestion and skin contact. Inhalation: X Skin: X Ingestion: X
May be irritating to open lesions and may irritate the eyes. May cause eyes to get watery.
Carcinogenicity NIP: N/A IARC Monograms?: N/A OSHA Regulated: No
Signs and symptoms of Exposure: N/A Medical conditions aggravated by exposure: None
EYE CONTACT: If splashed into eyes, flush with clear water for 15 minutes to remove product.
SKIN CONTACT: In case of prolonged skin contact, wash affected areas with soap and water thoroughly.
INGESTION: If digested, give plenty of water to drink and seek medical advice.
Emergency and first aid procedures: If accidentally ingested, rinse mouth with water. Give up to 8 oz. of water. Obtain medical
advice if stomach discomfort occurs. In event of contact with eyes, irrigate immediately with clean water for a minimum of 10 -
15 minutes. Obtain medical advice if irritation persists.
Section VII. 鈥? PRECAUTION FOR SAFE HANDLING AND USE
Steps to be taken in case material is released or spilled:
Wipe up spill with cloth or with paper towel. Rinse area with soap and water and wipe up.
Waste Disposal Method: Flush with water. N/A - Non-hazardous ingredients.
Precautions to be taken in handling and storing:
Keep at room temperature, DO NOT FREEZE. Keep lid closed when not in use. Store in area away from direct sunlight. Use
product at room temperature.
Section VIII. 鈥? CONTROL MEASUREMENTS
Respiratory Protection: (Specify type)
Ventilation: Local exhaust 鈥? Use in well ventilated areas. Special 鈥? N/A
Mechanical: (general)
Protective gloves 鈥? Yes Eye protection 鈥? Yes Protective Masks 鈥? N/A
Other protective clothing 鈥? Wear protective coverall suites or appropriate uniform. Avoid spilling concentrate on clothing. If
spill occurs, change clothing.
Work/Hygienic Practices: If product comes in contact with eyes, rinse with water thoroughly. If product comes in contact with
skin, rinse with soap and water, thoroughly.
|