MATERIAL SAFETY DATA SHEET
Effective 7/1/05
N-TERPINAL TM RS 75
____________________________________________________________________________________________________________
SECTION 1- PRODUCT IDENTIFICATION AND USE
N-TERPINAL TM RS75
PRODUCT IDENTIFIER
MODEL NO. RS-75
PRODUCT USE Solvent
MANUFACTUER鈥橲 & WSI Industries
SUPPLIER鈥橲 NAME: 1325 W. Sunshine St., #551
Springfield, MO 65807
TELEPHONE: (417) 865-2862
EMERGENCY PHONE: (417) 877-0250
FAX: (417) 877-0255
________________________________________________________________________________________________________
SECTION 2- HAZARDOUS INGREDIENTS
One of the components of this compound contains N-Methyl-2-Pyrrolidone and is subject to reporting
Requirements of SARA Title III Section 313. RS-75 is a non-controlled product under WHMIS
(Workplace Hazardous Materials Information System). Carcinogenicity Status: NTP-No; OSHA-No;
IARC-No; ACGIH-No
____________________________________________________________________________________________
SECTION 3 鈥? PHYSICAL DATA
PHYSICAL STATE: Liquid
APPEARANCE AND ODOR: Clear liquid
ODOR (PPM): <1
VAPOR PRESSURE (mm hG): <0.0733
VAPOR DENSITY (Air=1-): >1 g/l
EVAPORATION RATE: Slow
VOC: (ASTM Method D 3960) 0.38 lb./gal
211O F / 99O C
BOILING POINT: (ASTM Method D 86-82)
FREEZING POINT: N/A
3.5 @78F/260 C
pH: (EPA Method 150.1)
1.0736 @ 69.8F/210 C
SPECIFIC GRAVITY: (Westphal Balance)
100% @ 68F/200 C
SOLUBILITY IN WATER: (TSL Method)
6.8 cps @ 77F/250 C
VISCOSITY: (Brookfield, ASTM Method D2196)
______________________________________________________________________________________
SECTION 4 鈥? FIRE AND EXPLOSION DATA
FLAMMABLE LIMITS IN AIR (g/l): LFL=N/D, UFL= N/D
2210 F/ 1040 C
FLASH POINT AND METHOD: (Closed Cup EPA Method 1010)
EXTINGUISHING MEDIA: Foam, CO2, Dry chemical
LOWER FLAMMABILITY LIMIT % BY VOL: N/A
AUTOIGNITION TEMPERATURE N/A
HAZARDOUS COMBUSTION PRODUCTS: Carbon Monoxide, Oxides of Nitrogen
EXPLOSION DATA 鈥? SENSITIVITY TO IMPACT: None
SENSITIVITY TO STATIC CHARGE: None
__________________________________________________________________________________
SECTION 5 鈥? REACTIVITY DATA
CHEMICAL STABILITY: Stable under normal conditions
INCOMPATIBILITY: Strong oxidizing agents
DECOMPOSING PRODUCTS: None known
CONDITIONS FOR REACTIVITY: Hazardous polymerization will
not occur
ALUMINUM TEST: (Modified ASTM Method F482-84) No effect
________________________________________________________________________________________________
SECTION 6 鈥? TOXILOGICAL PROPERTIES
ROUTES OF ENTRY: Skin contact and absorption; eye
contact; inhalation; ingestion
EFFECTS OF ACUTE EXPOSURE: Inhalation鈥攎ay cause irritation
to mucous membranes; Skin
Contact--may cause irritation
or dermatitis; Eye Contact--may
cause stinging or burning; Ingestion--
may cause irritation to the digestive
system
EFFECTS OF CHRONIC OVER-EXPOSURE: Eyes 鈥? may cause eye damage;
Skin 鈥搈ay cause dermatitis
EXPOSURE LIMITS: None
IRRITANCY OF PRODUCT: Eye and skin irritant
SENSITIZATION TO PRODUCT: None
CARCINOGENICITY: None
TERATOGENICITY: None
REPRODUCTIVE TOXICITY: None
MUTAGENICITY: None
SYNERGISTIC PRODUCTS: None
______________________________________________________________________________________
SECTION 7 鈥? PREVENTIVE MEASURES
GLOVES (SPECIFY): Chemically resistant
RESPIRATOR (SPECIFY): If needed, use MSHA/NIOSH
approved, mist organic vapor
cartridge (i.e., OVD/DM #8741
or #8751A from 3M)
EYE (SPECIFY): Chemical splash goggles
and/or face shield
FOOTWARE (SPECIFY): Apron and rubber boots
OTHER (SPECIFY): None
ENGINEERING CONTROLS (i.e., ventilation, enclosed process): None required
WASTE DISPOSAL: BIODEGRADABLE
Canada- Refer to local government regulations regarding waste disposal.
USA 鈥? Virgin materials is not regulated by the Resource Conservation and Recovery Act (RCRA) (40
CFR PART 260-261).
STORAGE REQUIREMENTS: Store away from oxidizing
Agents
_______________________________________________________________________________________________
SECTION 8 鈥? FIRST AID MEASURES
EYE: In case of contact, immediately flush with plenty of low-pressure water at least
15minutes. Remove any contact lenses to ensure thorough flushing. Call a physician.
SKIN: Wash with soap and running water.
INHALATION: If inhaled, remove to area of fresh air. Drink large quantities of milk or water. Never
give anything by mouth to an unconscious person. Call a physician or the Poison
Control Center.
PRIMARY ROUTES OF ENTRY: Eyes, skin
___________________________________________________________________________________
SECTION 9 鈥? PREPARATION INFORMATION
Prepared by Technical Services Laboratories, Inc. September 15, 1997 Report Number G-0624-B
File No. T-999
______________________________________________________________________________________
While the information and information set forth herein are believed to be accurate as of the date hereof, WSI Industries makes no
Warranty with respect thereto and disclaims all liability for reliance thereon.
WSI Industries LLC.
1325 W. Sunshine St., #551
Springfield, MO 65807
Phone: (417) 865-2862 Fax: (417) 877-0255
Internet at http:// www.solventreplacement.com
Email: fwellman@solventreplacement.com
|