MATERIAL SAFETY DATA SHEET
22-0-6 / .75% Pro Pendi &
100% Poly - S
AGC8605-1
Manufactured by: In Case of Emergency call:
CHEMTREC 1-800-424-9300
The Scotts Company International Emergency Telephone Number:
14111 Scottslawn Road 1-703-527-3887 (USA)
Marysville, Ohio 43041 For non-Emergency calls:
1-937-644-0011(USA)
I. MATERIAL IDENTIFICATION
Product Name: AGC8605-1 NFPA Hazard Ratings 0 Least
Analysis: 22-0-6 1 Slight
Health 2
2 Moderate
Stock Number: 8605-1 Flammability 1 3 High
Reactivity 0 4 Severe
II. HAZARDOUS INGREDIENTS
OSHA ACGIH
MATERIAL CAS # PEL TLV
N-(1-Ethylpropyl)-3,4-dimethyl-2,6-
dinitrobenzenamine (Pendimethalin) 40487-42-1 None None
Potassium Chloride 7447-40-7 None None
Sulfur 7704-34-9 None None
Urea 57-13-6 None None
Nuisance Dust N/A 15 mg/m3 10 mg/m3
(total dust) (respirable)
III. FIRST AID PROCEDURES
Eyes: Flush with plenty of water. Call a physician if irritation persists.
Ingestion: Call a physician or Poison Control Center. Drink one or two glasses of water and induce vomiting
by touching back of throat with finger. If person if unconscious, do not give anything by mouth
and do not induce vomiting.
Skin: Wash with plenty of soap and water. Get medical attention if irritation persists.
Inhalation: Remove victim to fresh air. If not breathing, give artificial respiration, preferably mouth-to-mouth.
Get medical attention.
IV. HEALTH HAZARD INFORMATION
Summary of Risks: Possible nausea, vomiting and diarrhea. Causes eye irritation.
Oral LD50 greater than 5 g/kg. Dermal LD50 greater than 2 g/kg.
Primary Entry Route(s): Ingestion.
Acute Effects: See summary.
Chronic Effects: None known.
Medical conditions which may
be aggravated by contact: Skin abrasions and sores. Inhalation of dust may aggravate asthma.
Ingredients Listed as a Carcinogen: IARC Monographs: No
NTP: No
OSHA: No
Product Name: AGC8605-1 Page 2 of 2
V. PERSONAL PROTECTION AND PRECAUTIONS
Eye Contact: Protective eyewear not normally required but is suggested to avoid eye contact.
Gloves: Recommended if handling large quantities.
Respiratory: Dust mask with prolonged exposure.
VI. PHYSICAL HAZARD INFORMATION
Fire and Explosion Physical Properties
Flash Point (Test Method): N/A Appearance: Yellow granules
Flammable Limits (% in Air): N/A Melting Point: N/A
Auto Ignition Temperature: N/A Boiling Point: N/A
Solubility in H20: N/A
Specific Gravity: Not established
Reactivity Vapor Pressure: N/A
Stability: Stable Evaporation Rate: N/A
Hazardous Polymerization: Will not occur
Conditions to Avoid: Avoid contact with strong oxidizing agents.
Hazardous Decomposition Products: In a fire, thermal decomposition of urea and methylene ureas will generate
ammonia. Oxides of nitrogen, carbon and phosphorous also possible.
Chemical Incompatibilities: None known.
Unusual Fire, Explosion Sulfur dust can form explosive mixtures with air. If product is consumed in a
and Reactivity Hazards: fire, toxic sulfur dioxide will form. Contain runoff as active ingredient is toxic
to aquatic organisms.
In Case of Fire: Use self-contained air supply.
Extinguishing Media: Dry chemical, water fog, CO2, foam. Contain all runoff as active ingredient
is toxic to aquatic organisms.
VII. REGULATORY INFORMATION
DOT Classification: Not classified as hazardous.
VIII. STORAGE AND SPECIAL PRECAUTIONS
Precautions to be taken in handling and storage: Read label. Avoid bag breakage. Avoid inhalation or contact
with skin, eyes, or clothing. Keep out of lakes, streams, or ponds. Keep out of reach of children. Do not contaminate
feed or foodstuffs. Avoid contamination with oxidizing agents or strong alkali.
In case of spills: Read label. Sweep up spills. Use good housekeeping practices. Avoid contact with skin, eyes, or
clothing. Wash after handling.
Waste management/disposal: Read label. Dispose of small waste quantities according to label directions. For large
quantities of waste, consult local waste officials.
Revised: 6/4/1997
Date Issued: #######
The information contained herein is, to the best of Scott's knowledge and belief, accurate and reliable as of the date of preparation of this document. However, no
warranty or guarantee, express or implied, is made as to the accuracy or reliability, and Scotts shall not be liable for any loss or damage arising out of the use
thereof. No authorization is given or implied to use any patented invention without a license. In addition, Scotts shall not be liable for any damage or injury
resulting from abnormal use, from any failure to adhere to recommended practices or from any hazards inherent in the nature of the product.
|