MATERIAL SAFETY DATA SHEET
SECTION I: MANUFACTURER & MATERIAL IDENTIFICATION
Manufacturer Kramer Industries, Inc. Emergency Phone 732-650-9599
140 Ethel Road West
Suite U
Piscataway, NJ 08854-5951
Urea Plastic Abrasive
Product
CAS Number None
Date Prepared Revised 1/10
SECTION II: HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
HAZARDOUS COMPONENTS CAS # PEL (ppm) TLV (ppm)
No Hazardous Components None
INGREDIENTS Exposure Limit
Urea Formaldehyde ACGIH None
OSHA None
SECTION III: PHYSICAL/CHEMICAL CHARACTERISTICS
Evaporation Rate Solid Vapor Density N/A
Solubility in Water Insoluble Percent Volatile N/A
Approximate Boiling Range N/A Density 1.5
SECTION IV: FIRE AND EXPLOSION HAZARD DATA
Flash Point, ASTM D-1929 Estimated Flash Approx. 530癈
Flammable Limits N/A
Extinguishing Media Foam, Carbon Dioxide, Water, Dry Chemical
Special Procedures Full protective equipment
Unusual Fire & Explosion Hazards None known
SECTION V: REACTIVITY DATA
Stability Stable
Conditions to Avoid Sources of ignition and temperatures above 570癋 or 300癈
Incompatibility N/A
Hazardous Decomposition N/A
Hazardous Polymerization Will not occur
MSDS for Urea Plastic Abrasive cont.
SECTION VI: HEALTH HAZARD DATA
Symptoms/Effects of Overexposure and First Aid Ingestion: Ingestion of small quantities of this material under
normal circumstances would not cause harmful effect.
Inhalation: Gross overexposure to nuisance particles, regardless of how generated, may cause irritation of the
respiratory tract. If irritation develops, remove to fresh air. If breathing difficulty persists, consult a physician.
Skin or Eye Contact: Nuisance particles may cause irritation. In case of eye contact, flush immediately with
large amounts of water. For skin, wash with soap and water. If irritation persists, consult a physician.
SECTION VII: PRECAUTIONS FOR SAFE HANDLING AND USE
Spill No special procedures required.
Waste Disposal Sanitary landfill, in accordance with Federal, State and Local Regulations.
Handling & Storage N/A
SECTION VIII: CONTROL MEASURES
Respiratory Protection Do not breath dust. Wear a properly fitted dust respirator approved by NIOSH/MSHA
during application, unless air monitoring shows dust levels below 10 mg/m3.
Ventilation Keep airborne levels of nuisance dust to a minimum.
Protective Gloves Leather gloves are recommended
Eye Protection Safety glasses with side shields
Other Equipment None required
Work/Hygiene Practices Observe standard industrial hygiene practices
Transportation: Not regulated
SECTION IX: REGULATORY STATUS
NTP Not listed
IARC Monographs Not listed
OSHA Regulated Not regulated
Notice From Kramer Industries, Inc.: The data in this material safety sheet relate only to specific material
designated herein and do not relate to use in combination with any other material or process.
The information contained in this material safety data sheet is, to our best knowledge, true and accurate, but all recommendations or suggestions are made
without guarantee, since the conditions of use are beyond our control. It is the user's responsibility to determine the safety, toxicity and suitability for his own use
of the product described herein. KRAMER INDUSTRIES, INC. disclaims any liability incurred in connection with the use of these data or suggestions.
|