MATERIAL SAFETY DATA SHEET
Mule Hide Products Co., Inc.
P.O. Box 1057 Date Prepared: 1/01/2007
Beloit, WI 53512-1057 Date Printed: 1/01/2007
800-786-1492
MSDS SHEET EAC-001
SECTION 1 - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name Mule-Hide 115 Cleaner
Chemical Name N/A
Manufacturer Mule-Hide Products Co., Inc.
Address P.O. Box 1057
Beloit, WI 53512-1057
Phone 608-365-3111
Internet www.mulehide.com
Emergency Phone 800-424-9300 Chemtrec
MSDS Number EAC-001
Effective Date October 15, 2001
nNFPA Rating Health 2, Flammability 0, Reactivity 0
0-least, 1-slight, 2-moderate, 3-high, 4-extreme
SECTION 2 - PRODUCT INGREDIENTS
Exposure Limit Exposure Limit
Ingredient Name CAS Number % Weight
(OSHA PEL) (ACGIH TLV)
2 mg/m3
Potassium Hydroxide 1310-58-3 <1 None Established
2-Butoxyethanol 111-76-2 1-2 25 ppm 25 ppm
SECTION 3 - PHYSICAL/CHEMICAL DATA
Properties Unit Data
Appearance N/A Pale Lavender Liquid
Boiling point (Deg. F) 212
Evaporation Rate (N-Butyl Acetate = 1) <1
Flash Point (Deg. F) N/A
Melting Point (Deg. c~) Same as Water
Odor N/A Mild Mint Odor
Ph (undiluted product) N/A N/A
Saturation in air % N/A
Solids Content N/A N/A
Specific gravity lbs/gal 1.4
Vapor Density Air = 1 <1
Vapor Pressure (MM HG ?68 deg. F) 7.0
Viscosity cP N/A
VOC g/liter N/A
Volatility % 36
Water solubility % Infinitely Dilutable
1 of 4
MATERIAL SAFETY DATA SHEET
Mule Hide Products Co., Inc.
P.O. Box 1057 Date Prepared: 1/01/2007
Beloit, WI 53512-1057 Date Printed: 1/01/2007
800-786-1492
MSDS SHEET EAC-001
SECTION 4 - FIRE AND EXPLOSION DATA
Flammability Properties
Flashpoint (deg. F): N/A
Lower Flammable Limits N/A
Upper Flammable Limits N/A
Auto Ignition (deg. F) N/A
Fire Extinguishing Media
Product will not burn.
Special Fire Fighting Procedures
None Known
Unusual Fire and Explosion Hazards
Sealed containers exposed to fire may rupture as a result of pressure.
SECTION 5 - HAZARD IDENTIFICATION
Toxicity
Follow all federal, state, and local regulations.
Routes and Effects of Exposure
Eyes, skin, inhalation, and ingestion.
Eyes
Exposure may cause mild eye irritation.
Skin
Exposure may cause mild skin irritation.
Inhalation
Excessive inhalation of vapors or mists can cause nasal and respiratory irritation.
Ingestion
May cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Effects of Chronic Overexposure
Acute exposure may be corrosive and result in burns to skin and eyes. Severe exposure may result in permanent tissue damage.
Medical Conditions Aggravated by Exposure
May aggravate pre-existing skin conditions, especially in persons with hypersensitivity to chemical exposure.
Signs and Symptoms of Exposure
May cause burning or irritating sensations on skin or eyes.
SECTION 6 - FIRST AID PROCEDURES
Eye Contact
Immediately flush with large amounts of water for at least 15 minutes, lifting upper and lower eyelids occasionally. Get immediate medical
attention.
Skin Contact
Remove contaminated clothing. Thoroughly wash exposed skin areas with soap and water. Launder contaminated clothing before re-use. See a
physician if irritation or injury develops.
Inhalation
If affected, remove individual to fresh air.
Ingestion
If conscious, give 3 to 4 glasses of water to dilute. Seek immediate medical attention. Do not give anything by mouth to an unconscious person.
2 of 4
MATERIAL SAFETY DATA SHEET
Mule Hide Products Co., Inc.
P.O. Box 1057 Date Prepared: 1/01/2007
Beloit, WI 53512 Date Printed: 1/01/2007
800-786-1492
MSDS SHEET EAC-001
SECTION 7 - STABILITY/REACTIVITY DATA
Stability
Stable under normal conditions.
Conditions to Avoid
None Known
Incompatibility (Materials to avoid)
Avoid contact with acids, volatiles, non-ferrous metals.
Hazardous Polymerization
Will not occur.
Hazardous Combustion and Decomposition Products
Carbon monoxide, carbon dioxide, and traces of nitrogen.
SECTION 8 - HANDLING, USE, AND DISPOSAL
Procedures for Spills/Leaks
Cover with an absorbent material and transfer to a closed container.
Storage
Keep from freezing. Close container after use.
Practice safe working procedures and good personal hygiene. Use protective equipment when necessary. Wash hands thoroughly after
handling, especially before eating, drinking, smoking or using toilet facilities.
Waste Disposal Method
Dispose of material in accordance with applicable local, county, state and federal regulations.
SECTION 9 - EXPOSURE CONTROL/PERSONAL PROTECTION
Eye
Chemical splash goggles in compliance with OSHA regulations are recommended to safeguard against potential eye contact, irritation or injury.
However, OSHA regulations also permit other type safety glasses (consult your safety equipment supplier).
Ventilation
General local ventilation should be sufficient to keep product vapor and/or mist concentrations within specified TLV ranges.
Respiratory
None Required.
Protective Clothing
The use of impermeable gloves is advised to prevent skin contact, or injury (see your safety equipment supplier). Utilize a chemical resistant
apron and/or other impervious clothing to minimize repeated or prolonged skin contact.
Work/Hygienic Practices
Wash hands thoroughly after handling, especially before eating, drinking, smoking or using toilet facilities.
3 of 4
MATERIAL SAFETY DATA SHEET
Mule Hide Products Co., Inc.
P.O. Box 1057 Date Prepared: 1/01/2007
Beloit, WI 53512 Date Printed: 1/01/2007
800-786-1492
MSDS SHEET EAC-001
SECTION 10 - TRANSPORTATION
Shipping Name Not regulated as a hazardous material for transport.
Labeling N/A
Labeling Required None required.
Hazard Class N/A
SECTION 11 - MISCELLANEOUS INFORMATION
Other Precautions
Product may corrode, degrade, or otherwise react with some metals and plastics upon prolonged contact. Consult with equipment supplier for
proper construction materials for storage tanks, mixers, fittings, pipes and other storage and handling equipment.
Containers of this material may be hazardous when emptied, because emptied containers retain residues (vapors, liquids and/or solids), all
hazard precautions given in this data sheet must be observed.
Additional Information
Contact Mule-Hide at 608-365-3111
MSDS Revision Summary
Revision Date January 1, 2007
Reason for Change New format
Disclaimer
The responsibility to provide a safe workplace is with the user. The user should consider the health hazards and safety information contained
herein as a guide and should take those precautions required in an individual operation to instruct employees and to develop work practices and
procedures for a safe environment.
The information herein has been compiled from sources believed to be reliable, and is accurate to the best of our knowledge. However, Mule-
Hide Products Co., Inc. cannot give any guarantees regarding information from other sources, and expressly does not make any warranties, nor
assume any liability for its use.
The OSHA Permissible Exposure Limits (PEL'S) contained in this Material Safety Data Sheet are the current limits as listed in the June 1993 Air
Contaminants Final Rule, specified in Tables Z-1, Z-2, and Z-3 (Federal Register, 58:35338-35351, June 30, 1993; corrected in Federal
Register, 58:40191, July 27, 1993; and subsequent amendments).
This is the end of MSDS
4 of 4
|