MATERIAL SAFETY DATA SHEET
PAGE 1
SECTION I - PRODUCT IDENTIFICATION AND PREPARATION INFORMATION
EFFECTIVE DATE: January 1st, 2009
KleenOut
PRODUCT NAME:
WHMIS CLASS: Class E - Corrosive Material CODE NO. 7288
Class D - Division 2B
T.D.G. CLASSIFICATION: Not regulated under TDG
MANUFACTURER NAME AND ADDRESS: BRODI SPECIALTY PRODUCTS LTD.
250 COCHRANE DRIVE, UNIT 9
MARKHAM, ONTARIO L3R 8E5
(905) 475-6084
MSDS PREPARED BY: MSDS CO-ORDINATOR, (877) 744-0751 EXT 205, BRODI SPECIALTY PRODUCTS LTD
EMERGENCY PHONE: CANUTEC (613) 996 6666
SECTION II - HAZARDOUS INGREDIENTS
INGREDIENTS: CAS# WT% ACGIH-TLV LC50 LD50
Ethylene glycol mono-
butyl ether 111-76-2 1-5 25 ppm TWA 500 ppm 4hr (Rat) 200 mg/kg (Dermal Rabbit)
D'Limonene 5989-27-5 1-5 Not available Not available >5 g/kg (Oral Rat)
Ethoxylated Alcohol 68439-45-2 1-5 Not available Not available 5.1g/kg(Oral Rat)
SECTION III- PHYSICAL DATA
BOILING POINT (DEG C): 100 SPECIFIC GRAVITY (H20=1): 1.0150
VAPOUR PRESSURE (mm Hg): Not available PERCENT VOLATILE (WT%): >85%
VAPOUR DENSITY (AIR=1): Similar EVAPORATION RATE (Water=1): Similar
SOLUBILITY IN WATER: Soluble PH (AS SUPPLIED): 12.0-13.0
PHYSICAL STATE: Liquid VISCOSITY: Not available
APPEARANCE AND ODOUR: Clear, light orange citrus odour.
SECTION IV- FIRE AND EXPLOSION DATA
FLAMMABILITY: Not flammable
FLASH POINT: Not applicable
LEL: Not available
UEL: Not available
HAZARDOUS COMBUSTION PRODUCTS: Oxides of carbon.
MEANS OF EXTINCTION: Treat for surrounding material.
SPECIAL FIRE HAZARDS: None known at this time.
1
PRODUCT NAME: KleenOut CODE: 7288 PAGE 2
SECTION V- REACTIVITY DATA
CONDITIONS FOR CHEMICAL INSTABILITY: Stable
INCOMPATIBILITY: Strong oxidizing agents
HAZARDOUS DECOMPOSITION: Not applicable
SECTION VI- TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY: Eye, skin contact, inhalation, ingestion
EFFECTS OF ACUTE EXPOSURE:
EYE: Contact can cause severe irritation, reddening and swelling of tissues around the eye. .
SKIN: Contact can cause moderate to high irritation.
INHALATION: Can cause nose, throat and respiratory tract irritation, coughing and headache.
INGESTION: May cause vomiting, headache and medical problems.
EFFECTS OF CHRONIC EXPOSURE:
SKIN: Prolonged or repeated exposure can cause drying, defatting and dermatitis. (Ethylene
glycol mono-butyl ether) Can be absorbed through the skin in toxic amounts, if contact
is repeated and prolonged.
IRRITANCY: Hazardous by WHMIS Criteria
RESPIRATORY TRACT SENSITIZATION: No data available
CARCINOGENIC EFFECTS: Insufficient data available
TERATOGENIC EFFECTS: Insufficient data available
MUTAGENIC EFFECTS: Insufficient data available
SYNERGISTIC MATERIALS: Not available
SECTION VII-PREVENTATIVE MEASURES
GLOVES: Latex rubber, Natural rubber, Polyethylene.
EYE PROTECTION: Safety glasses to avoid possible contact.
RESPIRATORY PROTECTION: Not normally required if good ventilation is maintained.
OTHER PROTECTIVE EQUIPMENT: As required by employer codes.
ENGINEERING CONTROLS: General ventilation is normally adequate.
LEAK AND SPILL PROCEDURE: Before attempting clean up, refer to hazard data given above. Small spills may be absorbed with
non-reactive absorbent and placed in suitable, covered-labeled containers. Prevent large spills
from entering sewers or waterways. Contact emergency services and supplier for advice.
WASTE DISPOSAL: Review federal, provincial and local government requirements prior to disposal.
STORAGE REQUIREMENTS: Store in closed containers. Store away from incompatible materials. Store in a cool, dry well-
ventilated area.
SECTION VIII- FIRST AID
EYE: Flush with water for 15 minutes. If irritation persists, seek medical attention.
SKIN: Rinse with soap and water. Call a doctor if irritation develops and persists
INHALATION: Remove to fresh air. If symptoms persist, call a doctor.
INGESTION: Do not induce vomiting. Rinse mouth with water; drink two or more glasses of water. Contact a doctor immediately.
Never give anything by mouth if victim is unconscious, is rapidly losing consciousness or is convulsing.
DISCLAIMER:
Information for this material safety data sheet was obtained from sources considered technically accurate and reliable.
No warranty, expressed or implied, is made and the supplier will not be liable for any losses, injuries or consequential damages
which may result from the use of or reliance on any information contained in this form.
2
|