MATERIAL SAFETY
DATA SHEET
SEC 1244-A
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION I - IDENTIFICATION
----------------------------------------------------------------------------------------------------------------------------------------------------------------
W186 N11687 MORSE DRIVE
GERMANTOWN, WI 53022
PHONE 262-502-6610 FAX 262-502-4743
CHEMTREC EMERGENCY PHONE 1-800-424-9300 PREP/REVISION DATE 5/31/2006
----------------------------------------------------------------------------------------------------------------------------------------------------------------
CHEMICAL COMPOSITION: MIXTURE
CHEMICAL FAMILY: EPOXY RESIN
HMIS RATINGS
HEALTH= 2 FLAMMABILITY= 1 REACTIVITY= 0 PERSONAL PROTECTION = B
0=LEAST 1=SLIGHT 2=MODERATE 3=HIGH 4=EXTREME B=GLOVES,SAFETY GLASSES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION II - HAZARDOUS INGREDIENTS
----------------------------------------------------------------------------------------------------------------------------------------------------------------
NAME CAS # OSHA PEL ACIGH TLV
BISPHENOL-F TYPE EPOXY RESIN 28064-14-4 NE NE
0.01mg/m3 0.1mg/m3
SILVER 7440-22-4
* EXACT IDENTITY WITHHELD AS A TRADE SECRET
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION III - PHYSICAL DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
FLASH POINT (PMCC) >200oF BOILING POINT >400oF VAPOR DENSITY > AIR
EVAPORATION RATE NIL % VOLATILE BY VOL. 0 SPECIFIC GRAVITY 1.16
SOLUBILITY IN WATER: NEGLIGIBLE VAPOR PRESSURE < 1mm Hg
APPEARANCE AND ODOR: BLACK LIQUID, MILD EPOXY ODOR
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IV - FIRE AND EXPLOSION DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
EXTINGUISHING MEDIA: Water fog, carbon dioxide, foam or dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Full protective equipment including self-contained breathing apparatus
should be used. Water spray may be used to cool fire exposed container to prevent pressure build-up and possible auto-
ignition or rupture.
UNUSUAL FIRE & EXPLOSION HAZARDS: Keep containers tightly closed. Water may be used to cool unruptured
containers.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION V - REACTIVITY
----------------------------------------------------------------------------------------------------------------------------------------------------------------
STABILITY _X_ STABLE ___UNSTABLE
HAZARDOUS POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID: High temperatures, high humidity.
MATERIALS TO AVOID: STRONG OXIDIZING AGENTS, ACIDS
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, aldehydes, acids, and other organic substances may
be formed during combustion or thermal or oxidative decomposition. Reaction with some curing agents may produce
considerable
Page 1 of 3
MATERIAL SAFETY
DATA SHEET
SEC 1244-A
heat. Run-a-way cure reactions may char and decompose the resin system, generating unidentified fumes and vapors
which may be toxic.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VI - HEALTH HAZARD DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
PRIMARY ROUTES OF EXPOSURE: _X_DERMAL / EYE _X__INHALATION ___ INGESTION
MEDICAL CONDITIONS PRONE TO AGGRAVATION BY EXPOSURE: Preexisting disorders of the skin and/or eyes.
EYE CONTACT:
Contains ingredients which are irritating to the eyes. Symptoms may include blurred vision, burning sensation and tearing.
SKIN CONTACT:
Contains materials which cause moderate skin irritation. This product may cause skin sensitization or allergic reactions
which may be severe with certain people. Symptoms include rash, itching, hives and swelling of extremities. Prolonged or
repeated exposure may cause a defatting or drying action to skin.
INHALATION:
Unlikely at room temperature due to low volatility, however heating can generate vapors that may cause respiratory
irritation.
INGESTION:
Product is harmful if swallowed
CHRONIC HEALTH EFFECTS
The Bisphenol-A epoxy (DGEBA) resin this product contains has been shown to be mutagenic in some microbial tests,
but failed to show mutagenicity in others, the significance of this is unknown. Chromosomal abberations were observed in
cultured rat liver cells. Two year bioassys on mice exposed by the dermal route to DGEBA resin gave only very limited
evidence of weak carcinogenicity. Based on this and other evidence the International Agency for Research on Cancer
(IARC) concluded in 1988 that DGEBA epoxy resins are not classifiable as carcincogens.
EMERGENCY FIRST AID PROCEDURES:
INHALATION:
Move person to fresh air. Restore breathing. Treat symptomatically. Consult a physician.
EYES:
Flush eyes with water for at least 15 minutes. Take to a physician for medical treatment.
SKIN: Wash affected areas with soap and water. Remove contaminated clothing. Consult a physician if irritation persists.
INGESTION: Drink plenty of water to dilute. Do not induce vomiting. Give medical attention immediately. Never give
anything by mouth to an unconscious person.
Page 2 of 3
MATERIAL SAFETY
DATA SHEET
SEC 1244-A
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VII - PROTECTIVE MEASURES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
RESPIRATORY PROTECTION: Use approved chemical/mechanical filters designed to remove a combination of
particulates and organic vapors in open and restricted areas when ventilation does not meet the requirements of 29 CFR
1910.134. Use approved airline type respirators or hoods in confined areas.
VENTILATION: Sufficient ventilation in pattern and volume to keep the air contaminant concentration below applicable
exposure limits. All application areas should be ventilated in accordance with OSHA regulation 29 CFR 1910.134
PROTECTIVE GLOVES: Use neoprene or other impervious gloves to prevent skin contact.
EYE PROTECTION: Use safety glasses with side shields as minimum protection.
OTHER PROTECTIVE EQUIPMENT: Use protective cream if skin contact is likely. Remove and wash contaminated
clothing before reuse. Discard contaminated shoes.
HYGENIC PRACTICES: Wash hands before eating, smoking or using toilet facilities. Do not smoke in any chemical
handling and storage area. Food or beverages should not be consumed anywhere near this product is handled or stored.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VIII - SPILL OR LEAK PROCEDURES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SPILLS: Contain and remove with absorbent material. Avoid contact.
WASTE DISPOSAL METHOD: Disposal should be done in accordance with Federal (40 CFR Part 261), State and local
regulations. Before attempting clean-up, refer to hazard caution information in other sections of the MSDS form. Use only
licensed hazardous waste disposal companies.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IX - SPECIAL PRECAUTIONS
----------------------------------------------------------------------------------------------------------------------------------------------------------------
HANDLING AND STORAGE: Do not store near heat or open flame.
OTHER: Empty container should not be reused.
------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION X - TRANSPORTATION INFORMATION
------------------------------------------------------------------------------------------------------------------------------------------------------
DOT PROPER SHIPPING NAME: NOT REGULATED
HAZARD CLASS OR DIVISION: NA
PACKING GROUP NUMBER: NA
REQUIRED LABEL: NONE
UN NUMBER: NA
TSCA STATUS: All components of this product are listed on, or exempted from the requirement to be listed on, the TSCA
Inventory.
PROPOSITION 65 SUBSTANCES (component(s) known to the State of California to cause cancer and/or reproductive
toxicity and subject to warning and discharge requirements under the "Safe Drinking Water and Toxic Enforcement Act of
1986"): None
----------------------------------------------------------------------------------------------------------------------------------------------------------------
The information contained herein is based upon data taken in good faith and considered accurate. However, no warrant is
implied or expressed regarding the accuracy of this data or the results obtained from the use thereof.
NA= Not Available na= not applicable NE=Not Established ND=Not Determined mppcf=million parts/ft3
mg/M3= milligrams per cubic meter
Page 3 of 3
MATERIAL SAFETY
DATA SHEET
SEC 1244-B
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION I - IDENTIFICATION
----------------------------------------------------------------------------------------------------------------------------------------------------------------
W186 N11687 MORSE DRIVE
GERMANTOWN, WI 53022
PHONE 262-502-6610 FAX 262-502-4743
CHEMTREC EMERGENCY PHONE 1-800-424-9300 PREP/REVISION DATE 5/31/2006
----------------------------------------------------------------------------------------------------------------------------------------------------------------
CHEMICAL COMPOSITION: MIXTURE
CHEMICAL FAMILY: POLYAMINE BLEND
HMIS RATINGS
HEALTH= 2 FLAMMABILITY= 1 REACTIVITY= 0 PERSONAL PROTECTION = B
0=LEAST 1=SLIGHT 2=MODERATE 3=HIGH 4=EXTREME B=GLOVES,SAFETY GLASSES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION II - HAZARDOUS INGREDIENTS
----------------------------------------------------------------------------------------------------------------------------------------------------------------
NAME CAS # OSHA PEL ACIGH TLV
Methyltetrahydrophthalic anhydride 11070-44-3 NE NE
Imidazole 931-36-2 NA NA
0.01mg/m3 0.1mg/m3
SILVER 7440-22-4
* EXACT IDENTITY WITHHELD AS A TRADE SECRET
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION III - PHYSICAL DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
FLASH POINT (PMCC) >200oF BOILING POINT >200oF VAPOR DENSITY > AIR
EVAPORATION RATE NIL % VOLATILE BY VOL. 0 SPECIFIC GRAVITY 4.4
SOLUBILITY IN WATER: HYDROLYZES VAPOR PRESSURE < 1mm Hg
APPEARANCE AND ODOR: SILVER PASTE MILD ODOR
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IV - FIRE AND EXPLOSION DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
EXTINGUISHING MEDIA: Water fog, carbon dioxide, foam or dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Full protective equipment including self-contained breathing apparatus
should be used. Water spray may be used to cool fire exposed container to prevent pressure build-up and possible auto-
ignition or rupture.
UNUSUAL FIRE & EXPLOSION HAZARDS: Keep containers tightly closed. Water may be used to cool unruptured
containers.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION V - REACTIVITY
----------------------------------------------------------------------------------------------------------------------------------------------------------------
STABILITY _X_ STABLE ___UNSTABLE
HAZARDOUS POLYMERIZATION: Will not occur.
CONDITIONS TO AVOID: High temperatures, high humidity.
MATERIALS TO AVOID: STRONG OXIDIZING AGENTS, ACIDS, EPOXY RESINS IN UNCONTROLLED CONDITIONS
Page 1 of 3
MATERIAL SAFETY
DATA SHEET
SEC 1244-B
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VI - HEALTH HAZARD DATA
----------------------------------------------------------------------------------------------------------------------------------------------------------------
EFFECTS OF OVEREXPOSURE:
ACUTE: SKIN; Primarily redness and irritation.
CHRONIC: May cause skin sensitization.
ACUTE: INHALATION; Symptoms may include burning sensation, coughing and shortness of breath.
MEDICAL CONDITIONS PRONE TO AGGRAVATION BY EXPOSURE: Chronic diseases of the skin,
PRIMARY ROUTES OF EXPOSURE: _X_DERMAL ___INHALATION ___ INGESTION
EMERGENCY FIRST AID PROCEDURES:
Move person to fresh air. Restore breathing. Treat symptomatically. Consult a physician. (EYES) Flush eyes with water
for at least 15 minutes. Take to a physician for medical treatment. (SKIN) Wash affected areas with soap and water.
Remove contaminated clothing. Consult a physician if irritation persists. INGESTION: Drink one or two glasses of milk or
water. Do not induce vomiting. Give medical attention immediately. Never give anything by mouth to an unconscious
person.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VII - PROTECTIVE MEASURES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
RESPIRATORY PROTECTION: Avoid breathing vapors/mists. Use approved chemical/mechanical filters designed to
remove a combination of particulates and organic vapors in open and restricted areas when ventilation does not meet the
requirements of 29 CFR 1910.134. Use approved airline type respirators or hoods in confined areas.
VENTILATION: Sufficient ventilation in pattern and volume to keep the air contaminant concentration below applicable
exposure limits. All application areas should be ventilated in accordance with OSHA regulation 29 CFR 1910.134
PROTECTIVE GLOVES: Use neoprene or other impervious gloves to prevent skin contact.
EYE PROTECTION: Use safety glasses with side shields as minimum protection.
OTHER PROTECTIVE EQUIPMENT: Use protective cream if skin contact is likely. Remove and wash contaminated
clothing before reuse. Discard contaminated shoes.
HYGENIC PRACTICES: Wash hands before eating, smoking or using toilet facilities. Do not smoke in any chemical
handling and storage area. Food or beverages should not be consumed anywhere near this product is handled or stored.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION VIII - SPILL OR LEAK PROCEDURES
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SPILLS: Contain and remove with absorbent material. Avoid contact.
WASTE DISPOSAL METHOD: Disposal should be done in accordance with Federal (40 CFR Part 261), State and local
regulations. Before attempting clean-up, refer to hazard caution information in other sections of the MSDS form. Use only
licensed hazardous waste disposal companies.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION IX - SPECIAL PRECAUTIONS
----------------------------------------------------------------------------------------------------------------------------------------------------------------
HANDLING AND STORAGE: Do not store near heat or open flame.
OTHER: Empty container should not be reused.
Page 2 of 3
MATERIAL SAFETY
DATA SHEET
SEC 1244-B
------------------------------------------------------------------------------------------------------------------------------------------------------
SECTION X - TRANSPORTATION INFORMATION
------------------------------------------------------------------------------------------------------------------------------------------------------
DOT PROPER SHIPPING NAME: NOT REGULATED
HAZARD CLASS OR DIVISON: NA
PACKING GROUP NUMBER: NA
REQUIRED LABEL: NONE
IDENTIFICATION NUMBER: NA
TSCA SATATUS: All components of this product are listed on, or exempted from the requirement to be listed on, the
TSCA Inventory.
------------------------------------------------------------------------------------------------------------------------------------------------------
The information contained herein is based upon data taken in good faith and considered accurate. However, no warrant is
implied or expressed regarding the accuracy of this data or the results obtained from the use thereof.
NA= Not Available na= not applicable NE=Not Established ND=Not Determined mppcf=million parts/ft3
mg/M3= milligrams per cubic meter
Page 3 of 3
|