3- Hazards Identification:
Toxicity: Skin and eye irritant. Possible Inhalation irritant.
Primary routes of Entry: Skin, eyes, inhalation.
Signs of exposure: Irritation of the eyes, skin, nose, or throat. May cause dermatitis
on prolonged contact in sensitive individuals.
4- First Aid Measures:
Ingestion: Seek medical attention. Do not induce vomiting.
Inhalation: Remove to fresh air. If symptoms persist, obtain medical attention.
Skin contact: Wash thoroughly with soap and water.
Eye contact: Flush with warm water. Seek medical attention.
5- Fire Fighting Measures:
Flash Point: >200癋, Tag Closed Cup
Extinguishing Media: Foam, Dry chemical or carbon dioxide.
Unusual Fire or Explosion Hazards: No unusual hazard.
Special Fire Fighting Procedures: Where self-contained breathing apparatus.
Bonding Agent
Page 1 of 3
Material Safety Data Sheet
Bonding Agent
6-Accidental Release Measures
Steps to be taken in case of spill or leak: Soak up in an inert absorbent and store in a closed
container until disposal. Dispose of in accordance
with local regulations.
7- Handling and Storage:
Safe storage: Store away from heat and direct sunlight to maximize shelf life.
Store inside in a dry location. Avoid storage over 100癋
Handling: Keep container tightly closed. Avoid prolonged contact with skin.
Keep away from eyes.
8- Protective Equipment:
Ventilation: Local exhaust ventilation recommended to maintain vapor level
below TLV.
Respiratory protection: Not applicable with good local exhaust.
Skin: Neoprene gloves.
Eye protection: Safety glasses or goggles with side shields.
9- Physical and Chemical Properties:
Appearance: Amber liquid
Odor: Sharp, pungent
Boiling Point: >300癋
Vapor Pressure: <10 mmHg @80癋
Vapor Density: N/A
Specific Gravity: 1.11 @ 77癋
Solubility in water: Slight
VOC Content: 3.106%, 35.5 grams/liter
10- Stability and Reactivity
Stability: Stable
Hazardous Polymerization: Will not occur.
Incompatibility: Polymerized by contact with oxidizers, amines, and alkalis.
11- Toxicological Information
See Section 3
12-Ecological Information
No Data
13- Disposal Considerations:
Spill or accidental release: Soak up with an inert absorbent and store in vented
containers
Disposal procedures: Incinerate or dispose of in an approved landfill in
accordance with local and EPA regulations. Not a RCRA
hazardous waste.
Bonding Agent
Page 2 of 3
Material Safety Data Sheet
Hazard NFPA Hazard Code HMIS Hazard Code
Health 2 2
Fire 1 1
Reactivity 1 1
Specific Hazard No Water Personal Protection See
Section 8
NFPA is a registered trademark of the National Fire Protection Association.
HMIS is a registered trademark of the National Paint and Coatings Association.
Prepared by: Kimberly McCall, Chemist
Company: Cyberbond L.L.C.?401 North Raddant Road?Batavia, IL 60510
Phone: 630-761-8900 /Fax: 630-761-8989