Grade AA & AN0111
MATERIAL SAFETY DATA SHEET
January 2008
SECTION 1 ?PRODUCT AND COMPANY IDENTIFICATION
Product Name: INSTAbond 401 Anaerobic Sealing Compound
per ASTM D5363 AN0111 & Mil-S-22473 Grade AA
Company: ACCRAbond Inc.
8848 Hacks Cross Road
Olive Branch, MS 38654
Emergency Phone Numbers: ACCRAbond Inc. (662) 895-4480
CHEMTREC (800) 424-9300
SECTION 2 ?INFORMATION ON COMPONENTS
Chemical Name CAS Number Weight % ACGIH ACGIH OSHA PEL- SKIN
TLV STEL TWA
Methacrylated Polyol 25852-47-5 85 - 100 N/E N/E N/E No
Sodium Sulfimide 81-07-2 0.1 ?0.5 N/E N/E N/E No
Cumene Hydroperoxide 80-15-9 0.1 ?0.5 50 ppm N/E N/E Yes
Methoxyphenol 150-76-5 0.1 ?0.5 375 ppm N/E N/E Yes
SECTION 3 ?HAZARDS IDENTIFICATION
INGESTION: May be moderately toxic.
SKIN: May cause moderate skin injury (reddening, swelling) and/or
sensitization which may not occur immediately. Prolonged contact with
this product may cause burns.
INHALATION: Even though product has low volatility, vapors can be irritating.
EYES: Will cause eye irritation and possible eye injury.
TARGET ORGANS: None known.
HMIS RATING: Health ?2 Flammability ?1 Reactivity ?0
SECTION 4 ?FIRST AID MEASURES
INGESTION: Do not induce vomiting. Have victim rinse out mouth with water, then
drink sips of water to remove taste from mouth. Get medical attention.
If vomiting occurs spontaneously, keep head below hips to prevent
aspiration.
Page 1 of 4
Grade AA & AN0111
SKIN: Remove contaminated clothing and wash contact area with soap and
water for 15 minutes. If dermatitis occurs, seek medical attention.
INHALATION: In case of exposure to high concentration of vapors, remove person to
fresh air. If respiratory irritation persists, seek medical attention.
EYES: Immediately flush with plenty of water (under eye lids) at least 15
minutes. If redness, burning, blurred vision or swelling persists, consult
a physician immediately.
SECTION 5 ?FIRE FIGHTING MEASURES
FLASHPOINT: > 200?F (Setaflash)
EXTINQUISHING MEDIA: Use water fog, foam, dry chemical or carbon dioxide to extinguish
flames.
SPECIAL FIRE FIGHTING Firefighters should wear full protective clothing and self-contained
MEASURES: breathing apparatus. Thoroughly decontaminate fire fighting equipment
and fire fighting apparel after the incident.
SECTION 6 ?ACCIDENTAL RELEASE MEASURES
ACCIDENTAL RELEASE In the event of a spill, immediately remove any source of ignition.
MEASURES: Using appropriate personal protective equipment and non-sparking
tools, contain spilled material. Cover the liquid with inert absorbent.
Scoop all contaminated material into containers for proper disposal.
SECTION 7 ?HANDLING AND STORAGE
HANDLING AND STORAGE: Store below 100?F for maximum stability. Do not store in direct
sunlight or near high heat sources. To prevent loss of inhibitor, do not
blanket or sparge with nitrogen. Store samples in original packaging. If
product has solidified, do not attempt to use. Wash skin thoroughly with
soap and water after handling. Solvents should not be used to clean
hands or skin because they increase the penetration of the material into
the skin.
SECTION 8 ?EXPOSURE CONTROLS/PERSONAL PROTECTION
VENTILATION: Good air circulation and ventilation is adequate.
RESPIRATORY PROTECTION: A respirator protection program that meets OSHA 1910.134 must be
followed whenever workplace conditions warrant the use of a respirator.
SKIN PROTECTION: Butyl or nitrile gloves should be used along with appropriate clothing.
EYE PROTECTION: Chemical splash safety eyewear is always recommended.
Page 2 of 4
Grade AA & AN0111
SECTION 9 ?PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE: Green Liquid
ODOR: Mild
SPECIFIC GRAVITY: 1.10
SOLUBILITY IN WATER: Insoluble
VAPOR PRESSURE: N/A
VOLATILE ORGANIC CONTENT: <0.10 lbs/gal
SECTION 10 ?STABILITY AND REACTIVITY
STABILITY: This product is stable under normal conditions.
HAZARDOUS Hazardous polymerization may occur. Uncontrolled polymerization may
POLYMERIZATION: cause rapid evolution of heat and increase in pressure that could result
in violent rupture of sealed containers.
HAZARDOUS Hazardous decomposition products may include oxides of carbon and
DECOMPOSITION nitrogen, hydrocarbon fragments and organic decomposition fragments.
PRODUCTS:
INCOMPATIBILITY: Free radical initiators, including peroxides, strong oxidizing agents,
copper, copper alloys, carbon steel, iron-containing constituents, and
strong bases.
CONDITIONS TO AVOID: Storage above 100?F, exposure to direct sunlight or other UV sources,
loss of dissolved air or polymerization inhibitor, contamination with
incompatible materials.
SECTION 11 ?TOXICOLOGY INFORMATION
Chemical Name LD50 LC50
Cumene Hydroperoxide 500 mg/kg (drem rabbit) 700 ppm (inh rat)
Sodium Sulfimide 1.42 g/kg (oral rat) N/A
SECTION 12 ?ECOLOGICAL INFORMATION
ECOLOGICAL INFORMATION: Keep product from entering waterways.
SECTION 13 ?DISPOSAL INFORMATION
DISPOSAL INFORMATION: Dispose of in accordance with federal, state and local
regulations.
Page 3 of 4
Grade AA & AN0111
SECTION 14 ?TRANSPORTATION INFORMATION
UN OR ID NUMBER: Unrestricted. No Listing.
PROPER SHIPPING NAME: Not Regulated.
ITA: Not Regulated.
HAZARD CLASS/DIVISION: Not Regulated.
GROUND TRANSPORTATION: Not Regulated.
DOT: 49 CFR Part 172
SECTION 15 ?REGULATORY INFORMATION
SARA TITLE 313: Cumene Hydroperoxide (80-15-9).
TSCA 12 (B): No substances found that require reporting.
CERCA-SARA HAZARD CATEGORY: As defined, this material is considered a chronic health hazard
and a reaction hazard.
CALIF PROPOSITION 65: This product contains saccharin which is known to cause
cancer in laboratory animals. If the material is used as
intended, there is no requirement for Proposition 65 hazard
warning.
SECTION 16 - OTHER
To the best of our knowledge, the information contained herein is accurate. However, no liability whatsoever
is assumed for the accuracy or completeness of the information contained herein. Final determination of
suitability of any materials is the sole responsibility of the user. All materials may present unknown health
hazards and should be used with caution. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that exist.
Page 4 of 4
|