Sika Corporation
Material Safety Data Sheet
1. PRODUCT AND COMPANY IDENTIFICATION
Material Identification
Product Name: SIKAFLOOR WP-20
Product Use: Paint product.
Print date: 04/Oct/2008
Revision Date: 04/Oct/2008
Company Identification
Sika Corporation
201 Polito Avenue
Lyndhurst, NJ 07071
Manufacturer's Phone: 1-201-933-8800
24-Hour Medical Emergency Phone
CHEMTREC - In US 1-800-424-9233; International: 703-527-3887
2. COMPOSITION / INFORMATION ON HAZARDOUS INGREDIENTS
Common Name Approx. Chemical name
CAS-No. Weight %
N-METHYL-2- 1-5 1-Methyl-2-pyrrolidone
PYRROLIDONE
872-50-4
TRIETHYL AMINE 1-5 Triethylamine
121-44-8
If this section is blank there are no hazardous components per OSHA guidelines.
3. HAZARDS IDENTIFICATION
Primary Routes of Exposure:
Inhalation
Ingestion
Skin absorption
Emergency Overview:
This section not in use.
This product contains ingredients that may contribute to the following potential acute health effects:
Inhalation Effects:
Harmful if inhaled. May cause respiratory irritation.
Eye Contact:
Corneal Injury/eye damage. May cause eye burns.
Skin Contact:
May cause skin burns. Harmful if absorbed through the skin.
Page 1 / 6
Acute Ingestion:
May cause burns of the mouth, throat and stomach.
Other Effects:
Contains ingredients which are corrosive.
This product contains ingredients that may contribute to the following potential chronic health effects:
Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain
and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful
or fatal. May cause eye damage and pain. May cause dermatitis. Possible sensitization.
See Section 11 for toxicological information about Mutagens, Teratogens and Carcinogens.
If this section is blank, no information is available.
4. FIRST AID MEASURES
Inhalation:
If inhaled, remove to fresh air. If not breathing give artificial respiration, preferably mouth-to-mouth. If breathing is difficult
give oxygen. Get medical attention. If affected by inhalation, move victim to fresh air. If symptoms persist, seek medical
attention.
Eye Contact:
In case of contact, or suspected contact, immediately flush eyes with plenty of water for at least 15 minutes and get
medical attention immediately after flushing.
Skin Contact:
Remove contaminated shoes and discard. In case of contact, immediately flush skin with plenty of soap and water for at
least 15 minutes. If irritation persists get medical attention. Remove contaminated clothing and launder before reuse.
Ingestion:
If swallowed , do not induce vomiting. Give large quantities of water. If available, give several glasses of milk. Never give
anything by mouth to an unconscious person. Get medical attention immediately. If swallowed, get medical attention
immediately.
Medical conditions aggravated by exposure: Any respiratory or skin condition.
5. FIRE FIGHTING MEASURES
Flash point (Fahrenheit): 201?F ( 94?C) TCC/PM
Lower explosive limit: Not available. %
Upper explosive limit: Not available. %
Autoignition temperature: Not available. ?F ( ?C)
Sensitivity to impact: No.
Sensitivity to static discharge: Sensitivity to static discharge is not expected.
Hazardous combustion products: See Section 10.
Unusual fire and explosion hazards:
None known.
Extinguishing media:
Carbon dioxide, dry chemical, foam and/or water fog.
Fire fighting procedures:
Use water spray to cool nearby containers and structures exposed to fire.
6. ACCIDENTAL RELEASE MEASURES
Page 2 / 6
6. ACCIDENTAL RELEASE MEASURES
Action to be taken if material is released or spilled:
Ventilate area. Avoid breathing of vapors. Use self-containing breathing apparatus or airmask for large spills in a
confined area. Wipe, scrape or soak up in an inert material and put in a container for disposal. See section 5, "Unusual
Fire and Explosion Hazards", for proper container and storage procedures. Avoid contact with eyes.
7. HANDLING AND STORAGE
Precautions to be taken in handling and storage:
Keep container closed when not in use. Keep from freezing. Since emptied containers may contain product residue,
follow all label warnings, even after container is emptied. Do not cut, drill, grind, or weld on or near this container.
8. PERSONAL PROTECTIVE EQUIPMENT AND EXPOSURE CONTROLS
Personal Protective Equipment
Eye and face protection:
Avoid contact with eyes. Wear chemical goggles if there is the possibility of contact or splashing in the eye.
Skin protection:
Appropriate chemical resistant gloves should be worn.To prevent skin contact wear protective clothing covering all
exposed areas.
Respiratory protection:
If exposure cannot be controlled below applicable limits, use the appropriate NIOSH approved respirator such as an air
purifying respirator with organic vapor cartridge and dust/mist filter. Consult the respirator manufacturer's literature to
ensure that the respirator will provide adequate protection. Read and follow all respirator manufacturer's instructions.
Ventilation
Required when spraying or applying in confined area.
Exposure Guidelines
OSHA Permissible Exposure Limits (PEL's)
Common Name Approx. TWA (final) Ceilings limits (final) Skin designations
CAS-No. Weight %
TRIETHYL AMINE 1-5 100 mg/m?25 ppm
121-44-8
ACGIH Threshold Limit Value (TLV's)
Common Name Approx. TWA STEL Ceiling limits Skin designations
CAS-No. Weight %
TRIETHYL AMINE 1-5 1 ppm 3 ppm Can be absorbed
121-44-8 through the skin.
If this section is blank, no information is available.
9. PHYSICAL PROPERTIES
Odor: Normal for this product type.
Physical State: Liquid
pH: Not determined.
Vapor pressure: 53 mmHG @ 68?F ( 20?C)
Vapor density (air = 1.0): 3.4
Boiling point: 193?F ( 89?C)
Page 3 / 6
9. PHYSICAL PROPERTIES
Solubility in water: Soluble
Coefficient of water/oil distribution: Not determined.
Density (lbs per US gallon): 8.48
Specific Gravity: 1.02
Evaporation rate (butyl acetate = 1.0): .4
10. STABILITY AND REACTIVITY
Stability: Stable
Conditions to Avoid: None known.
Incompatibility: Avoid water-reactive materials, heat or contact with
peroxides or other catalysts.
Hazardous Polymerization: None anticipated.
Hazardous Decomposition Products: Carbon monoxide and carbon dioxide. Nitrogen
compounds.
Sensitivity to static discharge: Sensitivity to static discharge is not expected.
11. TOXICOLOGICAL INFORMATION
Mutagens:
Common Name Approx. California Prop 65 - Developmental California Prop 65 - Reproductive
CAS-No. Weight % Toxicity (Male)
N-METHYL-2- 1-5 Listed: June 15, 2001 Developmental
PYRROLIDONE toxin.
872-50-4
Teratogens:
Testicular effects.
Carcinogens:
If this section is blank, no information is available.
12. ECOLOGICAL DATA
Not available at this time.
13. DISPOSAL CONSIDERATIONS
Disposal should be made in accordance with federal, state and local regulations.
14. TRANSPORTATION INFORMATION
U.S. Department of Transportation
Proper Shipping Name: PAINT, NOT REGULATED
UN ID Number: NRPAIN
U.S. Highway & Rail Shipments
The supplier may apply one of the following exceptions: Combustible Liquid, Consumer Commodity, Limited Quantity,
Viscous Liquid, Does Not Sustain Combustion, or others, as allowed under 49CFR Hazmat Regulations. Please consult
49CFR Subchapter C to ensure that subsequent shipments comply with these exceptions.
Page 4 / 6
International Air Transport Association:
Proper Shipping Name: PAINT, NOT REGULATED
UN ID Number: NRPAIN
International Maritime Organization:
Proper Shipping Name: PAINT, NOT REGULATED
Non-Bulk UN ID Number: NRPAIN
15. REGULATORY INFORMATION
U.S. FEDERAL REGULATIONS:
Common Name Approx. SARA 302 SARA 313 CERCLA RQ in lbs.
CAS-No. Weight %
N-METHYL-2- 1-5 form R reporting required
PYRROLIDONE for 1.0% de minimis
872-50-4 concentration
TRIETHYL AMINE 1-5 form R reporting required 5000
121-44-8 for 1.0% de minimis
concentration
SARA 311/312 Hazard Class:
Acute: Yes
Chronic: Yes
Flammability: No
Reactivity: No
Sudden Pressure: No
U.S. STATE REGULATIONS:
Pennsylvania Right To Know:
TRIETHYL AMINE 121-44-8
N-METHYL-2-PYRROLIDONE 872-50-4
Additional Non-Hazardous Materials
WATER 7732-18-5
SUPPLIER TRADE SECRET Trade Secret
California Proposition 65:
WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive
harm: N-Methyl-2-Pyrrolidone (CAS 871-50-4)
Rule 66 status of product Not photochemically reactive.
INTERNATIONAL REGULATIONS - Chemical Inventories
TSCA Inventory: All components of this product are in compliance with U.S.
TSCA Chemical Substance Inventory Requirements.
Canada Domestic Substances List: Not all components in this product are listed on the Domestic
Substances List.
16. OTHER INFORMATION
HMIS Codes
Health: 3
Flammability: 1
Page 5 / 6
16. OTHER INFORMATION
Reactivity: 1
PPE: D
Abbreviations:
OSHA - Occupational Safety and Health Administration, IARC - International Agency for Research on Cancer, NIOSH -
National Institute of Occupational Safety and Health, NTP - National Toxicology Program, ACGIH - American Conference
of Governmental Industrial Hygienists, SCAQMD - South Coast Air Quality Management District, TSCA - Toxic
Substances Control Act, IATA - International Air Transport Association, IMO - International Maritime Organization, DOT -
Department of Transportation, NA - Not applicable, NOT ESTAB - Not established, N.A.V. - Not available, RQ -
Reportable quantity, WT - Weight, MG/CU M - Milligrams per cubic meter, G/L - Grams per liter, MM - Millimeters,
MPPCF - Millions of particles per cubic foot, PPM - parts per million, PPT - parts per thousand, TCC/PM - Tag closed
cup / Pensky-Martens, PB - Lead, PEL - Permissible exposure level, TWA - Time Weighted Average, STEL - Short term
exposure limit, C - Celsius, F - Fahrenheit.
Disclaimer:
The information contained in this Material Safety Data Sheet applies only to the actual Sika Corporation ("Sika")
product identified and described herein. This information is not intended to address, nor does it address the use
or application of the identified Sika product in combination with any other material, product or process. All of the
information set forth herein is based on technical data regarding the identified product that Sika believes to be
reliable as of the date hereof. Prior to each use of any Sika product, the user must always read and follow the
warnings and instructions on the product's current Technical Data Sheet, product label and Material Safety Data
Sheet for each Sika product, which are available at web site and/or telephone number listed in Section 1 of this
MSDS.
SIKA MAKES NO WARRANTIES EXPRESS OR IMPLIED AND ASSUMES NO LIABILITY ARISING FROM THIS
INFORMATION OR ITS USE. SIKA SHALL NOT BE LIABLE UNDER ANY LEGAL THEORY FOR SPECIAL OR
CONSEQUENTIAL DAMAGES AND SHALL NOT BE RESPONSIBLE FOR THE USE OF THIS PRODUCT IN A
MANNER TO INFRINGE ON ANY PATENT OR ANY OTHER INTELLECTUAL PROPERTY RIGHTS HELD BY
OTHERS.
All sales of Sika products are subject to its current terms and conditions of sale available at www.sikacorp.com
or 201-933-8800.
Page 6 / 6
|